聚乙烯化合物 的英文怎麼說

中文拼音 [jùyǐxīhuàgěwù]
聚乙烯化合物 英文
polyvinyl
  • 聚 : 動詞（聚集; 聚積） assemble; gather; get together
  • 烯 : 名詞[化學] （有機化合物的一類） alkene; olefince
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 物 : 名詞1 （東西） thing; matter; object 2 （指自己以外的人或與己相對的環境） other people; the outsi...
  • 聚乙烯 : polytene; formale; polyethylene; polythene聚乙烯薄膜 polyethylene film; 聚乙烯撐 polyvinylene; 聚...
  1. Nonionics include polyoxyethylene condensates, sucrose esters and alkyl amine oxides.

    非離子型表面活性劑有聚氧乙烯縮合物糖酯和烷基胺氧化物。
  2. Nonionic surface-active agents include polyoxyethylene condensates, sucrose esters and alkyl amine oxides.

    非離子型表面活性劑有聚氧乙烯縮合物，糖酯和烷基胺氧化物。
  3. Methods of testing plastics - chemical properties - determination of butyl rubber content of low density polyethylene compounds

    塑料的試驗方法.化學性能.低密度聚乙烯化合物中丁基橡膠含量的測定
  4. As to the high - density polyethylene, two strategies were performed : ( 1 ) after being modified by grafting polar groups on its backbone, polyethylene and organic montmorillonite were melt mixed directly, which could obtain the polyethylene / montmorillonite nanocomposites. the effect of groups grafted on the backbone on the efficiency of intercalation was investigated in this paper ; ( 2 ) choosing the grafters obtained in this experiment as the compatilizers, polyethylene / montmorillonite nanocomposites had also been prepared by melt mixing the polyethylene, grafter and organic montmorillonite. the difference of grafters and sequence of mixing on the intercalation result had also been analyzed

    對于高密度聚乙烯，採用以下兩種思路進行： （ 1 ）對聚乙烯首先進行功能化改性，使聚乙烯分子鏈上接枝上不同的極性基團，將改性后的聚乙烯再同有機蒙脫土直接熔融復合，成功的制備了聚乙烯蒙脫土納米復合材料，並考察了接枝到聚乙烯主鏈上基團的不同對最終插層效果的影響； （ 2 ）選用制得的接枝物作為相容劑，將聚乙烯，接枝物，有機蒙脫土三者熔融復合，也可以得到聚乙烯蒙脫土納米復合材料，並對選用不同的接枝物作為相容劑以及復合順序對最終插層效果的影響加以分析。
  5. Plasticized polyvinyl chloride compounds

    增塑聚氯乙烯化合物
  6. Test method for carbon black content in polyethylene compounds by the muffle - furnace technique

    使用隔焰爐技術測定聚乙烯化合物中碳黑含量的方法
  7. Standard test method for determination of carbon black content in polyethylene compounds by the muffle - furnace technique

    用套爐技術測定聚乙烯化合物中炭黑含量的標準試驗方法
  8. Tga. insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 1 : methods specific to polyethylene and polypropylene compounds - resistance to environmental stress cracking - measurement of the melt flow index - carbon black and or mineral filler content measurement in polyethylene by direct combustion - measurement of carbon black content by termogravimetric analysis - assessment of carbon black dispersion in polyethylene using a microscope

    電纜和光纜的絕緣和護套材料.通用試驗方法.第4 - 1部分:聚乙烯和聚丙烯化合物專用方法.抗環境應力致裂.熔化流動指數測量.通過直接燃燒測量聚乙烯中炭黑和或礦物填料含量.通過熱重分析法
  9. Pe. insulating and sheathing materials of electric and optical cables - common test methods - methods specific to polypropylene and polypropylene compounds - resistance to environmental stress cracking - measurement of the melt flow index - carbon black and or mineral filter content measurement in pe by direct combustion - measurement of carbon black content by tga - assessment of carbon black dispersion in polyethylene using a microscope

    電纜和光纜的絕緣和護套材料.通用試驗方法.聚丙烯和聚丙烯化合物專用方法.抗環境應力致裂.熔化流動指數測量.直接燃燒法測量聚乙烯
  10. Catalytic co - pyrolysis of corncob and low density polyethylene mixtures in hydrogen atmosphere

    玉米芯與低密度聚乙烯混合物在氫氣氣氛下的催化熱解研究
  11. In part 3, the in - situ copolymerization of ethylene was investigated by the combinations of the cobalt - based catalyst and the metallocene to prepare short - branched polyethylene. the major oligomers catalyzed by the cobalt - based catalyst 5, 6 and 7 werel - butene, and the minor were 1 - hexene. the comonomer effects were also observed

    在雙亞胺基吡啶鈷配合物與茂金屬復配催化乙烯原位共聚制備短支鏈支化聚乙烯中，合成了3種雙亞胺基吡啶鈷配合物，研究了反應條件對其催化乙烯齊聚活性和所得產物碳數分佈的影響。
  12. Insulating and sheathing materials of electric cables. common test methods. part 3 : methods specific to pvc compounds. section 2 : loss of mass test. thermal stability test

    電纜絕緣和護套材料.通用試驗方法.第3部分:聚氯乙烯化合物專用方法.第2節:質量損耗試驗.熱穩定性試驗
  13. A ; insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 2 : methods specific to polyethylene and polypropylene compounds - tensile strength and elongation at break after conditioning at elevated temperature - wrapping test after conditioning at elevated temperature - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test - test method for copper - catalyzed oxidative degradation

    電纜絕緣護套材料的通用試驗方法.第4部分:聚乙烯與聚丙烯復合物專用方法.第2節:預處理后的斷裂伸長率預處理后的翹曲試驗在空氣中熱老化后的翹曲試驗增加量測量長期穩定性試驗
  14. Insulating and sheathing materials of electric and optical cables - common test methods - methods specific to polyethylene and polypropylene compounds - tensile strength and elongation at break after conditioning at elevated temperature - wrapping test after conditioning at elevated temperature - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test - test method for copper - catalyzed oxidative degradation

    電纜和光纜的絕緣和護套材料.通用試驗方法.聚乙烯和聚丙烯化合物專用方法.高溫處理后抗拉強度和斷裂伸長度.高溫處理后的卷繞試驗.在空氣中熱老化后的卷繞試驗.質量增加的測量.長期穩定性試驗.催化銅氧化降解的試驗方法
  15. Common test methods for insulating and sheathing materials of electric cables - part 4 : methods specific to polyethylene and polypropylene compounds - section 1 : resistance to environmental stress cracking - wrapping test after thermal ageing in air - measurement of melt flow index - carbon black and or mineral filler content measurement in pe

    電纜絕緣和鎧裝材料通用試驗方法.第4部分:聚乙烯和聚丙烯復合物專用方法.第1節:耐環境應力裂化試驗.空氣中熱老化后的纏繞試驗.溶體流動指數的測量. pe中炭黑和或礦物填充料的含量測量
  16. Specification for general - purpose flexible pvc compounds for moulding and extrusion

    模製和擠壓用的一般途的柔性聚氯乙烯化合物規范
  17. Standard specification for rigid poly vinyl chloride and chlorinated poly vinyl chloride compounds for plastic pipe and fittings used in nonpressure applications

    非壓力應用塑料管及配件用硬質聚氯乙烯和聚氯乙烯化合物的標準規范
  18. A. common test methods for insulating and sheathing materials of electric cables - part 4 : methods specific to polyethylene and polypropylene compounds - section 2 : elongation at break after pre - conditioning - wrapping test after pre - conditioning - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test appendix a - test method for copper - catalysed oxidative degradation appendix b

    電纜絕緣和鎧裝材料的通用試驗方法.第4部分:聚乙烯與聚丙烯復合物專用方法.第2節:預處理后的斷裂伸長率.預處理后的纏繞試驗.空氣中熱老化后的纏繞試驗.增加量的測量.長期穩定性試驗
  19. Insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 2 : methods specific to polyethylene and polypropylene compounds - tensile strength and elongation at break after conditioning at elevated temperature - wrapping test after conditioning at elevated temperature - wrapping test after thermal ageing in air - measurement of mass increase - long - term stability test - test method for copper - catalyzed oxidative degradation

    電纜和光纜的絕緣和護套材料.通用試驗方法.第4 - 2部分:聚乙烯和聚丙烯化合物專用方法.高溫處理后抗拉強度和斷裂伸長度.高溫處理后的卷繞試驗.在空氣中熱老化后的卷繞試驗.質量增加的測量.長期穩定性試驗.催化銅氧化降解的試驗方法
  20. Insulating and sheathing materials of electric cables. common test methods. part 3 : methods specific to pvc compounds. section 1 : pressure test at high temperature. tests for resistance to cracking

    電纜絕緣和護套材料.通用試驗方法.第3部分:聚氯乙烯化合物專用方法.第1節:高溫下的壓力試驗.耐斷裂性試驗
分享友人
分享到 Line

分享到臉書