聚烷基碸 的英文怎麼說

中文拼音 [wánfēng]
聚烷基碸 英文
polyalkylsulfone
  • : 動詞(聚集; 聚積) assemble; gather; get together
  • : 名詞[化學] (有機化合物的一類) alkane
  • : 名詞[化學] (硫酰基與烴基結合而成的有機化合物) sulphone
  1. Aminated and hydroxylated polysulfone membranes were prepared by amination and hydroxylation reaction, respectively. then bovine albumin ( bsa ) - fixed membranes were obtained by crossed - linking albumin into porous membrane with 1, 1 ' - carbonyldiimidazole and bisoxirane reagents, respectively. a mathematical model for facilitated transport in asymmetric membranes with fixed site carriers was derived by assuming an instantaneous, microscopic concentraion fluctuation in the membrane

    以氯甲材,通過相轉化法制備出具有底部貫通孔的非對稱膜,通過胺化和羥化反應,分別制得胺化膜和羥膜,再採用羰二咪唑和雙環氧兩種活化試劑對其進行活化,將牛血清白蛋白固載在膜內,獲得固定白蛋白促進傳遞膜。
  2. The dual - bath coagulation method suggested by j. a. va n ' t hof could be used in membranes with high selectivity clearance rate of low - molecular weight substances and moderate water flux theoretically. therefore it may be applied in the field of hemofiltration. to improve and optimize the performance of the pes ultrafiltration membrane applied in the hf, here the flat membranes and hollow fiber ( hf ) membranes are made in certain conditions based on the dual - bath coagulation method where pes is used as the membrane material, dmso as solvent and pvp & peg as additives this paper includes five parts as follow : 1

    為了改善和優化超濾膜(單浴法)在血液過濾實際應用中的性能,本論文以j . a . van ' thof等提出的雙凝固浴法為礎,以( pes )為主要成膜材料,以二甲為溶劑,並添加一定分子量的致孔劑( pvp ,乙烯吡咯酮)以及一定分子量的添加劑( peg ,乙二醇)按照一定配比在一定溫度下製成透明均一的鑄膜液,靜置脫泡后在一定的工藝條件下製成平板膜和中空纖維膜,然後通過測試膜的結構和性能來評估其用於血液過濾中的前景。
  3. An excellent adhesive was prepared from bismaleimide ( bmi ), epoxy resin ( e - 51 and tde - 85 ), 4, 4 ' - diaminodiphenyl sulfone ( dds ) in this thesis. the influence of liquid rubber and polymer ether imide ( pei ) on the properties ( especially high - temperature strength and the peeling strength ) were discussed, their different toughening characteristics and mechanisms were discussed. last, the process and effection of heat - resisted structural adhesive were studied by adhesive experiment of synchronizer in automobile. the results of investigation made clear : the adhesive, has good properties, especially heat - resisted properity

    根據材料分子設計的原理,研究了二苯甲雙馬來酰亞胺( bmi ) 4 , 4 』 ?二胺二苯( dds ) e ? 51 tde ? 85組成的環氧膠粘劑體系,研究該體系在作為高溫結構膠粘劑使用時的粘接性能;然後研究了用無規羧液體丁腈橡膠( ctbn ? x )和醚酰亞胺( pei )分別來增韌該體系的增韌效果;最後通過碳纖維耐磨材料與同步器圓錐環的粘接實驗,研究了耐高溫結構膠粘劑的粘接工藝和使用效果。
分享友人