能量不變散射 的英文怎麼說

中文拼音 [néngliángbùbiànsǎnshè]
能量不變散射 英文
unmodified scattering
  • 能 : 能名詞（姓氏） a surname
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 不 : 名詞[書面語] （剁物所用的木墩） a block of wood
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 能量 : 1 [物理學] energy; amount of energy 2 （能力） capabilities; capacity; 能量不滅 conservation of e...
  • 散射 : [物理學] [電學] scattering; radio scattering; scatter; dispersion
  1. But an alternative simpler method is through the proton exchange ( pe ) process at lower temperature. pe waveguides exhibit larger increment of the index and lower waveguide loss than ti indiffusion waveguides. however, pe waveguide devices have n ' t been fully mature

    質子交換與傳統的鈦擴散工藝相比製作十分簡單，制備的波導具有較高的折射率增量、較小的波導損耗、較強的抗光折變能力，不但能大大降低成本而且還可以提高性能，但是質子交換波導器件目前尚未成熟。
  2. At the initial stage of planar technique, b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region, and the good shield effect of sio2 film to b. but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient, the linear slowly - changed distribution of acceptor b in pn junction can not be formed, which could not cater to the requirement of high - reversal - voltage devics. thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed, while the former can lead to relatively large the base - region deviation and abruptly varied region in si, which caused severe decentralization of current amplification parameter, bad thermal stability and high tr ; the latter needed the relatively difficult pack technique, with poor repeatability, high rejection ratio, and poor diffusion quality and productio n efficiency

    在平面工藝初期，由於b在硅中的固溶度、擴散系數與n型發射區的磷相匹配， sio _ 2對其又有良好的掩蔽作用，早被選為npn硅平面器件的理想基區擴散源，但b在硅中的固溶度大（ 1000時達到5 10 ~ （ 20 ） ，擴散系數小， b在硅中的雜質分佈不易形成pn結中雜質的線性緩變分佈，導致器件不能滿足高反壓的要求，隨之又出現了硼鋁塗層擴散工藝和閉管擴鎵工藝，前者會引起較大的基區偏差，雜質在硅內存在突變區域，導致放大系數分散嚴重，下降時間t _ f值較高，熱穩定性差；後者需要難度較大的真空封管技術，工藝重復性差，報廢率高，在擴散質量、生產效率諸方面均不能令人滿意。
  3. A quantitative analysis on the surface of the plate composite membranes with various polymerization tune was made on the basis of the feature absorption to ir by means of attenuated total reflection - fourier transform infrared spectroscopy. the results showed that polyamide functional layer grew thick with the polymerization time going on. this indicates that the polyamide functional layer formed on the interface cannot separate the w / o phases to stop the reaction

    利用衰減全反射-傅立葉變換紅外（ ftir - atr ）對不同聚合時間的平板復合膜表面進行了特徵吸收定量分析，研究發現，聚酰胺功能層隨聚合時間不斷增厚，這說明已形成的聚酰胺功能層不能屏障兩相而終止反應，相反由於哌嗪單體的分子量遠低於納濾截留分子量的范圍，很易擴散穿過功能層達到兩相界面，繼續與有機相單體酰氯反應。
  4. The experimental results indicate that when the air flow rate is determined, the key problem for energy saving is how to keep the indoor thermal comfort at a suitable level and reduce the difference between the internal and external temperature of the room. a formula is gained for calculating the critical values of air exchange rate. when ventilating rate is greater than the value, radiating heating is the better way for energy saving, or else, convection method in heating is more suitable

    實測還指出，當通風量一定時，如何保證人體熱舒適度不變而減少室內外氣溫差將成為大通風量房間節約採暖能耗的關鍵，本文結合圍護結構傳熱機理，在對三種方式的能耗狀況進行理論分析的基礎上，提出了換氣次數的節能臨界值，若換氣次數高於此值，則輻射供暖是較好的選擇，否則，散熱器供暖是較好的方法。
  5. The change of energy in wall rock is tracked in the whole process and the amount of energy transferred to linings is also evaluated. 5 ) based on the principal of energy invariance and the energy properties of sfrc, a practical design equation that related the thickness of projecting sfrc to the energy related properties of tunnel is given in the end. this equation is then used to design a single - track railway tunnel in iii grade rock condition

    並進一步推導了不同形式的構件間的能量耗散關系，為將標準試驗的能量統計結果運用於實際結構中打下了基礎； 4 ）利用有限元軟體對隧道開挖過程進行了三維模擬，得到了隧道圍巖在開挖掘進過程中的能量轉化趨勢和規律，得到了鋼纖維噴射混凝土襯砌在支護過程中的能量變化； 5 ）利用能量守恆原理和已經推導出的構件能量耗散關系，建立了鋼纖維噴射混凝土襯砌厚度與圍巖開挖能量變化間的關系，並運用此方法對級圍巖條件中的鐵路單線隧道的鋼纖維噴射混凝土襯砌進行了設計計算；
  6. The character of surface radiation and energy expended over soil temperature variation is that the temperature variation at surface, 5cm depth and 10cm depth are approximately sine curve on clear and cloudy day while this way the temperature variation at 20cm depth shows small extent anti - phase variation and the temperature under 50cm is no diurnal. in contrast, the temperature at 5m, 10cm and 20cm shows linear decrease and the soil - surface temperature is concaved on rainy day

    地表輻射和能量耗散反映在土壤溫度變化上的特徵是晴天和陰天地表、 5cm 、 10cm的溫度變化表現為準正玄曲線， 20cm深處的溫度變化呈現出幅度很小的反位向變化， 50cm以下地溫已不存在日變化特徵；雨天5cm 、 10cm和20cm的溫度呈線性遞減，地表溫度表現出由降雨引起的凹陷現象。
  7. Numerical result illustrates that focal length becomes longer when incident wavelength becomes shorter, however the relationship between focal length and incident wavelength is n ' t absolute inverse ratio, it is that the increasing of focal length is faster than the decreasing of incident wavelength. at the same time the numerical result also show that scalar theory ca n ' t be used in the rigorous analysis of the dispersion property of subwavelength diffractive microlens

    然後研究了亞波長衍射微透鏡的色散特性，表明亞波長衍射微透鏡的焦距隨著波長變短而增加，但是波長與焦距之間並非簡單的完全反比例關系，而是隨著波長的減小焦距增加得更快，同時指出標量理論已不能準確分析亞波長衍射微透鏡的色散特性。
分享友人
分享到 Line

分享到臉書