能量閥 的英文怎麼說
中文拼音 [néngliángfá]
能量閥
英文
energy threshold-
It has enough energy to overcome the frictional resistance in valves and registers.
它有足夠的能量克服閥門和記錄器的摩擦阻力。This paper put forward a method, which is used to identify the blow - off point of shock absorber valve system, based on the damping - displacement characteristic test of shock absorber, conversation of energy and equivalent damping coefficient
摘要以減振器示功特性試驗為基礎，以能量守恆為依據，提出一種以等效阻尼系數為對象的識別減振器閥系開閥點的方法。The litter - resistance slowly closing butterfly check valve is developed a newest product based on our butterfly check valve, hydra - matic transmission to be add in the valve with unique design, new stuction and optimum performance, can be used pipeline of water supply and dring with such media : fresh water, sea water, sewage, raw water, ect. the valve should be installed at outlet of the water pump, in stapping the pump, the process of slowly closing after valve plate shuts rapidly. can be guard effectively against the destruction water hummer, so to ensure the safe operation of the pipline
微阻緩閉蝶式止回閥是在我廠生產的蝶式雙瓣止回閥的基礎上利用能量轉換原理增設油壓緩閉裝置的新型模式止回閥，設計獨特，結構新穎，性能優宜，適用於凈水，源水，污水，海水等介質的供、排水管路中，安裝於水泵出口端，停泵時由於油壓阻尼作用法盤先速閉后緩閉，以消除破壞性水錘，保證灌路安全運行。Analysis is made on structure characteristics of the finned - tube, and analysis has been made on the special heat and mass transfer principle of every micro - unit under both dry and wet conditions. appropriate hypothesis is made and based on the energy, mass and momentum equivalent, the evaporator models of dynamic distributed parameters are set up. in addition, the gascooler and internal exchanger models of dynamic and distributed parameters, the throttling valve models and the compressor models are set up, too
本文的內容如下： 1對翅片管蒸發器的結構特點進行分析，選取適當的微元體，對于干、濕工況下每個微元分別進行傳熱傳質分析，通過適當的假設，利用質量守恆方程、能量守恆方程和動量守恆方程建立了蒸發器的分佈參數數學模型；對回熱器劃分微元建立了分佈參數數學模型；對氣體冷卻器建立了分佈參數數學模型；對壓縮機建立了數學模型；建立了節流閥的數學模型，為系統模擬奠定了基礎。As we all know, the back - pressure valve ( also called evaporating pressure regulator ) is often used to regulate the evaporating temperature of every high - temperature refrigeratory in the system containing many different temperatures but single engine of the ship. but it is neglected that the energy of the system is lost and the efficiency of the system becomes low
眾所周知船舶單機多庫（簡稱為高、低溫冷庫）系統中，常用背壓閥（蒸發壓力調節閥）來調節各高溫庫的蒸發溫度，但忽略了系統無形損耗的能量，效率也有所下降。Through analyzing the figure of energy wasting of pump, the quality in pipes is direct proportion of the speed of pump if the speed of pump is reduced. the power of electromotor fell the cube of the speed of pump. so the energy wasting of constant pressure water supply based on variable frequency speed regulating technology is envident less than the traditional mode is used throttle to supply water
分析水泵工況的能耗比較圖，可以看出利用變頻調速實現恆壓供水，當轉速降低時，流量與轉速成正比，功率以轉速的三次方下降，與傳統供水方式中用閥門節流方式相比，在一定程度上可以減少能量損耗，能夠明顯節能。The centrifugal pump for oilfield waterflooding and oil transfer worked with low pump efficiency owing to unstable load and its energy loss is fairly large
油田注水集輸系統離心泵由於載荷經常變化，大多不能在其額定工況點工作，泵效低，且需要用泵出口閥調節流量，產生一定的泵管壓差，造成較大的能量損失。The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced
論文第二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況，在回顧電梯液壓控制系統節能技術的基礎上，介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能控制系統研究」的基本原理，分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式；詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計，重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成控制閥組的設計等內容；最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。According to the time variation and feature extraction difficulty of rotating machinery vibration signals, the rule of choosing wavelet basis function and wavelet denoising soft - thresholding value is proposed after making further research on wavelet transform technique, using for denoising rotating machinery vibration signals the conception of " energy " is proposed, based on the theory that signals energy in all frequency can be affected by faults deeply, to construct feature vectors of rotating machinery vibration signals which can give a convenient disposal way to fault feature extraction and fault intellectual diagnosis
針對旋轉機械振動信號的非平穩性及特徵難以提取的特點，通過對小波變換技術的進一步研究，提出旋轉機械振動信號處理的小波基函數選擇原則及小波包消噪的軟閥值原則。利用小波包變換對旋轉機械振動信號進行消噪處理和特徵提取。並以「能量」為元素，構造旋轉機械振動信號的特徵向量，從而為旋轉機械振動信號的故障特徵提取以及后續的故障智能診斷提供了一種便捷的處理方法。Because the operation in water hydraulic valves is controlled by flow fluid and the pressure drop results from energy loss of flow fluid past valve channel, the flow state of fluid in valves becomes the most important factor for the operational property of valves
由於水壓閥是通過控制流體流動來操作系統的，閥的壓降也來自於流體流經閥道時的能量損失，因此閥內的流體流動狀態就成為決定閥操作性能最為重要的因素。After simulating the model of water hydraulic valves, the velocity distribution, pressure distribution, energy distribution can be obtained and relations between the valve channel and the energy loss, the negative pressure distribution can be analyzed, which offers the theory foundation for designing water hydraulic valves with the high efficiency, low energy loss and low noise
通過對水壓閥模型的cfd穩態和瞬態解析，可以得到水壓閥內流場的速度分佈、壓力分佈及能量分佈，據此定性分析流道結構（速度、壓力、流動的分離與再附壁，旋渦的產生與消失等）與能量損失、負壓分佈等的關系，從而為設計出高效率、低能耗、低噪聲的水壓閥提供理論依據。The numerical simulation validates that the flow tongue of jet is helpful to dissipate the energy of water. it also proves the effect of dissipating energy is better
模擬計算證明了入流水舌有利於能量的消耗，山從川（淪卜驗證了錐形閥消力池消耗能量效果好的特點。On the base of the quasi two - stage compression heat pump system with economizer, considering that it can make use of the pressure energy of liquid with high pressure and minish energy losing of the system, ejector is adopted to replace the throttle in the assistant loop, and design the quasi two - stage compression heat pump system coupled with ejector
本課題正是在帶閃發器準二級壓縮熱泵系統的基礎上，考慮到噴射器元件可以有效利用高壓流體壓力能，減小系統能量損失的優點，將其引入系統以替代輔路節流閥，設計出了準二級壓縮?噴射復合熱泵系統。Two - piece, cast bronze construction. the nibco t585 - 70 - sv ball valve provides positive energy isolation. with the valve in the closed position the down stream air exhausts to the atmosphere
兩件式鑄青銅結構.此球閥具有很好的能量隔離性能.如果這種閥門處于關閉位置，則下游氣體將排放到大氣中Based on the high - low voltage electric driving unit, a new electric driving unit is built, which not only has the advantages of the high - low voltage electric driving unit but also has the advantage of obtaining high limiting current and low maintaining current easily. using self - excitation chopper circuit, the electric driving unit is good efficient, and the heat creating from the solenoid is small
在高低壓驅動電路的基礎上又設計出一種高低壓自激斬波恆流驅動電路，該驅動電路除了具有高低壓驅動電路的功能外，還具有高壓限流和低壓維持電流獲取方便、能量利用更為合理、閥發熱更少等特點。Once thought purely benign, the wisps contain within them a part of the primal energy used to destroy the terrible eredar warlord, archimonde
盡管小精靈通常被認為是溫和的，但在他們身上蘊含著巨大能量足以摧毀強大的邪惡軍閥阿克蒙德。In the light of significant energy losing during the hydraulic excavator working, a dynamic system was made up from the diesel engine, the variable pump, the control valve and the load to cut down the losing energy from a systematic approach based on the control characteristics of the system elements
摘要針對液壓挖掘機在工作過程中存在的大量能量損失，根據泵的控制特性曲線，將發動機、變量泵、控制閥及負載作為一個動態系統來研究其節能問題。Gas higher speed, the greater the energy losses ; spring - loaded edge too large, the loss is great resistance, the size of the air valve movement design guidelines to determine the reasonableness of the law
氣速越高，能量損失越大；彈簧力過大，阻力損失也大，其大小按氣閥運動規律的合理性準則設計確定。In order to solve the problems that large energy consumption, temperature variation, high, cost trouble maintenance in current electro - hydraulic servo control system for material testing machine, a new design scheme that electro - hydraulic proportional control system for material testing machine based on extension control strategy is proposed. the design scheme is successful by means of designing new main frame system, hydraulic cylinder system, digital electro - hydraulic micro - fluid proportional valve and electrical control system, and its results lay a foundation for material testing machine industries in our country
針對國內外材料試驗機主要採用電液伺服控制系統，存在能耗大、溫升、成本高、維護困難等問題，本課題提出了基於可拓控制策略的材料試驗機電比例負載適應控制系統這一新型研究方案，通過開發新型試驗機主機系統、液壓缸系統、數字式微小流量電液比例流量閥及電控系統，實現了材料試驗機電液比例負載適應控制，為我國材料試驗機自動控制系統的產業化打下了基礎。In order to study the operation characteristics of hpacdhws, distributed parameter simulation models of the fin heat exchanger and the plate heat exchanger are built up. the compressor model is founded in map - based method, and the thermodynamics expansion value model is built up in force balance method. the dynamic system model is the efficient connection of all component models by laws of equalization of mass, momentum and energy
為了研究hpacdhws的運行特性，本文利用分佈參數法分別建立了翅片管換熱器和板式換熱器的動態數學模型，採用圖形法和力平衡法分別建立了壓縮機和熱力膨脹閥的集總參數計算數學模型，並基於質量、動量和能量守恆定律等約束條件，建立了hpacdhws的動態模擬模型。分享友人