脫除表面層 的英文怎麼說

中文拼音 [tuōchúbiǎomiàncéng]
脫除表面層 英文
desurfacing
  • 脫 : Ⅰ動詞1 （脫落） cast; shed; drop; fall off 2 （取下; 除去） take off; strip; cast off 3 （脫離） ...
  • 除 : Ⅰ動詞1 （去掉） get rid of; eliminate; remove 2 [數學] （用一個數把另一個數分成若干等份） divide:...
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
  1. Potassium acetate adsorbed on the surface of kaolinite particle can be eluted by absolute ethyl alcohol, while that intercalated between the inner layer of kaolinite may not be affected

    用無水乙醇作洗滌液可以將吸附在高嶺土顆粒表面的乙酸鉀洗脫除去，而已經插入高嶺土層間的乙酸鉀則不受影響。
  2. It can be concluded that the performance differences between the plate membrane and the hollow fiber membrane can be attribute to difference of the stresses in the membranes when they were under pressure and the difference of the strain caused in the membrane, besides the possible reason that the surface curvature difference between a plate substrate and a hollow fiber one may cause structure difference in the dense functional layer when coating. the stresses in a hollow fiber composite membrane under an outside pressure are quite different from that in a plate one in that they exert on the hollow fiber in both the radial and circular directions, and the compress strain of the hollow fiber is thus much more complex, which may cause the top layer crinkle and a decreased salt rejection

    分析認為造成平板復合膜（ ）和中空纖維復合膜（ ）性能差異的主要原因，除了平板基膜與中空纖維基膜因表面曲率不同可能引起在塗覆時形成的緻密功能層結構上的差異之外，由於中空纖維膜受外壓時，膜內部承受的應力形式與平板膜不同，會同時在徑向（膜厚度方向）和環向（膜面內方向）兩個方向產生壓應力，因此，所發生的形變也較為復雜，可能造成表面復合層的起皺或脫落，引起脫鹽率下降。
分享友人
分享到 Line

分享到臉書