膜層 的英文怎麼說

中文拼音 [mócéng]
膜層 英文
rete膜層溫度 film temperature; 膜層阻力 film resistance
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  1. Cases report of a new procedure preventing stoma site fistula by using parietal pleura to replace esophageal adventitia layer

    用胸膜壁層代替食管外膜層預防吻合口瘺315例報告315
  2. The slime layer consists of one aerobic and one anaerobic sublayer.

    粘膜層由好氣分層和厭氣分層所組成。
  3. The activity change of blood platelets saved with albuginea over night

    白膜層過夜貯存制備的濃縮血小板保存期間的活化情況
  4. Bismuth ruthenate and silver were selected as conductor phases and the mixture of calcium oxide - alumina - silicon dioxide ( cao - al _ 2o _ 3 - sio _ 2 ) glass and lead oxide - boron oxide - silicon dioxide ( pbo - b _ 2o _ 3 - sio _ 2 ) glass was selected as inorganic binder phases. it was found that, with the increasing of volume fraction of silver and conductor phase, sheet resistivities descend and there are critical thresholds

    實驗發現，隨著功能相百分含量的增加，電阻膜層的方阻值逐漸減小，存在兩個臨界閾值，電阻溫度系數偏向正值;功能相中銀百分含量增加，膜層的方阻值逐漸減小，有一個臨界閾值，電阻溫度系數偏向正值。
  5. The obtained polysilane - polyacrylate gradient films showed no macro - interface with the silicone content reducing gradually from the top surface to the bottom one. dma thermograms indicated that polysilane - polyacrylate gradient films contained two glass temperatures with their bands drifting from and their range extending much from each component. the good properties of waterproof, calorifics, and ultraviolet - absorption were also determined by dsc, uv and water contact angle measurements

    結果表明：有機硅聚合物-聚丙烯酸酯梯度膜有一個較寬的玻璃化轉變溫區，玻璃化轉變范圍相對組分材料的玻璃化轉變范圍發生了擴展：有機硅聚合物-聚甲基丙烯酸酯梯度膜具有較好的熱學性能；硅含量的提高有利於改善膜層的憎水性能和紫外吸收性能。
  6. In order to solve the above - mentioned problems, the present invention provides a method for plating a polymer material with a metal film, which can form the film on the surface of polymer materials, which are difficult to plate by the prior wet plating method, at a relatively low cost in comparison to the dry plating method and exhibits a uniform thickness and a good adhesion of the metal film and further, shows a good reproducibility

    為了解決上述問題，本發明提供了一種給聚合物材料上鍍金屬膜的方法，用該方法可以在聚合物材料表面形成膜層，這是原來的工藝難于做到的，而且比干鍍成本低，鍍層厚度均勻，金屬膜的粘附性好，最後，還顯示出好的重現性。
  7. A sample is put on the table which is processed into a inclined plane on the filmed plane, and two interfaces of a film are focalized, then the thickness is read out that is a difference between the heights of two interfaces of a film

    將實驗樣品的覆膜面打磨成斜面后平放在金相顯微鏡樣品臺上，分別對膜層的兩個界面對焦，從對焦旋鈕上讀出兩焦面的高度差即為膜層的厚度。
  8. Get 4 right anterolateral femoral flaps and 4 left scapular flaps which were dyed obviously after 3 days, dehydrate by graded ethanol, vitrification and paraffin embeded, horizontally and vertically sliced continuously, thickness is 15, 20 and loojtim respectively, he dyed, observed under microscope. results : ( 1 ) direct cutaneous artery or musculo - cutaneous artery, in the procedure of common integument tissue being shallowed up step by step, continuously sending out branches to deep fascia layer, superficial fascia layer, hypodermis layer, hypopapilla layer and papilla layer to form the five - grade cutaneous microcirculation " blood vessel tree " of the skin blood vessel network that can be identified

    結果門）亙接皮動脈或肌皮動脈，在體被組織逐步淺出的整個行程中，不斷發出分支並分別在深筋膜層、皮下組織（淺筋膜）層、真皮下層、乳頭下層和乳頭層內形成五級具有鑒別特徵的皮膚微循環血管網（血管樹） 。 （ 2 ）體被組織靜脈血管網由淺入深分為五層：皮膚乳頭層。乳頭下層、真皮下層、皮下組織層和深筋膜層。
  9. ( 2 ) common integument tissue venous vessel network can be divided into five layers from superficial layer to deep layer : cutaneous papillary layer, hypopapillary layer, hypodermis layer, subdermal layer and deep fascia layer. the artery branch and arteriole that shallowed up from hypopapillar layer get to papillar layer to form vessel network, circuitous and twisted, reflux and anastomose to become postcapillary micro veins and endothelial venule, then anastomose each other and accompanied with artery to enter hypo

    小靜脈伴行動脈進入皮下組織層、深筋膜層，並與皮下組織層和深筋膜層動脈分支的伴行靜脈匯合，分別形成皮下組織層、深筋膜層靜脈網，進而匯入軸心動脈的伴行靜脈。而真皮下血管網中與動脈不伴行的微靜脈匯合成為小靜脈，並逐漸聚集增粗，匯合加入淺非伴行靜脈屬支或即為屬支的起點。
  10. In early ic fabrication practice, etch bias was usually dealt with by introducing an appropriate amount of compensation in the masking layer.

    在早期的集成電路製作實踐中，刻蝕偏差通常是通過在掩膜層上引入一個適量的修正來處理的。
  11. The muscle and fascial layers are incised lateral to a rectus incision.

    在腹直肌切口外側切開肌肉和筋膜層。
  12. Secondly, through analyzing the failure instance of electrical connectors in using and testing environment, educed contact fault was a main mode of failure of electrical connectors. on natural working conditions, the main reasons which caused fault of electrical connector were contact stress decreasing, microseism wearing and tearing and surface film growing

    而在正常的工作條件下，造成電連接器電接觸失效，即決定電連接器工作壽命的主要原因是接觸壓力減小、微動磨損和表面膜層的生長，而影響接觸壓力、微動磨損和表面膜層變化的主要因素是環境振動和溫度。
  13. This paper mainly discusses the designing and testing method to the dds acousto - optic mode locking. it also makes some further analysis on the critical technology - - - - - - the transducer acoustical membrane matching and transducer thinning, which can directly affect the performance of acousto - optic elements. it then analyses the heat effect of acousto - optic elements and the technology of transducer thinning by developing ion - beam sputtering of high frequency acousto - optic elements

    本文重點討論了dds聲光鎖模器的設計及測試方法，討論和分析了影響聲光器件性能的關鍵工藝換能器聲學膜層匹配和換能器減薄工藝，對聲光器件的熱效應進行了測試分析，對離子刻蝕法聲光換能器減薄新工藝作了一定的探討。
  14. The coating thickness is of the order of 100 nm nanometre

    膜層的厚度約為100奈米。
  15. The great amount of stabilizing agent led to the non - uniform of the plating layer. the addition of the high polymer could decrease the size of silver particles and help to increase the dispersibility of powders

    採用高銅鍍液，鍍覆表面金屬顆粒降至2 3urn ，形成一層緻密連續的銅銀共沉積的金屬膜層。
  16. Electrochemical impedance spectra of prussian blue film modified platinum electrode

    基於普魯士藍和甲苯胺藍膜層層修飾的葡萄糖生物傳感器
  17. When increasing the oxygen pressure, the rheed pattern changes to streaky one again. this rheed pattern transformation induced by the oxygen pressure is reversible. ex situ xps results indicate that the element ni of lno film deposited in the relatively low oxygen pressure with thickness below the critical value exists in the form as ni2 +, while as ni3 + in the relatively high oxygen pressure

    隨著膜厚增加而超過約30nm的臨界厚度時，越來越多的晶格氧會移動到了薄膜表面，此時所提供的氧將使得后續生長的lno膜層重新形成鈣鈦礦結構，並以層狀方式外延生長。
  18. Experiment re - sults indicate the microcavity of l - - d pc structure can get a high reflection co - efficient and a good stabi1ity and substantiality of the fiim layers in air

    實驗結果表明，光子晶體結構的微腔可以達到很高的反射率，且膜層的牢固性以及在空氣中的穩定性也較好。
  19. 3. an elementary attempt has been made to enhance the signa - to - noise ratio of pqc sensors using cholestyramine particles embedded in the sensing film. bor more, an all - purpose sulpha - drugs pqc sensor was developed whch can be used for screening practice

    對如何提高基於離子對締合物的壓電藥物傳感器的信噪比進行了初步探索，發現在傳感膜層嵌入考來烯胺樹脂顆粒對磺胺藥物壓電傳感器的信號有明顯的擴增作用。
  20. The company main product includes : the vacuum electron gun, opticsmembrane level thickness measuring instrument, the electron gunscanning control meter, the high efficiency crystal thyratron pressureregulator, the precise optics with the power source, the electricitycontrol the cabinet, the data acquisition module and so on

    公司主要產品有：真空電子槍、光學膜層厚度測量儀、電子槍掃描控制儀、大功率晶閘管調壓器、精密光學用電源、電氣控制櫃、數據採集模塊等。
分享友人
分享到 Line

分享到臉書