膠粘度 的英文怎麼說

中文拼音 [jiāoniándù]
膠粘度 英文
adhesion capacity
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  1. The juncture of between two boards of the flume box was agglomerated ( ) with stickiness first. then the top and the bottom board of the box were tighten with bolts

    水槽式加熱器箱體兩板間的連接首先用粘補膠粘接，然後在箱體的四周用螺絲連接，確保機械強度和密封性能。
  2. The small packing adhesive, which is a modified product from ethylene - vinyl acetate copolymerized emulsion, has high solid content, low viscosity, and good adhesive strength. the product is up to the standard of foodstuff hygiene and suitable for the small package of the cigarette packing production line with stable adhesive application and the making speed up to 400 packs per minute. type i is for white card paper, while type ii is for golden card paper

    小盒包裝膠系乙烯-醋酸乙烯共聚乳液改性產品，具有高固含低粘度粘接力強等特點，產品符合食品衛生標準，適用於卷煙卷包生產線的小盒包裝，施膠穩定，無開包等不良現象，車速可達400包分，型為白卡紙專用膠，型為金卡紙專用膠，具有極佳的初粘力和持粘力，對非極性材料的光滑表面有獨特的優良粘接性能，對各種難粘材料均可適用。
  3. It can implement emulsion breaking, dehydration and remove water, soap, acid, color and metal particulate in emulsive turbine oil and low - viscosity lubricating oil as well as filtration of hydraulic transmission oil and antiwear hydraulic oil in machinery, turbine oil of electric equipment

    能對嚴重進水混濁乳化的透平油低粘度潤滑油進行破乳脫水，除去油中水分皂類膠質酸質色素及金屬微粒等機械雜質，使乳化狀油液變清澈。
  4. In this paper, the viscosity changes of hydroxy ethyl cellulose sol caused by a kind of mixed salt were studied, which provided valuable basic data and an adapting equation for its practical application

    摘要研究了一種混合鹽的存在使羥乙基纖維素溶膠粘度變化的情況，為其實際應用提供了有價值的基礎數據和擬合公式。
  5. Coarse - mesh guar gums, will typically - but not always - develop viscosity more slowly

    粗目數的瓜爾膠粉通常-但不總是-形成粘度的過程較慢。
  6. 4. hard maple : origin of north america and europe, wooden features : density 0. 49 - 0. 55g cm3, it is valued for its strength, beauty and resistance to wear. texture is fine with a uniform grain and a fairly clear white color. maple is best when left natural with a clear seal coating

    木材特徵：氣干密度0 . 49 - 0 . 55g cm3材質軟， ，強度，韌性適中結構均勻，紋理直，木材堅固，耐沖擊力切割，膠粘和磨光性能良好，耐腐耐磨性良好。
  7. Owing to penetration, absorption, and internal lubrication, the homogenizing - dispersing agent filled in rubber compound reduced the difference of viscosity, polarity, surface tension in dissimilar rubbers, and accelerated interfusion, dispersing, homogeneous mixing

    由於均勻分散劑的滲透、吸附及內潤滑作用，減小了不同橡膠間粘度、極性和表面張力的差別，達到了快速融合、分散、摻混均勻的效果。
  8. Adhesives - wood adhesives for non - structural applications - determination of tensile shear strength of lap joints

    膠粘劑.非結構用木材粘結劑.搭接接頭拉力剪切強度的測量
  9. Jointing products - mastics - test cone penetrability

    接縫產品.膠粘劑.試驗圓錐貫入度
  10. Determination of mooney viscosity of rubber ; test apparatus

    橡膠的莫氏粘度測定.第2部分:試驗儀器
  11. Solvent can be added to plastisol coating to lower the viscosity, producing organosol coatings

    可加入溶劑到塑性溶膠塗料中以降低它的粘度，形成有機溶膠塗料。
  12. The optimal preparing conditions were found to be as follows : the initial viscosity of cellulose xanthate ranging from 5, 000 to 8, 000 cst, the mixture of pump oil and chlorobenzene with a 6 : 1 mass ratio as disperse phase, the mass ratio of disperse phase to water phase at 6 : 1, the mixing speed at 350 ~ 400 rpm

    詳細研究了一些影響復合微球形成的因素，得到較優的工藝條件為：纖維素黃原酸酯粘膠粘度為5000 8000cst ，分散相為6 : 1 （ w w ）泵油和氯苯混合物，攪拌速度為350 400rpm 。
  13. Soft soldering fluxes - test methods - assessment of tackiness of flux residues

    軟釬焊劑.試驗方法.第14部分:釬焊劑殘留物膠粘度測定
  14. For sbs and sebs, especially sebs, the melt viscosity and the shear rate are inter - rated

    Sbs與sebs材料尤其是sebs材料的熔膠粘度melt viscosity與剪切率shear rate繫系相關
  15. Soft soldering fluxes ; test methods ; part 14 : assessment of tackiness of flux residues iso 9455 - 14 : 1991 ; german version en 29455 - 14 : 1993

    軟釬焊劑.試驗方法.第14部分:釬焊劑殘留物膠粘度測定
  16. If the manufacturing temperature exceeds 200c, the melt viscosity will increase sbs molecules may result in arching which reduce the productivity

    若加工溫度超過200c ，熔膠粘度會上升sbs分子可能有架橋現象，因而降低生產率
  17. If the materials are degraded in the event of high temperature and high shearing rate, the melt viscosity will decrease due to the breaking up of the molecular bonds

    如果材料因高溫或高剪切率加工而降解，熔膠粘度會因分子鏈斷裂而降低
  18. But, the melt viscosity of the sbs and sebs elastomers is highly affected by the shear rate inside the barrel but it is not sensitive to the temperature inside the barrel

    但sbs與sebs彈體的熔膠粘度melt viscosity非常容易被炮筒內剪切率shear rate影響，反而對炮筒內的溫度不太敏感
  19. The effects of all kinds of factors and additives on the viscosity of the pvc paste and blends were sysmetically examined. viscosities, flame - retardant properties, surface resistances, mechanical performances of all the improved recipes were investigated. the cost of the improved recipes was largely fallen down and the compositive properties were better than those of the initial recipes

    對各種因素和添加劑對pvc糊和覆蓋膠粘度的影響，以及所有改進配方的粘度、阻燃性能、表面電阻和力學性能進行了詳細的分析，最終得到了即能夠大幅度降低成本又能夠提高產品綜合性能的配方。
  20. This machine is used to test the quality of corrugated carton paper

    用途：用於橡膠粘度的木尼測試
分享友人
分享到 Line

分享到臉書