膠體懸液 的英文怎麼說
中文拼音 [jiāotǐxuányè]
膠體懸液
英文
suspension colloid-
One case is that of tiny dust particles or colloidal particles suspended in a fluid.
一種就是微小的灰塵粒子或懸浮在液體中的膠粒。A sol that consists of solid particles suspended in a liquid is a colloidal suspension.
由固體微粒懸浮在液體中所組成的溶膠叫膠態懸浮體。The porous ceramics is composed of lots of bridge arch - shaped microspores that connected and well - distributed inside the material. when the fluid passes through these pores, the suspended matters, colloid particles and big molecular organic substances are withheld or absorbed to the inner surface of the pore, and result in filtration, purification adn even - dispersion, high strength, good resistance to abrasion, high temperature and corrosion, no pollution, long workinglife, and easy to regenerate, the porous ceramics are available for filtration and fluidization of variou gas and liquid
微孔陶瓷過濾介質由許多大小分佈均勻，相互連通的橋拱狀開口氣孔組成.當流體從這些氣孔中通過時，流體中的懸浮物質，膠體顆粒，大分子有機物等被截留，吸附在微孔道內，從而達到了凈化和過濾均勻化的效果.微孔陶瓷強度高，耐磨損，耐高溫，耐腐蝕，無污染，氣孔分佈均勻，使用壽命長且再生簡便，特別適用於各種氣，液過濾和流態化過程( 3 ) left lower limb was used to prepare artery ( red ) and vein ( blue ) color cast specimens using perchloroethylene. ( 4 ) deep freezed right lower limb sample, injecting red gelatin into femoral artery, forward and backward injecting blue latex with barium sulfate into femoral vein and great saphenous vein, cuting flap after dealing with formalin and get x - ray photos
（ 3 ）採用1例新鮮屍體左下肢標本制備過氯乙烯動（紅） 、靜（藍）脈分色鑄型標本。 （ 4 ）右下肢冷藏標本，于股動脈灌注紅色乳膠，再於股靜脈及大隱靜脈順、逆行灌注含硫酸鋇混懸液之藍色乳膠，福爾馬林防腐，然後切取皮瓣，攝取x線片。The results showed that the rubber latex particles separated the clay into nanometer units, accompanied with the competition between separation of rubber latex particles and re - aggregation of single silicate layers upon addition of flocculant during the process of co - coagulating, while the intercalation of rubber molecules into clay galleries did not occur
結果表明，在加入絮凝劑使橡膠乳液黏土水懸浮液共凝聚的過程中，由於存在膠乳粒子對黏土片層的隔離作用與在混合液中分散的黏土單片層的重新聚集作用的競爭，因此，在絮凝物中，橡膠大分子將黏土片層隔離成納米分散單元（包括單片層和多片層的聚集體） ，在多片層的黏土聚集體層間沒有橡膠大分子插入。We can provide customers with automatic / half - automatic dustless coating production line for plastic parts, whole - range liquid / powder electrostatic coating production line, automatic coating machine for small pieces, whole - range stand coating equipment, electrostatic eliminating equipment, dust removing equipment and various uv light curing equipment ; and we provide supporting logistic equipment including whole - range horizontal conveyor, bevel conveyor, overhead suspension conveyor, vertical conveyor and transfer machine ; and we also provide various production line equipment for assembly line, screen printing line, aging line, inspection line and packing line
可為客戶提供全自動及半自動塑膠件無塵塗裝生產線、全系列液、粉體靜電塗裝生產線、小件全自動塗裝機、全系列臺式塗裝設備、除靜電除塵設備及各類uv光固化設備；配套提供全系列平面輸送機、斜面輸送機、懸掛式吊空輸送線、垂直輸送機和移載機等物流設備；提供各類組裝生產線、絲印生產線、老化線、檢測線和包裝線等流水生產線設備。Lukang ? gel of proper density in water based system can adhesion and suspension powder materiel ( such as pigment, medicine and talcum powder etc. ), stabilize suspension liquid, prevent suspended material sediment and harden, make suspension liquid even, bright - colored, convenience, easy spraying, and unaffected by outside force and time
適當濃度的綠康凝膠在水性體系中可粘合、懸浮粉狀物料（如：顏料、藥物、滑石粉等） ，穩定懸浮液，防止已懸浮物質的沉澱積合、硬化，使懸浮液質地均勻，色澤艷麗，使用方便，噴霧更加容易，且不受外力、時間影響。The output signal of pda is affected by the suspended particle concentration, particle size, and the type and dosage of coagulant as well. by analysing the fi curve, it is found that the characteristic parameters of fi curve closely relate to aggregates size and turbidity removal the aggregates size and turbidity removal achieve the maximum when the amplitude of fluctuation is the maximum. the mean diameter and fractal dimension increase with agitation time, and finally reach a steady - state
通過對混凝過程的在線監測和對pda輸出信號fi曲線的數學解析表明： fi曲線綜合反映了懸濁液中膠體顆粒濃度和顆粒粒徑，混凝劑種類和投量很大程度上影響了fi曲線形狀， fi曲線的特徵值與絮凝體平均粒徑和濁度去除率之間具有良好的相關關系，在振幅最大處，濁度去除率達到最高，絮體平均粒徑最大，該條件下對應的投藥量為最佳投藥量。In this paper, a novel method for synthesis of zno colloidal spheres is presented. in addition, we have proposed a tunable pc, in which the pbg can be tuned as desired by controlling parameters such as zno colloidal spheres size and temperature
利用膠體自組裝法制備了zno光子晶體，並通過控制反應溫度、溶液a用量、膠體懸浮液的濃度、前處理溫度、基片潔凈度等因素，可以實現對zno光子晶體的可控生長。分享友人