膠體體系 的英文怎麼說

中文拼音 [jiāotǐtǐxì]
膠體體系 英文
colloid system
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 體 : 體構詞成分。
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  1. A method to calculate quantitatively the adsorption volume or adsorption space of per mass of adsorbent derived from both the adsorbed molecule volume and the maximum adsorbance of a solute in an adsorption isotherm under a given experimential condition is presented firstly for a solid / liquid adsorption system of the solute in a dilute aqueous solution. this method is suitable for not only mono - layer adsorption, but also mani - layer adsorption and micelle adsorpion of surfactant constructed by hydrophile and lipophile groups. therefore, the surface concentration of the adsorbate, cs, deduced from the adsorption volume is possessed of the meaning of true concentration, and the value of the patition coefficient of the adsorbate between solid and liquid phass, p, attained by the cs and the c, solution concentration of the adsorbate, can be accurate. the foregoing a set of calculations are presented for the solid - liquid adsorption systems consisted of the wool fiber and separately dodecyltrimethyl - ammonium bromide ( dtab ) and hexadecyltrimethyl - ammonium bromide ( ctab ) in this paper. this provides a strong basis for adsorption thermodynamic investigation of adsorbate

    對稀溶液中溶質的固/液吸附體系，首次提出了根據吸附分子體積和實驗條件下吸附等溫線中的最大吸附量計算單位質量吸附劑的吸附體積或吸附空間的方法.此法適用於單層吸附，也適用於多層吸附和具有親水親油結構的表面活性劑分子的膠團吸附.由此，吸附質的表面相濃度cs具有真實濃度的含義，相應地，計算得到的溶質的固/液分配系數p就有了準確值.分別計算由溴代十二烷基三甲銨（ dtab ）和溴代十六烷基三甲銨（ ctab ）與羊毛纖維構成的液/固體系分配系數等，為溶質吸附的熱力學研究奠定了基礎
  2. We can see from the photos of the sem that the diameters of the powers of this tree land of materials obtained by the system of trion x - 100 / caprylic alcohol / cyclohexane / water are about 20 nm. by means of uv - vis, atomic absorption spectrometry and so on, nanoparticles of this three kind of anode materials are synthesized

    利用trionx - 100 /正辛醇/環己烷/水反膠束體系制備出三種物質的粉體，掃描電子顯微鏡照片顯示粒子的粒徑在20nm左右，分佈均勻；此外還利用uv - vis 、原子吸收光譜等測試手段，都表明合成出了三種正極材料的納米粒子。
  3. Many methods are used to improve properties and performance of emulsion adhesives, including changing proportion of monomers or initiator system, improving emulsion polymerization, mixing or chemical combination with other polymers

    討論了通過改變單體組成或引發體系、改進聚合工藝、通過共混或化學結合引人其他聚合物的方式改進乳液型膠粘劑性能的方法。
  4. According to the principle of surface and colloid chemistry, the pore structure and characteristics of tight sand gas reservoir are analyzed

    摘要根據表面與膠體化學原理，分析了低滲緻密砂巖氣藏的孔隙結構特徵、物性特徵以及它們之間的關系。
  5. But in the forepassed research, the people all abstracted the colloid in the water as the sphericity and explained it by the known theory of the colloid chemistry. moreover some people modified the result by the grain coefficient in the derivation of theory. but this assume had more difference on the observed phenomena in the experiment, so it was not perfect in theoretical speaking

    關于絮凝的理論基礎在國外研究得比較多，但在過去的研究中，人們大都是將水中的膠體顆粒抽象為球形，用已有的膠體化學理論去加以解釋，並在理論推導中引入顆粒系數加以修正，這與實際實驗所觀察到的現象有較大的差別，從理論上說，是很不完善的。
  6. A foam is a colloidal system in which gas bubbles are dispersed in a liquid or solid.

    泡沫也是一種膠體體系，其中氣泡分散在液體和固體里。
  7. " for his work on disperse systems

    對膠體化學中分散系統的研究
  8. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  9. The intense eluviation and weathering of soil with groundwater and run - off result in the enhancing of capacity of transference of some elements, such as si, al, fe, mn. the chemical reactions of the colloid particles in the soil water make those crannies or holes filled by some epigenetic clay minerals and quartz. then a great deal of white reticulate clay comes into being in the quaternary laterite of the dongting basin

    地下水和地表水強烈的淋溶作用使土壤中硅鋁鐵錳等元素的遷移能力增強，土壤膠體粒子之間的化學反應，使得這些孔隙空間在後期逐漸被次生黏土礦物和石英所充填，最終，在洞庭盆地第四系紅土地層中形成大量的蠕蟲狀和根狀白色網紋。
  10. 3. based on the gel time and dsc curve figure of two kinds of modified phenolic resin and flory and kissinger theory, the rage of cure process parameters for the resin system, moulding pressure and resin content are established

    3 、通過對二種改性酚醛樹脂體系凝膠時間、 dsc曲線圖的分析，引入flory理論、 kissinger理論，確定了樹脂體系的固化工藝參數（固化溫度、固化時間、后處理溫度）范圍；並初步確定了成型壓力和樹脂含量的范圍。
  11. Guar gum can viscosify, stabilize, and emulsify water systems as well as bind moisture to itself

    瓜爾膠可增粘、穩定、乳化水體系並能夠自身結合水分。
  12. Seven stars big dipper multi - purpose colloid mill jm series, the colloid pump the zb series, the mulser r series

    產品描述:七星jm多功能膠體磨系列、膠體泵zb系列、乳化機r系列。
  13. Research on portland cement hydration and mechanical properties of prc low water cement ratio system

    低水膠比體系硅酸鹽水泥水化特性與力學性能研究
  14. Thermodynamic properties of the micellization of cationic gemini surfactants

    表面活性劑膠束體系的熱力學性質
  15. And chloride - resistance property is promoted by increasing dosage of cementttious materials ; there is obvious difference on chloride - solidified performance of different cement variety

    不同的水泥品種對氯離子的固化能力有所差別，膠材體系中c3a越低，抗滲性能較差。
  16. Based on this system the cracking resistence of portland cement paste system was tested. also the effect of fly ash, slag, silica fume and admixtures on the cracking at early ages was studied

    本文對純硅酸鹽水泥膠凝體系的抗裂性能進行了研究，同時試驗考察了粉煤灰、礦渣、硅灰和外加劑對膠凝體系早期抗裂性能的影響。
  17. In this paper, the microstructure changes of polypropylene induced by a complex combination of shearing, compression, stretching and friction actions during single pan - milling or co - milling with iron, uhmwpe and waste tire rubber chips ( wtr ) were studied and the stress induced effects were revealed. the structure and morphological development of iron particulates and wtr during pan - milling and co - milling with polypropylene were also characterized. the properties of pp / fe, pp / wtr and pp / wtr / fe composites prepared through pan - milling techniques were investigated

    本文利用磨盤型力化學反應器對被碾磨材料施加強大的剪切、環向應力、擠壓、拉伸和摩擦作用，研究聚丙烯碾磨和共碾磨粉碎過程微觀形態結構和性能的變化，以及聚合物在碾磨過程中呈現的力化學現象，並將其應用拓展至金屬、橡膠等體系，研究碾磨粉碎在聚丙烯鐵超微粉體的制備、高交聯密度彈性材料廢舊輪胎橡膠（ wtr ）的超微粉碎，以及pp fe ， pp wtr材料的性能與碾磨作用的關系。
  18. It has many advantages, such as the particles size is well distributed, and its diameter can be well controlled, etc. because of this virtue, reverse micelle shows broad prospects in the preparation of ferrite nanoparticles. hi this work, the syntheses of mnfe2o4 nanoparticles, cofe2o4 nanoparticles and znfe2o4 nanoparticles are prepared by the reverse micelle method, these preparations employed reverse micelles formed with anionic surfactant bis - ( 2 - ethylhexyl ) sodium sulosuccinate ( aot ), which is considered the most effective surfactant, and another anionic surfactant bis - ( 2 - ethylhexyl ) sodium hydroxy sulosuccinate ( ahot ), which is a new surfactant, and was synthesized by our own research group. we also synthesized znfe2o4 nanoparticles using the cationic surfactant cetyltrimethylammonium bromide ( ctab )

    本文分別採用通常被認為最佳的陰離子表面活性劑? ?二（ 2 -乙基己基）丁二酸酯磺酸鈉（ aot ） ，和我們課題組自己設計合成的新型陰離子表面活性劑? ?二（ 2 -乙基己基）羥基丁二酸酯磺酸鈉（ ahot ）所構成的反膠束體系為微反應器，成功制備了mnfe _ 2o _ 4納米粒子、 cofe _ 2o _ 4納米粒子和znfe _ 2o _ 4納米粒子；還以陽離子型表面活性劑? ?十六烷基三甲基溴化銨（ ctab ）構成的反膠束體系為微反應器，成功制備了znfe _ 2o _ 4納米粒子；並探討了表面活性劑的種類和結構對反膠束法制備鐵氧體納米粒子反應的影響。
  19. A free radical polymerization mechanism for ultrasonically irradiated emulsion polymerization was proposed. ( 2 ) ultrasonically irradiated encapsulating emulsion polymerization was first used to prepare polymer / inorganic nanoparticles composites

    二、採用超聲輻照包裹乳液聚合法制備了長期穩定的、聚合物包裹無機納米粒子的膠乳體系，處理后得到聚合物/無機納米粒子復合材料。
  20. Non destructive testing. industrial radiographic film. part 1 : classification of film systems for industrial radiography

    無損檢驗.工業用x射線照相膠片.第1部分:工業x射線照相用膠片體系的分類
分享友人
分享到 Line

分享到臉書