鍋爐受熱面 的英文怎麼說

中文拼音 [guōlúshòurèmiàn]
鍋爐受熱面 英文
boiler heating surface
  • 鍋 : 名詞1. （炊事用具） pan; pot 2. （裝液體加熱用的器具） boiler; cauldron3. （某些器物上像鍋的部分） bowl （of a pipe, etc. ）
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 鍋爐 : boiler; furnace
  1. This thesis establishes the main factor of heating surface slagging of no. 1 boiler, that it is due to irrational layout of furnace heating surface, improper angle of burner which lead to flames attaching to furnace walls. such deduction is built on the basis of necessity of analyzing the heating surface slagging, the type of coal, the design of the furnace and burner, the operational condition and other factors effecting slagging of boiler. the research is mingled with practical operations of no. 1 boiler in inner mongolia fengtai electric power generation co, ltd

    本論文從分析燃煤鍋爐結渣問題必要性出發，從煤種、爐膛及燃燒器設計、運行工況等因素對鍋爐結渣的影響著手，結合內蒙古豐泰發電有限公司~ # 1鍋爐實際運行中存在的問題，確定了~ # 1爐受熱而結渣的主要原因是爐膛受熱面布置不合理，燃燒器角度不合適導致火焰貼壁所致。
  2. Subsequently, we introduce some monitoring model and implement currently used, then we release our model, which suit the 1 # boiler of beilun power plant, on the basis of the models before. our model is subdivided into three categories, each category suit the heat exchanger of deferent type : the furnace, convective surface and trisector air preheater, all these categories use clean factor as the indication of the soot desposition level

    首先介紹了鍋爐灰污染危害的現狀，對比研究了國內外的灰污染監測手段和監測模型，並針對北侖1 #鍋爐，建立了鍋爐各受熱麵灰污染監測模型，這些監測模型分為爐膛、對流受熱面、以及三分倉空預器三種類型，採用清潔因子作為受熱麵灰污染狀況的指標。
  3. The article takes a 600mw natural cycle drum boiler ( soot blow using steam ) as investigating object, establishes soot accumulation loss and soot blowing energy loss models for its water cooling wall, superheater, economizer and air preheater respectively, set up instructions for soot blower operating. simulating calculation results are compared with site data to verify usefulness of key models. the article introduced the operation optimizing design of soot blowers of yanzhou no2 power plant based on theoretical research

    本文以600mw汽包自然循環鍋爐（蒸汽吹灰）為具體分析對象，分別建立其水冷壁、過熱器、省煤器、空預器的積灰損失和各受熱面吹灰能量損失的模型，建立相應的吹灰器運行規則指導，對設計中的關鍵模型問題，通過模擬計算及與現場數據作比較的方法，驗證其可用程度。
  4. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等；改進了水冷壁布置使換熱效果更好，減少輻射換熱損失；改進對流段結構，更充分的利用爐膛出口煙氣余熱，提高熱效率；並且進行了煙氣阻力計算、熱效率計算和能量平衡測試，對改進后的稠油燃料和改進前進行了對比，燃燒狀況和熱效率有明顯改善。
  5. Oxidation resistance and wear resistance coatings for boiler tube

    鍋爐受熱面抗氧化磨蝕塗層的研究
  6. All sorts of methods for preventing and reparing the damage of panel pipe of heating surface which is caused by boiler sootblower

    鍋爐吹灰器吹傷受熱面管排的綜合治理
  7. Preliminary study on tube clip weld rupture of boiler heating surface

    鍋爐受熱面管定位連接件焊縫開裂原因初探
  8. To reduce the loss due to the fouling of the heat exchanger surface and improve the economic efficiency of the boiler, we must judge the soot deposition level exactly and reliably, then we can schedule the soot blowers to cure the loss caused by soot deposition

    為了減少受熱面污染造成的損失，提高鍋爐經濟性，勢必要求準確可靠地判斷鍋爐受熱面的灰污染狀況，通過對吹灰器等加以調度來減少由於受熱麵灰污染帶來的損失。
  9. The ash fouling online monitoring models are built for furnace, convection heating surface and tri - sectional regenerative air preheater based on the analysis and summarization the researches on the ash fouling monitoring technic and models of boiler. clean factor ( cf ) is chosen to express the effect on heat transfer of ash fouling and is calculated by heat transfer steady - state model

    在分析研究總結現有的鍋爐各類受熱面的各種灰污監測技術和模型的基礎上，建立了鍋爐爐膛、對流受熱面和三分倉空預器的灰污在線監測模型，以清潔因子表徵受熱麵灰污對鍋爐受熱面傳熱的影響。
  10. Application of supersonic arc spraying coating resistant to abrasion on power station boiler heating surface

    超音速電弧噴塗耐磨塗層在電站鍋爐受熱面上的應用
  11. Influencing factors of boiler heating surface fouling monitoring

    鍋爐受熱面污染監測影響原因的分析
  12. Explicit analytical solution of boiler heating surface dynamic process

    鍋爐受熱面動態過程的一套顯式解析特解
  13. Treatment for the boiler heating surface leakage in hubei hanchuan power plant

    湖北漢川電廠鍋爐受熱面泄漏整治
  14. Experimental research on slagging characteristic of heating surface of 330 mw boiler

    機組鍋爐受熱面污染特性的試驗研究
  15. Reliability design and life assessment of large capacity station boiler tubes

    大容量電站鍋爐受熱面管子的可靠性設計與壽命評定
  16. Boiler heating surface

    鍋爐受熱面
  17. Heating - side ' s abrasion analysis and protection of the circulating fluidized bed boiler

    循環流化床鍋爐受熱面的磨損分析及預防措施
  18. Welding quality supervision management of in - service boilers in heating surface modification project

    在役鍋爐受熱面管改造工程中的焊接質量監督管理
  19. The original design was intermediate vapor 42t / h, but the actual output is 30 - 35t / h, at the same time the temperature and pressure of the vapor are unstable, it affects the economic efficiency, the reason were the collecting dust on the heat area and serious corrision, they led to the decrease of the boiler load, and need stop to washing the dust, the article deals with the reform of the exhaust gas boiler, at the basic of the design condition, after thermo calculation, flute gas, resistence calculationand strenth calculation, the structure of the heat surface had been rearranged, then the proof calculation was done

    原設計產中壓蒸汽42噸時，但投運后只產30 - 35噸時，並且蒸汽溫度和壓力均不穩定，影響到經濟效益。其原因是受熱面積灰和腐蝕嚴重，影響傳熱使鍋爐負荷下降，不能長時間運行，需停產清理積灰。本論文針對此余熱鍋爐的技術改造，在給定設計條件基礎上，通過熱力計算，煙氣阻力計算和強度計算，對鍋爐受熱面結構重新布置，然後再作校核計算。
  20. The cf correlation of some monitored modules and the cf sensitivity to sootblowing are studied and analyzed from the view of the characteristic of heating surface itself and measuring point collocation

    針對對象鍋爐受熱面和測點布置特徵，討論了各監測模塊清潔因子的相關性和對吹灰的敏感性。
分享友人
分享到 Line

分享到臉書