蒸汽消耗 的英文怎麼說

中文拼音 [zhēngxiāohào]
蒸汽消耗 英文
steam consumption
  • : Ⅰ動詞1. (蒸發) evaporate2. (利用水蒸氣的熱力使食物熟或熱) steam Ⅱ名詞[中醫] (將藥物隔水蒸熟) steaming
  • : 名詞1. (由液體或某些固體變成的氣體) vapour2. (水蒸氣) steam
  • : 動詞1 (消失) disappear; vanish 2 (使消失; 消除) eliminate; dispel; remove 3 (度過; 消遣) pa...
  • : Ⅰ動1 (減損; 消耗) consume; cost 2 [方言] (拖延) waste time; dawdle Ⅱ名詞1 (壞的音信或消息) ...
  • 蒸汽 : vapour; reek; breath; steam蒸汽採暖 steam heating; 蒸汽錘 [機械工程] steam hammer; 蒸汽打樁鍾 ste...
  • 消耗 : 1 (因使用或損失而漸漸減少) consume; use up; expend 2 (使消耗) deplete 3 [書面語] (音信) mes...
  1. Some changes are needed in the configuration of the plant to reflect the changes that have occurred on the site, primarily that both the hydrogen recovery plant that was fed with purge gas and supplied instrument air and the site auxiliary boilers that provide low pressure steam have been dismantled

    裝置布局發生了一些變化,主要的兩項就是拆除了氫回收裝置和輔助鍋爐,氫回收裝置吹掃氣和儀表空氣,輔助鍋爐曾經用來提供低壓
  2. After the transformation of the shift flow to the total low - temperature shift process, the steam consumption per ton of ammonia drops remarkably, but the resistance in the catalyst beds increases rapidly

    摘要將變換流程改為全低變工藝后,噸氨蒸汽消耗明顯下降,但觸媒床層阻力迅速上升。
  3. Using structured packing column or modification of tray column can reduce the steam consumption. after modification of tray column the quality of the refined oil can he also improved

    摘要採用結構填料脫臭塔或改造板式脫臭塔都可以降低蒸汽消耗量。改造板式脫臭塔的同時還可以改善精煉成品油的質量。
  4. The article mainly introduces a new drying tech nique of pvc which has characteristics of unique featu re of low steam consumption and large intensity of drying, low power consumption, low investment of equipment and large elasticity of operation

    一種新型pvc樹脂乾燥技術,具有蒸汽消耗低、乾燥強度大、動力低、設備投入小、操作彈性大的特點。
  5. Comparing with internal heating type fluidized bed, vibration fluidized bed, which get the material to fluidized state through mechanical vibration, can improve thermal utilization factor, quality and reduce steam and power consumption, and one time investment while keeping all advantages of internal heating type fluidized bed

    振動式流化床是一種利用機械的振動,使物料達到流化狀態,它在保留內熱式流化床乾燥器優點的基礎上,在熱利用率,產品質量,降低及電力,設備一次性投資低等方面均較內熱式流化床有較大提高。
  6. The sum of the energy lost and delivered by a steam power plant would be found to be exactly equal to the chemical energy of the fuel consumed

    一個發電廠/站損失的和輸出的總能量,將被發現完全等同於燃油所的化學能量。
  7. Process acquired and improved with the necessary modifications to optimize its work, reducing the specific consume of steam and energy, rationalizing the water consumption and ensuring a uniform cooking

    工藝進行了優化,減少了蒸汽消耗,合理控制水,確保漿料煮的均勻一致
  8. In the systematic optimization we have the gradational optimization, when the heat and electricity load is acknowledged, we can have the least vapour by optimizing the arrangement of the load of every generator in advance. then we can optimize the load of every boiler in the light of the total vapour and have the least fuel consumption

    在系統優化方面採用了分級優化方法:當外界所需的熱、電負荷確定以後,首先優化分配各臺輪機的熱、電負荷使得所需的總新量最低;然後根據這一總新負荷優化分配各臺鍋爐的負荷,使總燃料量最低。
  9. According to the discrepancy of useage, we choose 2 - 5 differential pressure of tower to rectify, use multilevel heat coupling technique, use system heat by classification, and make good use of heat as far as possible, so as to save the cost of steam

    根據產品用途不同或差異,選用2 - 5塔差壓精餾,採用多級熱耦合技術,分級利用系統熱量,使熱量的利用盡可能達到最佳狀態,以節約蒸汽消耗
  10. The calculation methods of energy saving in solution polymerization rubber condensation were provided

    同時給出了凝聚過程蒸汽消耗量的計算方法。
  11. If the total area reduced, the amount of vapor would increased. whereas, if the total area increased, the amount of vapor would reduced

    即,總傳熱面積減小,加熱量則增加;反之,總傳熱面積增加,加熱蒸汽消耗量減少。
  12. The multi - effect evaporation system ca n ' t be designed in order that both total area of heat conduction and consumption of vapor were least

    不可設計一個多效發系統,使總傳熱面積和加熱蒸汽消耗量同時為最小,只能求得相對有效解。
  13. The matrix was introduced to optimize the total area of heat conduction. the relation between consumption of vapor and total area of heat conduction was given

    引入矩陣概念,對三效降膜發系統總傳熱面積進行優化,得到加熱蒸汽消耗量與總傳熱面積之間的關系。
  14. Saturation vapour pressure of internal combustion engine under actual operation conditions is expressed as the multinomial by using least square method, which facilitates the calculation of rectifying coefficient of engine output and fuel consumption as well as the fabrication of computer programme for such calculations

    摘要介紹了用最小二乘法擬合方法,將內燃機現場環境狀況下飽和壓表示為多項式形式,為計算功率和燃油率校正系數,並為此而編制計算機程序提供方便。
  15. Basing on the exergy analysis of the evaporation system the links which losing exergy most was found. the external losing exergy mainly concentrated in the consumption of second - degree vapor. the internal losing exergy mainly caused by the difference in temperature of heat conduction and concentrated heat

    在對發系統(火用)分析基礎上,找到系統(火用)損的主要環節,即二次引起的外部(火用)損、有效傳熱溫差和濃縮熱引起的內部(火用)損。
分享友人