蒸發汽化 的英文怎麼說

中文拼音 [zhēngfāqìhuà]
蒸發汽化 英文
carburation by evaporation
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 發 : 名詞（頭發） hair
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 蒸發 : [物理學] [化學] evaporation; evaporate蒸發計 evaporometer; evaporimeter; atmidometer; atmometer; ...
  • 汽化 : [物理學] vaporization; evaporation; carburate; boil off; nebulization汽化計 atmidometer; evaporat...
  1. They used for making tubes of condenser or vapourizer of refrigeration, for waterfeeder, for capilliary tube in meters and oil - conducting pipe union for mechanical equipment

    該產品廣泛應用於機械、電氣儀表、汽車、輕工、化學工業等部門，作為製冷設備的冷凝器，蒸發器管、供水熱水管，儀表毛細管及機械設備聯結油管等部件。
  2. They used for malcing tubes of condenser or vapourizer of refrigeration, for waterfeeder, for capilliary tube in meters and oil - conducting pipe union for mechanical equipment

    該產品廣泛應用於機械、電氣儀表、汽車、輕工、化學工業等部門，作為製冷設備的冷凝器，蒸發器管，供水熱水管，儀表毛細管及機械設備聯結油管等部件。
  3. We get several useful conclusions on isobaric evaporation, isothermal flash, isobaric condensation, isothermal compressed condensation. an analysis on the micro - layer evaporation model is also discussed in the paper

    在定壓汽化、定溫降壓自蒸發、定壓凝結、定溫加壓凝結、可用能、微層蒸發模型幾個方面得出了一些有用的結論。
  4. Develop and manufacture large pumped storage units, large tubular turbine units, high - power super - critical thermal power unit, large air - cooled turbine generator, large cfb boilers, high - power nuclear steam turbine and generator, pressure shell of nuclear island, high - pressure evaporator and primary pump

    開發生產大型抽水蓄能機組、大型貫流式機組、大功率超臨界火電機組、大型空冷汽輪發電機、大型循環硫化床鍋爐、大功率核電站汽輪機和發電機、核島設備壓力殼、高壓蒸發器和主泵等核電一級設備。
  5. An instrument that measures the rate of water evaporation

    汽化計，蒸發計測定水蒸發速率的儀器
  6. The analytical results indicate that the temperature and the concentration of water vapor have been changed in the condition of condensation and also provide evidence of structural optimum of indirect evaporative cooler

    數值模擬以及熱力性能分析的結果表明，冷凝使得間接蒸發冷卻器內部的溫度場、水蒸汽濃度場等的分佈發生了變化，換熱效果以及有用能的利用狀況也發生了變化。
  7. The main results in this paper are as follows : ( 1 ) study on starting up performance of thermosyphon : according to the study on the states before and after starting up of thermosyphon with the various filling amount, it is considered that the phase change heat transfer inside the copper - water thermosyphon with a large ratio of length and diameter is not only influenced by the boiling degree of superheat, but also controlled by evaporation and companied with the boiling of the thin liquid film

    本文的主要研究結果為： （ 1 ）熱虹吸管啟動性能的研究：通過對從不同充液量、啟動前狀態、內部汽化核心狀態對啟動的影響所進行的試驗研究，認為大長徑比的銅?水熱虹吸管管內相變不僅僅為沸騰，而是以蒸發為主，伴有薄液膜的沸騰。
  8. This paper analyses the heat absorption and evaporation process of the droplet, the combustion characteristic of motor spirit and ethanol motor spirit, and oxygen concentration of motor spirit and ethanol motor spirit was measured from burning to self extinguishing in the enclosed space

    摘要分析了細水霧滅火時液滴的吸熱蒸發過程和汽油與乙醇汽油的燃燒特性，進行了汽油、乙醇在封閉空間內從燃燒到自行熄滅時的含氧量變化測量。
  9. The fuel diffusion and vaporization model in the intake port of small gasoline engine are analyzed, and the key factors affecting the formation of droplet and film are generalized

    本文對小型汽油機進氣道內燃油霧化和蒸發模型進行了分析，總結出了影響油滴油膜形成和蒸發的主要因素。
  10. Material balance and energy balance equations of complex multi - effect evaporation system were expressed in matrix equation, which has the advantages of clear structure and high modularization. by holding or omitting correlation block - matrix in matrix equation, matrix equation could be used to describe the difference of forward - feed, back - feed and cross - reed multi - evaporation system with or without solid separation, extra steam being led off to preheat material liquid, condensation water flash, or solution flash. the models include design and operation

    該模型利用矩陣方程具有結構清晰和高度模塊化的特點，將復雜多效蒸發系統的物料及熱量衡算方程組以矩陣形式表達，通過保留或舍棄矩陣中特定功能模塊，模型就能代表有或無固相析出、有或無引出額外蒸汽預熱原料液、有或無冷凝水閃蒸、有或無溶液閃蒸等不同情況以及各種情況任意組合的併流、逆流、錯流多效蒸發過程，從而實現模型的通用性。
  11. The heat pump evaporation had become a feasible measure of energy conservation. however, the variational work situation influenced both the ejector ' s efficiency and the evaporation capability, even the normal production

    蒸汽噴射式熱泵蒸發為蒸發行業簡單易行的節能措施，但工況的變化會影響噴射器的效率，降低蒸發能力，甚至影響蒸發操作的正常進行。
  12. The matrix was introduced to optimize the total area of heat conduction. the relation between consumption of vapor and total area of heat conduction was given

    引入矩陣概念，對三效降膜蒸發系統總傳熱面積進行優化，得到加熱蒸汽消耗量與總傳熱面積之間的關系。
  13. The design model of seawater desalination with the tvc falling - film evaporation process was deduced. the transfer coefficient of falling - film evaporation process was analyzed in detail. and the effect of the parameter change of process steam to the operation of the device was calculated and discussed

    本文主要開展tvc壓縮蒸餾海水淡化技術研究，建立了tvc壓縮噴淋降膜蒸餾海水淡化裝置的設計模型，對降膜蒸發過程的傳熱系數進行了詳細的分析，並對工作蒸汽參數變化對裝置運行的影響進行了分析計算。
  14. A full cycle can be subdivided into three sub stages : liquid refilling stage, bubble nucleation, growth, coalescence and explosion stage, and transient liquid film evaporation stage

    1個完整的周期可以分成3個子過程：進液階段，汽泡核化、增長、聚合及爆炸階段，瞬變液膜蒸發階段。
  15. In this paper, a new type evaporator, inert particle fluidized bed evaporator, which is adapted to tea liquid infusion evaporating. we designed and built an inert particle fluidized bed evaporator

    本文針對汽?液?固三相流化床蒸發器的特點，把該種蒸發設備應用於綠茶浸提液濃縮蒸發過程。
  16. Inert particles can prevent and clean the fouls. this kind of evaporator fit for the condensing of the glucose solution and it maybe used broadly in foodstuff field in the future

    汽-液-固三相循環流化床蒸發器適用於葡萄糖溶液的蒸發濃縮，在食品工業中具有一定的應用前景。
  17. After the flue heat evaporates the moisture, dry sodium or calcium salts and the un - reacted absorbent are collected in the dust collector. however, very few domestic companies have the ability to manufacture the fdg system

    ，吸收劑噴入洗滌塔時為霧化的泥漿，水汽慢慢地被熱煙氣所蒸發，最後以乾鈉鹽或鈣鹽及未反應的吸收劑混合物之型式，被集塵機所收集去除。
  18. Condenser and evaporator are the main equipments in the refrigerant system. to modeling a heat exchanger to acquaint and grip the working performance of different refrigerant in a aac system can accelerate the equipments choice matching. furthermore which has the important practical meaning for the modernization of aac designs

    冷凝器和蒸發器是汽車空調系統的主要部件，建立一個換熱器動態模擬模型，認識和掌握不同製冷工質在汽車空調系統換熱器內的工作特性，可以加速設計過程中的部件選型和匹配，對實現汽車空調系統設計方法的現代化具有重要的現實意義。
  19. They are removed using catalytic or oxidation reactions to form non - toxic nitrogen or nitrates. practical processes include ammonia and catalytic method, high - temperature nitrogen reduction method, activated carbon and incineration as well as alkaline washing

    ，吸收劑噴入洗滌塔時為霧化的泥漿，水汽慢慢地被熱煙氣所蒸發，最後以乾鈉鹽或鈣鹽及未反應的吸收劑混合物之型式，被集塵機所收集去除。
  20. In this paper, we applied the vapor - liquid - solid three - phase circulating fluidized bed evaporator to condense glucose solution considering its advantage. in the experiment, we changed the parameters such as evaporation temperature, difference in temperature of the fluid heating and heated, liquid flux, liquid thickness and the ratio of inert particles to analyze and study this kind of equipment ' s heat transfer properties in different operational conditions

    通過改變蒸發溫度、傳熱溫差、料液流量、料液濃度以及惰性粒子的體積分率等參數，研究了其在不同操作條件下的傳熱性能，並給出了汽-液-固三相循環流化床蒸發器沸騰傳熱的數學模型，模型預測值與實驗值吻合較好。
分享友人
分享到 Line

分享到臉書