蒸發滴 的英文怎麼說

中文拼音 [zhēngfādī]
蒸發滴 英文
evaporating droplet
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 發 : 名詞（頭發） hair
  • 滴 : Ⅰ動詞（液體一點一點地向下落） drip Ⅱ名詞（一點一點地向下落的液體） drop; droplet Ⅲ量詞（用於滴下的液體的數量） drop
  • 蒸發 : [物理學] [化學] evaporation; evaporate蒸發計 evaporometer; evaporimeter; atmidometer; atmometer; ...
  1. Water, containing dissolved calcium hydrogen carbonate, passes through the limestone and drops evaporate on the stalactite, increasing its length with a deposit of calcium carbonate.

    含有溶解碳酸氫鈣的水通過石灰石滴在鐘乳石上蒸發，隨著碳酸鈣沉積物的增加不斷增加著它的長度。
  2. It was found : 1 ) the film restrained evaporation surface intensity and had obvious function of rising and keeping moisture, 2 ) the drip irrigation could supply water according to growing requirement and augment of water conflux intensity around crop root, it also had strongly controllable operation and wasted fewer water

    覆膜抑制了土壤表面的蒸發面匯，具有明顯的提墑保墑作用，滴灌能隨時根據作物生長需要及作物根系匯流強度的增大而補充匯流源，可控性很強，水的浪費率很低。
  3. The rain drops will be subject to evaporation in the unsaturated subcloud layer.

    在非飽和的雲下層，雨滴將被蒸發。
  4. Larger drops fall quickly and can better afford to lose mass by evaporation.

    較大的雨滴下落得很快，蒸發引起的質量損失較少。
  5. The drip type cooler is a fan unit with evaporative pads.

    滴水式冷卻器是一個帶有蒸發填料的風機裝置。
  6. If the environmental relative humidity is lower, the drop will undergo evaporation and solute concentration will rise.

    如果環境相對濕度較低，則液滴將蒸發，溶質的濃度也隨之提高。
  7. Trickle irrigation is regarded as a significant technology of water - saving irrigation, because we can exactly control the quantity of irrigation water, decreasing ground evaporation and deep - seated leak

    滴灌系統作為一種優秀的節水灌溉技術，它能夠精確的控制灌溉水量，減少地面蒸發和深層滲漏。
  8. Smaller drops spend more time in the unsaturated air and, if too small, are unable to reach the ground before evaporating completely.

    較小的雨滴在非飽和空氣中耗費時間較長，如果太小則在到達地面之前就完全蒸發掉了。
  9. There is a vaporizing layer below 0 layer and it is far thick, which may be one of the important reasons of small precipitation on ground ; in the paper the cloud and the rain drop size distribution in warm layer of stratiform cloud are calculated and analyzed. it is found that n ( d ) = n0dnexp ( - a d ) can express the size distributions of little cloud drops, big cloud drops and rain drops. the observational and calculated results are well matched

    在零度層以下蒸發層的存在，且比較深厚，應是導致地面雨強較小的重要因素之一；本文對暖層的雲滴譜和雨滴譜進行了計算，對小雲滴、大雲滴和雨滴分佈可以用同一種形式的分佈密度函數多階函數n （ d ） = n _ 0d ~ nexp （ - d ）來表示。
  10. The body ' s ability to cool down is impaired by damp air since sweat drips off the skin rather than evaporates, resulting in dehydration without the cooling

    潮濕的空氣會削弱人體的降溫能力，因為汗水會從皮膚上滴下來，而不是蒸發掉，這樣不但沒降溫，還會導致人體脫水。
  11. As to the simulation, three - dimensional n - s equations and two - phase flow model, in which the liquid toluene spray as discrete particles was considered, were employed to describe the turbulent combustion processes in the combustion chamber. the mass and energy transfer between the two phases were calculated by the droplet evaporation model, and the arrehnius model was used to obtain the gas chemical reaction rate. the details of 3d flow field, the distributions of temperature and compounds were obtained by solving the equations

    數值模擬方面，應用三維湍流n - s方程以及顆粒軌道模型描述了激光器燃燒室內部的噴霧兩相燃燒流動過程，兩相之間的質量、能量交換由液滴蒸發模型計算，氣相化學反應速率由arrhnius公式計算，通過耦合求解氣液兩相模型方程，模擬了燃燒室三維流場，得到了燃燒室內的溫度和組分濃度分佈。
  12. The key items influent on the characteristics of spraying have been also studied in the dissertation, we can get a good spraying result by adjusting the related parameters efficiently. ( 3 ) the theoretical model of the dynamical parameters such as temperature, moisture, pressure and contour for hot medium and particle inside the drying chamber were obtained by model, utilized the computational fluid dynamics technique to solve the problem between spraying droplets medium by arranging the double grid dispersing structure and rotary outlet structure and the developed structure improved the drying efficiency and product quality

    （ 3 ）採用-模型實現了壓力噴霧乾燥塔的溫度場、濕度場、流場的理論建模，利用計算流體力學（ cfd ）技術來解決噴霧乾燥過程中熱介質與霧滴間的傳熱傳質以及動量傳遞和湍流擾動等問題，避免了乾燥過程中的設計不合理狀況；通過增加雙格柵均風裝置和旋轉出風裝置，改善了乾燥塔內的熱質傳遞，提高了乾燥塔的體積蒸發強度。
  13. Numerical simulation of dynamics and evaporation of fuel droplets in the chamber of fuel - burning boiler

    燃油鍋爐油滴運動蒸發的數值模擬
  14. Thermodynamic analysis on wet compression process is done in this thesis and studies are done on ideal wet compression process, actual wet compression process, water droplet evaporative rate, wet compression work, inlet evaporative cooling, wet compression efficiencies and water droplet breaking. and thermodynamic model of wet compression process is established, which gives out rules of and methods to calculate wet compression parameters

    本文從熱力學的角度對濕壓縮過程進行了分析，分別對理想濕壓縮過程、實際濕壓縮過程、水滴的蒸發速率、濕壓縮功、進氣蒸發冷卻、濕壓縮效率和水滴的破碎等進行了研究，建立了濕壓縮過程的熱力學模型，給出了濕壓縮過程狀態參數的變化規律和計算方法。
  15. Non - fourier effect of water drop vaporization for water metal fuel motor

    金屬燃料發動機水滴蒸發非傅里葉效應研究
  16. Then, having ensured that their species will survive, the shrimps die as the last of the water evaporates

    然而，在確信物種得以繁衍之後，小蝦就隨著最後一滴水的蒸發而死去。
  17. The dehydration time is square of the droplets diameter so the small diameters of the droplets can cut down the drying time then reduce the height of the drying chamber. to the combined spin - flow pressure spray drying, the diameters of droplets are small and the dehydration rate is higher so keeping the qualities of the dried products we can increase the speed of the inlet wind and reduce the temperature of the outlet wind thus can improve the evaporation intensity of the drying chamber and the average energy utilization of the drying equipment

    因霧滴的脫水時間與其直徑的平方成正比，減小液滴直徑有利於縮短乾燥脫水時間，可有效降低乾燥塔的高度；由於旋流式組合壓力噴嘴霧化滴徑的減小，脫水速度明顯加快，在不影響乾燥物料性質的前提下，適當提高進風溫度，同時有效地降低排氣溫度，有利於提高幹燥塔的蒸發強度，也有利於提高幹燥設備的平均能源利用率。
  18. This paper analyses the heat absorption and evaporation process of the droplet, the combustion characteristic of motor spirit and ethanol motor spirit, and oxygen concentration of motor spirit and ethanol motor spirit was measured from burning to self extinguishing in the enclosed space

    摘要分析了細水霧滅火時液滴的吸熱蒸發過程和汽油與乙醇汽油的燃燒特性，進行了汽油、乙醇在封閉空間內從燃燒到自行熄滅時的含氧量變化測量。
  19. As well - known, there is an induced current on the surface when metal material is in the high frequency electromagnetic field, since tending to skin heating effect to make the temperature of metal material surface go up promptly, surface beginning melt when temperature reaches the melting point of metal, metal material is heated up continuously by surface to core till the metal droplet of melting

    自懸浮定向流技術制備金屬納米微粒與一般的蒸發冷凝法有所不同，其原理是：金屬材料在高頻電磁場中產生表面感生電流，由於趨膚加熱效應使得金屬材料表面的溫度迅速升高，當溫度達到金屬的熔點時表面開始熔化，通過熱傳導作用金屬材料由表面到芯部不斷加熱直至熔化成金屬液滴。
  20. The fuel diffusion and vaporization model in the intake port of small gasoline engine are analyzed, and the key factors affecting the formation of droplet and film are generalized

    本文對小型汽油機進氣道內燃油霧化和蒸發模型進行了分析，總結出了影響油滴油膜形成和蒸發的主要因素。
分享友人
分享到 Line

分享到臉書