蓄能電路 的英文怎麼說

中文拼音 [néngdiàn]
蓄能電路 英文
tank
  • : 動詞1. (儲存; 積蓄) store up; save up 2. (留著而不剃掉) grow 3. (心裏藏著) entertain (ideas); harbour
  • : 能名詞(姓氏) a surname
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 1 (道路) road; way; path 2 (路程) journey; distance 3 (途徑; 門路) way; means 4 (條理) se...
  • 蓄能 : energy storage蓄能器 accumulator
  • 電路 : [訊] circuit (ckt); electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. This paper presents a method that chopping wave is done by switch devices which consist of three - level resistance regulating module and intelligence power module ipm, and which realizes constant - current discharge of storage battery. to achieve the intelligence control of the drive protection and the discharge process of ipm, the paper designs circuit formed by igbt threshold drive pulse pwm signals. ipm fault - blocking protection circuit and microcomputer 80c196. the devices can accurately control the 0 ~ 150a discharge current and the discharge time of the storage battery and calculate the releasing power

    實現池恆流放過程智控制是池放裝置發展的必然趨,本文提出了一種通過三極阻調節模塊和由智功率模塊ipm為開關器件進行斬波從而實現池恆流放的方法。為達到對ipm的驅動保護和放過程的智控制,文中設計了igbt門極驅動脈沖pwm信號形成和ipm故障封鎖保護及由單片機80c196為核心的微機控制器。本裝置夠對池進行0 150a放流及放時間的精確控制及釋放容量的計算。
  2. Finally, because high - speed power solenoid valve is one of the most important executive parts in the electronic control diesel engine and the performances of diesel engine are strongly related to the solenoid valve, the response performance of the solenoid valve is investigated. the response performance of the solenoid is influenced by many factors, such as driving voltage, electric driving unit etc. in order to have high excitation voltage and in low maintaining voltage, a high - low voltage electric driving unit is designed, and in order to make the solenoid valve close more rapidly, an active free - wheeling circuit and a bootstrapping circuit are designed in the electric driving unit, too. in the high - low electric driving unit, high voltage and low voltage are supplied by the dc - dc device and by the accumulator respectively

    高速強力磁閥的響應性除了與閥本身的結構和材料有關外,與驅動壓、驅動的設計密切相關,本文通過分析,首先開發出一種高低壓驅動,高壓源是山升壓式dc - dc原理獲取的,低壓由池本身提供,實現高壓強激和低壓維持的功中採用有源續流柴汕機中卜軌知介系統的設訓及其七川j敝略的叭究進行續流,加誣了磁閥的關閉速度;採用自舉吐,降低了場效應管對驅動壓的要求。
  3. The core products include telecom power systems, board mounted power supplies, custom power supplies, ups, precision air conditionings, outdoor shelter solutions, automatic transfer systems, network power protection products, vrla batteries, lv & precision distribution cabinets, centralized power and environment monitoring systems, dc power systems and ac motor drive inverters used in electric utility power systems

    艾默生網源產品涉及通信源、印刷板板裝源、客戶定製源、 ups 、機房專用精密空調、戶外一體化通信機櫃、自動切換開關、動力網保護產品、池、低壓配和精密配櫃、動力設備及環境監控系統、力操作源、交流變頻調速器等領域。
  4. Dppt nickel cadmium rechargeable cells and batteries for electric road vehicle propulsion applications - part 1 : dynamic discharge performance test and dynamic endurance test

    子道車輛推進通用的鎳鎘再充池和池組.第1部分:動態放試驗
  5. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步動機變頻調速技術的發展概況,在回顧梯液壓控制系統節技術的基礎上,介紹了本課題研製的「採用器的液壓梯變頻節控制系統研究」的基本原理,分析了動力系統在梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式;詳細地介紹了本課題節系統液壓動力泵站的結構設計和參數設計,重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、器迴泄漏油損失機理的研究及其補償裝置的設計、器-泵馬達壓力量轉換裝置的設計、多功集成控制閥組的設計等內容;最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件氣接線、計算機控制及數據採集系統的硬體設計等內容。
  6. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模,並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究,主要針對影響系統特性的主要參數變化,動態分析系統的輸出特性,在上下行工況中,分析了機軸系粘性阻尼系數、軸系摩擦力矩、主迴器迴液壓泵馬達內泄漏系數、器氣體容積、液壓缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響;最後對軸向柱塞泵馬達的流量壓力脈動對梯轎廂速度的影響和器內油液體積損失機理進行了理論研究。
  7. The pressure existing between the guide vane and the runner when the pump - turbine of east china tongbai pumped storage power station stops at different loads is analyzed, and the method for determining the best load at which the generator circuit breaker ( gcb ) switches off during operation of the pump - turbine is illuminated

    摘要介紹華東桐柏抽水站的水泵運行時,不同負荷工況下停機、導葉和轉輪間壓力的變化,闡述了華東桐柏抽水站1號機組發機斷器開斷的最佳負荷值選定。
  8. Based on the experiment of nimh battery, investigations on characteristics of discharging and charging of nimh battery, and analysis of influencing factor of nimh battery, an approach of ah ? coe ? ocu has been carried out to estimate an accurate surplus energy and state of charge of nimh batteries, and consider the compensation of the temperature, aging and self - discharging etc. after theoretic analysis has been completed, simulations are given to determine parameters of batteries for changan hev

    本文在池試驗的基礎上,分析和研究ni - mh池充放特性及其影響因素,建立了池內阻、動勢模型,提出了安時?量守恆?開壓演算法( ah ? coe ? ocu法)預測池的剩餘量和荷狀態計算方法,並進行溫度、循環使用壽命、自放等補償,從而建立了池的充放模型。
  9. Abstract : the rechargeble batteries are used for backup power internal electrically equipments and instruments. but batteries lifetime usually is shorten by overwork and then malfunctions of equipment are induced. to avoid the complexion described above, the protection circuit against overwork is designed. it is based upon the voltage comparator and regulator. it will light up a red led when the volume of the batteries discharged close upon 50 % ; it will switch off the load automatically when it discharged closing to 80 % of their energy capacity, thus overwork of batteries can be avoided and lifetime may be extended

    文摘:用池做后備源的系統(或設備) ,常因過放導致池提前報廢而造成設備故障.根據壓隨容量變化的規律,利用壓比較器和壓基準源設計製作了池放保護,當池放量接近容量的50 %時,啟動預警信號;當池放量達到容量的80 %時,自動切斷負載,防止池過度放,延長池壽命,保證系統(或設備)在供恢復正常后正常運行
  10. There are six series products : accumulator test system, power quality analysis system, auto test analysis system, intelligent cable test system, diesel engine test system and railway security alarm system

    公司現有六大系列的產品:池檢測維護系統,質量分析系統,汽車檢測維護系統,智纜檢測系統,柴油機檢測系統,鐵運輸安全保障系統。
  11. It can reduce the accumulation of heat and increase the rate of temperature gone up and save electric energy, improve the precision of temperature control and easy service the furnace and circuit, by an improvement on the fireproofing materials and temperature control in electric furnace of laboratory

    摘要通過對實驗室爐的耐火材料和溫度控制的改進,可以降低爐體的熱,加快升溫速度,節約,提高溫度控制精度,方便了爐體和的維修。
  12. According to the principle of optimizing resources allocation throughout the grid and the actual situation of the grid, the layout plans of pumped - storage power stations in east china power grid are given, with consideration of conditions such as network transmission capacity and economy

    然後根據全網資源優化配置原則,針對華東網具體情況,考慮網輸送力和經濟性等約束條件,給出了抽水站在華東網范圍內的布局思
  13. In software, this paper programmed this local supervision & control system of communication power supply using visual basic6. 0 language too. and deeply researched on how to fulfill the following functions : dynamic graph display of real - time data acquisition, historical data management ( including save, demand, print, and delete historical data, painting historical trend curve ), intelligent management of the storage cells, alarm and its management, system management, network communication and help system

    重點研究了如何利用visualbasic6 . 0來完成該監控系統的以下功:實時數據的動態圖形顯示,歷史數據管理(包括歷史數據存儲、查詢、列印及刪除、歷史曲線的繪制) ,池智管理,報警及其管理,系統管理,網通信,幫助系統。
  14. Taking stc89le516ad and uc3842 as the core, an intelligent charging circuit which can realize receivable charging electric current curve tracking technology for the battery was designed

    摘要以stc89le516ad和uc3842為核心,實現池可接受充流曲線跟蹤技術的智設計。
  15. In order to estimate soc effectively, based on the principle of the charge and discharge of the mh / ni batteries, " analyzed the traditional ways of estimating soc, in this research paper a neural network model of mh / ni batteries on lm network was built up

    採用can總線構成了整個分散式量管理系統。為有效地對動車池的soc進行預測,引入了人工神經網bp改進演算法的levenberg - marqardt ( lm )演算法,建立了基於鎳氫池的神經網模型。
分享友人