表面張力測量 的英文怎麼說

中文拼音 [biǎomiànzhānglìcèliáng]
表面張力測量 英文
measurement of surface tension
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 張 : Ⅰ動詞1 [書面語] （給弓或樂器上弦） fix （a bowstring）; string （a musical instrument） 2 （分開;...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. A new diagraph surface tension with the device of surface tension coefficient has been developed in order to cultivate the working abilities and deepen the students ' understanding of the impression to the liquid surface tension with comprehend

    摘要本文為培養學生動手能力和加深學生對液體表面張力的印象和理解，研製出一種新的測量表面張力和表面張力系數的裝置，並從原理和實際操作中作了詳細的說明。
  2. Moreover, the resulted prediction model of foam size of the closed cell aluminum foam was verified by comparison to the experimental results from the foaming process at different foaming conditions, and the predicted bubble diameter is in good agreement with the experimental ones, the relative error distributes between - 5. 04 % and 6. 32 %

    當入射空氣的壓強、氣流量，液面高度，出氣孔直徑增大時，氣泡直徑隨之增大；當出氣孔數量，液體粘度增大時，氣泡直徑減小，表面張力對氣泡直徑的影響可以忽略不計；靜態條件下液體表面氣泡直徑的預測值和實驗測量值符合得較好，相對誤差分佈在- 5 . 04 % ~ 6 . 32 %之間。
  3. If the wetting liquid has very low surface tension, the precise measurement of θ is not critical.

    如潤濕液體的表面張力很低，接觸角的精確測量則不難。
  4. Surface tension measurements of binary hydrofluorocarbon mixtures

    二元混合物表面張力測量
  5. The interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity

    研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大
  6. Abstract : the interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity

    文摘:研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大
  7. Adhesives - wettability - determination by measurement of contact angle and critical surface tension of solid surface

    膠粘劑.濕潤度.通過固體表面接觸角和臨界表面張力的測量確定濕潤度
  8. Adhesives - wettability - determination by measurement of contact angle and critical surface tension of solid surface ; german version en 828 : 1997

    粘合劑.可濕性.固體表面接觸角度和臨界表面張力測量
  9. A lot of indoor and in - suti test to the properties of the chemical grouting material, especially the properties requested by actual engineering has proceeded. active - diluent of furfural - acetone, low poison hardener. surfactant and a series of formula have been selected by experiment. cw series material has low glue degree, time last of it harden can be adjust, surface tension and contact angle of the material is low

    對漿材性能特別是工程實際對漿材要求的性能進行了大量室內、現場試驗測試，選擇性能優良的糠醛?丙酮活性稀釋劑、低毒憎水性固化劑、表面活性劑及系列漿材配比， cw系漿液粘度、固化時間大范圍可調、表面張力及接觸角小、漿材固化及固結強度高，具有優良的浸潤性能和工藝性能。
  10. On the design of the instrument software, because the computer data process system of the first and second kinds of products run in the dos environment, which is written by the language of the basic. it is proved in the dos environment that data is processed slowly, man - machine interface is n ' t friend and operation is n ' t convenient. what ' s more, the code of program written by the basic is changed easily by accident by user, which does n ' t adapt to production and commodity of the instrument. therefore, we have developed with visual c + + language a suit of data process soft system supported by windows 95 / windows 98 / windows nt in the third kind of the sample instrument. the developed software system has good reliability, friendly user interface and convenient operation

    另外為了進一步擴大儀器的測量范圍，我們將第三代產品的使用擴展到對各種液體表面張力的測試，並進行kd -型樣機的製作，以供第三軍醫大學燒傷研究所作人和動物呼吸道燒傷的實驗研究。在儀器的硬體設計方面，我們力求做到結構緊湊，性能穩定，重復性好，且成本低廉。在儀器的軟體設計方面，由於第一和第二代產品的計算機數據處理系統是運行在dos環境下，用basic語言編寫的程序。
  11. < uk > if the wetting liquid has very low surface tension, the precise measurement of is not critical. < / uk >

    < uk >如潤濕液體的表面張力很低，接觸角的精確測量則不難。 < / uk >
  12. Lastly, according to correlation theoretics of advanced education and application theoretics of computer multimedia technology, the paper researched and empoldered college physical experiments " multimedia textbook. on the base of abundant investigation and practice in practical work, some research and development principles about multimedia textbook were concluded, and the basic frame of college physical experiments " multimedia textbook was constructed. and thereinto, five multimedia experiments such as measuring electrostatic field with simulation method, michelson interferometer, measuring the tensility of liquid surface, air cushion navigation experiment, and drawing lissajous figures were empoldered

    最後，論文根據高等教育的相關理論和計算機多媒體技術的應用理論，開展了「大學物理實驗」多媒體教材的研究與開發工作，並在大量調查研究和研發實踐的基礎上，歸納出多媒體教材的研發原則，構建起「大學物理實驗」多媒體教材的基本框架，同時研發了「模擬法測靜電場」 、 「邁克爾遜干涉儀」 、 「氣墊導軌」 、 「液體表面張力的測定」以及「李薩如圖形」等五個實驗內容的多媒體教材。
  13. Anionic and non - ionic surface active agents. determination of the critical micellization concentration. method by measuring surface tension with a plate, stirrup or ring

    陰離子和非離子表面活性劑.臨界膠束濃度的測定.用板蹬式夾或環測量表面張力的方法
  14. Second, the iscosity, density, surface tension and size of the spray droplets of binder solutions with different hpc concentrations were determined and wetting characteristics of the binders on the excipients were measured

    第二，對不同濃度的hpc溶液的黏性，密度，表面張力和霧滴大小進行測定，並測量黏合劑對輔料的潤濕特性。
  15. Plastics. aqueous dispersions of polymers and copolymers. measurement of superficial tension dynamic method by immersion foil

    塑料製品.聚合物和共聚物的含水分散物.用動態法通過浸泡箔片對表面張力的測量
分享友人
分享到 Line

分享到臉書