衰減材料 的英文怎麼說

中文拼音 [shuāijiǎncáiliào]
衰減材料 英文
attenuating material
  • 衰 : 衰動詞（衰弱） decline; wane
  • 材 : 名詞1 （木料） timber 2 （泛指可以直接製成成品的東西; 材料） material 3 （供寫作或參考的資料） ma...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 衰減 : attenuation; decay; damping; reduction; rejection; weakening; deamplification; dampening; dying o...
  • 材料 : 1. （原料） material 2. （資料） data; material 3. （適于做某種事的人才） makings; stuff
  1. At present, the solar cells used on space aircrafts are still mainly si and gaas solar cells. however, the radiation resistance ability of these two materials is poor. since the photoelectric conversion efficiency attenuates rapidly with the radiation, the lifetime of si and gaas solar cells is short and their stability is not satisfied for space applications at van allen belt

    目前國內外用於航天器上的太陽電池主要為si和gaas太陽電池，但這兩種材料的抗輻射能力較差，其光電轉換效率由於高空輻射衰減很快，因而壽命短，穩定性差，不能滿足用於vanallen強輻射帶的空間應用需要。
  2. And the impact of processing conditions on the electrochemical performance of the porous sn - cu alloys was investigated. results showed that it was good to add more verdigris and to make the annealing time longer for improving the performance. however, the problem of capacity fading can not be solved completely by this method

    並對制備合金材料過程中所添加物質的種類和比例、燒結時間等工藝參數對合金的性能的影響進行了分析，發現添加堿式碳酸銅，並且增大添加比例以及延長燒結時間對電極材料的循環壽命有利，但是不能根本解決容量衰減的問題。
  3. Measurement of the longitudinal wave velocity and attenuation for underwater acoustical materials - pulse - tube method

    水聲材料縱波聲速和衰減的測量脈沖管法
  4. So we do n ' t ignore the effect of inner amortisseur of these materials, these similar materials are called the viscoelastic

    在對大多數這樣材料的研究時，我們不再忽略它們的內部衰減的影響，這些材料為粘彈性材料。
  5. Test method for shock attenuating properties of materials systems for athletic footwear

    運動鞋用材料系統的沖擊衰減性能的試驗方法
  6. Therefore, by determining the intensity of ultrasonic damping, the mechanical properties of composite can be predicted directly

    結果表明，可以通過超聲衰減的弦度直接預測復合材料的力學性能。
  7. In allusion to disjoint of damage model in material, member and structure level, two times poa - based global damage model is presented. this model includes synthetically stiffness, intensity and ductibility degrading by equivalent stiffness decay before and after damaged

    針對材料、構件和結構層次的損傷模型存在著脫節問題，本文介紹了基於兩次poa分析的整體損傷模型，通過結構受損前後等效剛度的衰減來綜合考慮結構剛度、強度和延性的退化，並通過算例來驗證該模型。
  8. Secondly, better performance lifepo4 / c composite was synthesized by adding proper content of sucrose to the reactants, test results exhibited the initial discharge capability could get 130mah. g - 1 and the capability didn ’ t fade down after more than ten cycles ’ test

    2 .添加適量的蔗糖制備出電化學性能良好的lifepo _ 4 / c復合的正極材料，其初始放電比容量高達130mah . g - 1 ;經10次充放電循環，材料的比容量幾乎不衰減。
  9. The damage introduced by single and 5 repeated thermal shocks ( water - quench experiments ) was characterized by degradation of flexural strength in three - point bending

    單次和5次重復熱震（水淬試驗）后經三點抗彎測試來觀察材料抗彎強度的衰減情況。
  10. So sral2o4 eu, dy can be regarded as high efficiency solid display material. in this dissertation, sral2o4 : eu, dy is prepared by high temperature solid - state reaction, which contained the steps of stoichiometry, grind and high temperature agglomeration

    並通過對10小時余輝衰減曲線的準確測量詳細研究了各步驟對材料發光性能的影響，總結出制備此類長余輝材料的最佳配方和制備工藝。
  11. Electro - optical curves for lc cells have been analyzed and it has been shown mat a large attenuation range and a shallow attenuation slope can be achieved simultaneously for a variable optical attenuator based on a parallel - aligned lc cell with an appropriate surface anchoring strength. as compared with the existing liquid crystal - based voa structure ( using two cascaded lc cells with a particular material ), the present structure is simple and has no special requirement for the lc materials

    提出了基於弱錨定平行排列液晶盒的可變光衰減器（衰減范圍大、衰減曲線下降平緩以保證調節精度） ，與己有液晶型可變光衰減器結構（選用特定液晶材料、兩個液晶盒級聯結構）相比較，本論文提出的基於弱錨定平行排列液晶盒的可變光衰減器結構簡單，同時對于液晶材料無特殊要求。
  12. Experiment contrast show, the prepared w - type planar hexaferrite microwave absorptive material appears two absorptive peaks in the frequency range of ( 7 ~ l2ghz ), its average attel1uation exceed 7db, the maximum absorptive attenuation is 24db, coat matching thickness is l. 21mm, especialy its curie temperature is 457c. so, it can meet practical demands in military camouflage field

    實驗結果表明，該種吸收材料在x波段內呈現兩個吸收峰，平均衰減量7db ，最大吸收峰為24db ，塗層匹配厚度為1 . 21mm ，特別是具有457的居里溫度。所以該種鐵氧體是一種性能優良的微波吸收材料，在軍事隱形技術中有實用價值。
  13. The main cause of signal ' s decrease in infrared channel of spacecraft flying remote sensing instrumentation is water vapor deposition on the surface of low temperature optical instruments which released from materials

    摘要空間遙感儀器紅外通道的信號衰減，人軌初期的主要原因是由於材料釋放的水汽在低溫光學窗口表面沉積，導致紅外透射率降低所致。
  14. Ii ) the membrane materials of polymer may be oxidized by ferrate ( vi ) because of their strong or weak reductivity, when they were directly connect with the ferrate ( vi ) cathode in experiment cell., so the the cathode ' s capacity decreased

    二、高分子隔膜材料具有或強或弱的還原性，在實驗電池中與高鐵電池的正極直接接觸，可能會被高鐵酸鹽氧化，造成電池正極容量衰減及穩定性下降。
  15. Modification factors were given according to the relationship between elastic modulus reduction and tensile stress. the empirical elementarily formulas of damage evolution in tensile loading were given quantitatively, and verified by experiments

    通過彈性模量衰減與應力變化的關系，確定了二維編織、三維編織c sic復合材料拉伸損傷的修正系數，初步定量給出了該材料拉伸損傷演化方程的經驗公式並通過實驗驗證。
  16. It is indicated that the hydration process of cement - based materials with slag, fly ash and silica fume is different in some degree from that of neat cement because of the difference in mineral structure and hydration mechanism. the periods of accelerating, decelerating and terminating are prolonged and hydration reaction decelerates. the second peak of rate curve of the heat evolution could be divided into two small peaks, which are contributed to the hydration of clinkers and mineral mixtures at the temperature of 30 but when temperature comes to 50, the two small peaks combine into one and the reaction accelerates

    結果表明，與硅酸鹽水泥相比，由於礦物摻合料與水泥熟料在活性和水化機理上的差異，水化歷程有較大的改變：多組分體系誘導期、加速期和衰減期延長，水化反應速率明顯降低；低溫時，水化放熱速率曲線上的第二放熱峰細化成分別對應于熟料和礦物摻合料水化的兩個小峰；高溫時，反應速率加快，雙峰合併；進一步研究發現，摻合料的種類與摻量對水化歷程也有較大的影響；建立了適用於多組分水泥基材料不同水化階段的水化動力學方程。
  17. The damping coefficient of the laminated composites is more than twice that of ly12 aluminum alloy. furthermore, the damping coefficient of laminated composite is enhanced with the increasing of thickness of fiber / resin layer. the vibration damping mechanism is analyzed

    研究了不同纖維樹脂層厚度時疊層復合材料的阻尼性能，發現隨中間層厚度的增加，疊層復合材料的振動衰減系數增加，並分析其振動衰減機制。
  18. We think increase of the internal resistance of battery is the main problem to the recycle life deteriorating at high rate, besides the influence of the materials. decomposition occurred on positive and negative electrode at high rate current and the interspaces increased. the restrains of swelling and the increase of an oxygen overvoltage can improve the performance of recycle life

    對于電池性能衰減的原因，認為除了所使用的材料是影響電池性能的重要因素之外，在溫度和大電流作用下，電池的正負極材料發生裂解，極片內空隙增大，電池內阻性能惡化是引起電池高倍率循環性能惡化的關鍵;通過抑制正極析氧和膨脹，並降低負極合金材料的粉化過程，將有望緩解電池內阻特性的惡化，從而提高電池高倍率充放電循環性能。
  19. There are two main factors resulting in fading capacity and poor cyclability, one is the john - teller distortion of mn3 +, and the other is mn dissolution to electrolyte. the main objects of this paper are to resolved these key problems effecting on the performance of batteries. during the research of suppressing jahn - teller distortion, low valence cation ( al 、 mg ) and anion ( f ) doped method are usually adopted

    針對limn2o4正極材料在電化學循環過程中發生jahn - teller畸變和mn在電解液中溶解這兩個導致容量衰減和循環性能劣化的關鍵問題，分別採用al 、 mg陽離子摻雜和al / f 、 mg / f陰陽離子復合摻雜兩種措施，對尖晶石結構limn2o4正極材料進行了改性研究。
  20. The significant capacity loss of the spinel limn2o4 during cycling hereby prevents its wider use as cathode materials for lithium secondary batteries. there are two main factors resulting in fading capacity and poor cyclability, one is the jahn - teller distortion of mn3 +, and the other is mn dissolution to electrolyte. the main objects of this paper are to resolved these key problems effecting on the performance of batteries

    針對limn _ 2o _ 4正極材料在電化學循環過程中發生jahn - teller畸變和mn在電解液中溶解這兩個導致容量衰減和循環性能劣化的關鍵問題，分別採用陰陽離子復合摻雜和尖晶石晶粒表面包裹兩種措施，對尖晶石結構limn _ 2o _ 4正極材料進行了改性研究。
分享友人
分享到 Line

分享到臉書