被測值 的英文怎麼說

中文拼音 [bèicèzhí]
被測值 英文
measured alue,
  • 被 : Ⅰ名詞1 （被子） quilt 2 （姓氏） a surname Ⅱ動詞[書面語]1 （復蓋） cover; spread 2 （遭受） suffe...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  1. In the wet lab, phenol is tested for ph, solidification point, solubility in water, bromine index, color, and distillation ranges

    在濕的實驗室中，酚為酸堿值，團結點被測試，水，溴指標，顏色和蒸餾范圍的溶解度。
  2. Research of thermal engineering performance test facilities for refrigerated containers - the test standards and methods are deeply analyzed. airtightness test, heat leakage test and performance test ( with refrigeration unit ) are done on the developed test facilities. the process of the experiment system, used hi measuring the thermal engineering properties of refrigerated containers, is thoroughly discussed

    氣密性實驗結果顯示，箱內、外的溫度波動范圍處於15 25之間，箱內、外的壓差處於250 10pa范圍內，平均漏氣率為2 . 38 （ m / h ） ，遠遠低於極限值10 （ m / h ） ，被測試的冷藏集裝箱的氣密性符合規范要求。
  3. In addition, the biosensor could be used for the detection of benzoic acid. the choline oxidase electrode based on polyaniline / polyacrylonitrile composite film showed sensitive and stable bioelectrochemical response to choline, which was influenced by ph, working potential and temperature

    研究發現，基於聚苯胺/聚丙烯腈復合膜的膽堿氧化酶電極對膽堿具有靈敏和穩定的生物電化學響應，被測溶液的ph值、工作電位、使用溫度等對酶電極的響應有一定的影響。
  4. The use of suppression - conductometry showed the special features of lowering the background of the eluent, increasing the conductance of the detected ions and improving the s / n ratio

    採用抑制電導可以降低淋洗液的背景電導，又可以增加被測離子的電導值，改善信噪比。
  5. The laboratory can provide calibration service for the measurement of the wavelength of any laser having a nominal wavelength of 633 nm. calibration is performed by comparing the wavelength of the laser under test with the wavelength of the standard iodine - stabilized helium - neon laser of the laboratory

    本所可為波長標稱值為633nm的激光器提供波長測量服務。被測試的激光波長將與本所的標準碘穩頻氦氖激光器的波長比對而進行校正。
  6. A portable wind cable can be measured in a variety of circumstances, not by the winds of change cable circumstances measuring wind cable tension ; both of arbitrary moment of absolute tension cable wind, the wind can monitor cable tension variation ; construction equipment to the wild environment ; lightweight structures, the demolition convenient, simple measurement ; the intelligent measurement mode, can provide a wide range of choices rope specifications directly measured wind cable tension that the absolute need for conversion, and misoperation automatic alarm functions, measurement more convenient, direct, accurate and high degree of automation

    一種便攜式纜風測力器可在各種施工環境下，在不改變纜風受力的情況下測量纜風張力；既能測量任意時刻纜風張力的絕對值，又可監測纜風的張力變化；裝置適應野外施工環境；結構輕巧、安拆方便、測量簡捷；在智能化測量模式下，能夠提供多種鋼絲繩規格的選擇，直接顯示被測纜風張力的絕對值，無需換算，並有誤操作自動報警功能，測量更加方便、直接、準確，自動化程度高。
  7. The main working procedure of the fiber - optic sensor is : the sensing element detects the acceleration signal, this signal modulates the phase of the wave, and the phase change is corresponding to the acceleration signal

    該光纖加速度計的工作過程為:敏感元件感受外界的加速度信號，並把它轉化成馬赫-增德爾干涉儀測量臂的拉伸或壓縮，從而引起測量臂中的光波相位變化，相位變化量即代表被測加速度值。
  8. The photoelectric integrating color measurement instrument can obtain the objective tristimulus values via spectral energy integration of the color to be measured by the chromatic detectors, such as the colorimeter and color - difference meter, which have wide application in industrial practice

    摘要光電積分式測色儀器通過色度探測器對被測顏色光譜能量進行積分測量，直接獲得目標的三刺激值，如色度計和色差計等，已被廣泛應用於工業實踐。
  9. When various diameter particles are irradiated by a collimated laser light beam, light scattering phenomenon takes place, and the scattering light parameter include the information of the particles size distribution. mie scattering theory is the fundamental principle of the particle size measuring instruments and its computations are complicate

    微型化霧粒粒徑分佈測量儀的測量原理是米氏光散射理論，當不同粒徑的顆粒被平行激光束照射后，發生光散射現象，散射光的參數包含有被測顆粒粒徑的信息，但其數值計算量大且復雜。
  10. This paper uses an optically modulated scatterer system to measure microwave field with minimal disturbance. this method is especially adapt to measure magnitude and phase of microwave field close to conductor and microwave field with complex path between source and field. so it can be used to measure radiation antenna ’ s near - field and microwave into slots

    光調制散射器的測量方法最大限度地減少了測量裝置對被測場的擾動，特別適合於測量導體附近和具有復雜路徑場的幅值和相位分佈，可以用於對輻射天線近場的測試以及孔縫耦合中場的測量，可為天線的設計，微波孔縫耦合效應的研究提供較精確的實驗數據。
  11. Continuous adjustable current 0 ~ 1a could avoid shock by high current. technician could estimate safety current data after testing normal current as referral

    具連續可調恆流輸出0 ~ 1a ，根據被測電子線路的正常耗用電流值參考，估算預設安全的恆流值，防止大電流對負載的沖擊。
  12. It can automatically match rotational speed generator, electromagnetic rotational speed sensor and electromagnetic turbine flowmeter. moreover it can adapted measured signal that is 1v ~ 300v voltage and 1hz ~ 2500hz frequency

    能自動匹配測速發電機、電磁式測速傳感器和電磁渦輪流量計，適應電壓峰峰值從1伏以下至300多伏、頻率從1hz以下至2500hz以上的被測信號。
  13. It was found that the composite film containing 28. 6 % polyisoprene suited well for biosensor construction. the apparent michaelis constanst and activation energy for the immobilized glucose oxidase are 11. 9 mm and 41. 1 kj - mol " 1, respectively. the biosensor response was influenced by ph value of determined solution, applied potential and operational temperature

    研究發現，復合膜中聚異戊二烯含量28 . 6為傳感器製作的最佳條件；固定化葡萄糖氧化酶的表觀米氏常數為11 . 9mm ，酶催化反應的表觀活化能為41 . 1kj ? mol ~ （ - 1 ） ；被測溶液的ph值、工作電位、使用溫度等對葡萄糖傳感器的響應有一定的影響。
  14. This inverse filter can consider the efficacious bandwidth of signal tested and the character of measurement system synchronously so we can acquire the estimating value of signal tested and the error is little

    這種反濾波器兼顧被測信號的有效帶寬和測試系統的特性，能夠得到被測信號誤差很小的估計值。
  15. The circuit on which the ballast is tested is to be protected by class h non - renewable fuses at ten times the input current rating of the ballast or the next higher ampere fuse rating but in no case less than 20 amperes

    被測試的鎮流器的電路由h級的不可再生的保險絲（是鎮流器的額定電壓的十倍）保護著的或者是更高安培的熔絲額定值，但是決不能少於20安培
  16. First, the error transfer characteristic among subsystems at different space locations is analyzed, and the direct transfer characteristic from discrete standard measure space to the workpiece measure space under measured in measure system is proven. second, the error reconstruction condition and method of mapping from discrete standard measurement system to continuous standard measure space are analyzed. based on the measurement sample stationarity in limited distance, the prediction model ' s limited astringency and mensurability to the dynamic measuring error and the prediction error respectively are proven

    分析了不同空間位置子系統間的誤差傳遞特性，證明了在測量系統中離散標準量值空間向被測量工件量值空間的直接傳遞性；分析了離散標準量系統向連續量值空間映射的誤差重構條件和方法；基於測量樣本的有限距離的平穩性，證明了預報模型對動態測量誤差的有限收斂性和預報誤差的可測度性，進而證明了以離散標準量值系統對被測工件預報修正的可行性和合理性。
  17. Advanced fpga technology is introduced to improve the integration of digital circuits, and all digital circuits in the original module are integrated in the fpga chips, which could not only reduce the cost, but also improve the reliability and measurement precision of the circuits. high speed digital signal processor ( dsp ) is selected as the coprocessor instead of scm ; it can receive all kinds of commands sent from vxi, analyze and execute the commands, harmonize each section of the module and process the data. higher - conversion - speed comparator chip is adopted to convert the input signals being measured into square waveform signals which could be identified by fpga chip ; it can expand the measurement range of frequency dramatically

    本文在原有vxi總線四通道計數器模塊的設計基礎上，通過對原模塊缺陷的分析，採用一些新的技術和新的電子器件來重新設計該計數器模塊:採用最新的fpga技術來提高數字電路的集成度，將原模塊中的所有數字電路全部集成在fpga晶元中，這樣不僅能節約成本，還能提高電路的可靠性和測量精度;採用高速的數字信號處理器（ dsp ）取代原有的單片機作為協處理器，來接收vxi發來的各種命令，分析命令、執行命令、協調模塊各部分的工作以及對數據的處理;採用轉換速率更高的比較器晶元將輸入的被測信號轉換為fpga晶元能夠識別的方波信號，能極大提高測量頻率的范圍;採用d / a轉換晶元和隔離運算放大器得到隔離通道所需的比較電平，該比較電平值能夠根據實際需求進行設置，能增強模塊的使用靈活性。
  18. According to dynamic characters of vibration system, the relation between the balance machine vibration and unbalance value is find out, which provide a foundation for the tests method

    本文通過研究平衡機機械部分振動系統的動力學特性，得出了平衡機振動系統由於被測工件不平衡的慣性力產生的振動和不平衡慣性力量值之間的關系，為測試方法的建立提供了依據。
  19. Then the optical path difference can be obtained with psi algorithm and to use the phase value for each pixel to determine a height value for each pixel. a primary advantage of psi is its high precision. with careful control of environmental conditions, measurement precision to the nanometer scale or below is possible with psi

    它的基本測量原理是，通過攝像系統（ ccd ）接受到的干涉圖中空間坐標已知的各個像素點的光強信號，在壓電晶體驅動參考光程有序變化時，採集到多幅干涉圖的光強信號，由移相干涉法，由光強值得到被測光程差值（位相值） 。
  20. Artificial adjustment of measured values to allow for their significance in aparticular context

    考慮到被測值在特定情況下的重要性而作的人為修正。
分享友人
分享到 Line

分享到臉書