補償腔 的英文怎麼說

中文拼音 [bǔchángqiāng]
補償腔 英文
compensated cavity
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 償 : 動詞1. （歸還; 抵補） repay; compensate for 2. （滿足） meet; fulfil
  • 腔 : 名詞1. （動物體內空的部分） cavity; chamber 2. （話） speech 3. （樂曲的調子） tune; pitch 4. （說話的腔調） accent; tone
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  1. A study on a compact kerr - lens mode - locking resonator with astigmatic compensation

    緊湊型像散補償的克爾透鏡鎖模腔
  2. Second, we compute the self - impedance through cavity modal theory and mutual impendance based on reaction theory respectively. then the generalized impedance matrix that reflects the effect of mutual coupling is formed. at last, the effect of mutual coupli ng on 2 - d doa estimation algorithms is investigated and two efficient methods of mutual coupling compensation are proposed

    本文首先對兩種二維doa估計演算法? ssm法和二維酉esprit法的性能進行了比較，用空域平滑演算法解決了相干源的二維doa估計；其次運用腔模理論計算微帶天線的自阻抗，用反應原理計算微帶天線間的互阻抗，進而形成計入互耦影響的廣義阻抗矩陣；討論了互耦對二維doa估計的影響，提出了兩種互耦補償的方法。
  3. Research on temperature compensation in the rectangular resonant cavities using bi - metals

    利用熱雙金屬片對矩形波導諧振腔溫度補償方法的研究
  4. Self - compensating sealing technology by pressure of inner cavity medium

    內腔介質壓力自補償密封技術
  5. Adopting the amendatory rate equation, the threshold of the micro - cavity has been studied and the conclusion is shown as following : if there is not non - radiation transition, the pump velocity just need to compensate the photon velocity escaped from the cavity, and the intensity of output light will direct ratio to the intensity of input light then we got a micro - cavity laser with no threshold

    採用修正的速率方程對微腔激光器的閾值進行研究，得到如下結論：在沒有無輻射躍遷時，激光器的泵浦速率只需恰好補償光子向腔外的逃逸速率，輸出光強隨著輸入泵浦光強性線增加，實現所謂的「無閾值」激光器。
  6. The compensator compensates the change of polarized light, and also controls the polarized orientation. in result, we get a cavity, with the orientations of the linear polarized multi - longitudinal modes are agree. the noise of green output reducing, the cavity is steady with multi - longitudinal modes operating

    本文首次將nd ： yvo _ 4晶體應用於抑制激光噪聲的補償片法中，利用nd ： yvo _ 4晶體的線偏振特性，控制諧振腔內激光束的偏振方向，使多縱模均為線偏振，且偏振方向一致，從而減少了綠光輸出中的波動現象。
  7. In the part of the experimental designs, a experimental configuration of an unstable cavity by use of two bbo crystals compensating the walkoff effect and pumped by reflection is presented, and two set of controlling systems designs of open and closed loop are also presented ; we realized closed loop controlling system of bbo optical parametric oscillator tuning system, by using american general scanning inc. ' s controller to control bbo crystal ' s rotation, and scaled the output wavelength with charge coupled device

    在實驗設計上給出了利用兩塊bbo晶體補償走離效應返回式泵浦非穩腔的實驗設計，設計了開環和閉環兩套控制系統。通過使用美國通用掃描公司的掃描頭控制bbo晶體的轉動，用ccd對bbo - opo輸出波長進行標定，實現了bbo - opo調諧系統的閉環控制，相對波長調諧誤差小於0 . 04 ，並給出了354 . 7nm泵浦的類相位匹配bbo - opo輸出波長隨晶體轉角變化的理論和實驗曲線。
  8. Geometric, kinetic, and lifetime analysis of anti - rotation mechanism with thrust ball - bearing is conducted, which is commonly employed in the scroll compressor of automotive air - conditioning system, and its wear during later stage ' s operation is also analysed quantitatively. it is pointed out that, in the case of having radial flexible mechanism, the wear between anti - rotation mechanism and scroll wrap exhibits synchronism and self - compensation. otherwise slight rotation would take place with that mechanism and orbiting scroll, resulting in asymmetric pressure within compression chamber pair and radial leakage

    針對汽車空調渦旋壓縮機中最常見的防自轉機構滾珠防自轉止推軸承，進行了幾何、受力及壽命分析，並對其後期磨損加以定性的理論分析.指出在具有徑向柔性機構的情況下，該防自轉機構和渦旋盤齒的磨損具有同步性和自動補償性.在無徑向柔性機構的情況下，防自轉機構和渦旋盤會產生微自轉，可導致壓縮腔對壓力不對稱和產生徑向泄漏
  9. Steps were made on the female die surface to make up for the thickness different of the blanks

    凹模表面和型腔加工了臺階以補償坯料的厚度差值。
  10. Phase compensation of talbot cavity

    外腔鎖相相位補償元件的理論計算
  11. Based on there studies, a new temperature compensation method is proposed to stabilize the resonant frequency of a rectangular resonant cavity

    根據熱雙金屬材料的溫度特性，本文提出了一種穩定諧振腔諧振頻率、對諧振腔進行溫度補償的方法。
  12. That is, through analysis of the principle on flow control and " hydraulic transistor ", design and calculation of flow control characteristic as well as main parts in valve inner chamber, a piloted reducing valve will be installed between main valve and pilot valve. after a pressure - difference compensating reducing valve was added in the non - pressure compensating piloted reducing valve of the flow control valve in vlalvistor valve, the calculation on control characteristic emulation and load characteristic emulation has been carried out. the result of the calculation shows that after pressure compensating reducing valve was added, the linearity of the control characteristics has been greatly improved thus eliminating influence upon outlet flow by load pressure - change of the hydraulic system and improving performance characteristics of the hydraulic component

    文章還在對瑞典valvistor閥的插裝比例閥研究的基礎上，提出了一種新的流量控制原理，即：通過對流量控制和「液壓晶體管」原理的分析、流量控制特性及閥內腔主要結構件的設計計算，在主閥和導閥之間增設先導減壓閥，並進一步對valvistor閥的流量控制閥之無壓力補償先導減壓閥、加入壓差補償減壓閥后的控制特性進行了模擬計算和負載特性模擬計算，結果表明：增設壓力補償先導增壓閥后，其控制特性曲線變得非常線性，從而消除了液壓系統負載壓力變化對主閥輸出流量的影響。
分享友人
分享到 Line

分享到臉書