補償電橋 的英文怎麼說

中文拼音 [bǔchángdiànqiáo]
補償電橋 英文
bucket bridge
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 償 : 動詞1. （歸還; 抵補） repay; compensate for 2. （滿足） meet; fulfil
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 橋 : 名詞1. （橋梁） bridge 2. （姓氏） a surname
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  1. Second, the results of theory analysis and simulation research show that the output of one cycle controlled bridge switching power amplifier have dc offset because of the nonideal characteristic of reset signal. the magnitude of output dc offset voltage is proportional to width of reset pulse. a voltage compensation technique is used to solve this question, and the computation formula of compensation voltage is gived. the circuit compensated and not are researched through simulation and experiment, which results show that compensated circuit solve the output dc offset effectively

    其次，理論分析和模擬研究結果表明，由於復位脈沖的非理想特性，單周控制的全橋開關功率放大器輸出端存在直流偏置問題，其大小與復位脈沖的寬度成正比。針對輸出直流偏置問題，提出了電壓補償的改進方案，給出了補償電壓的具體計算公式。對補償前和補償后的方案進行了對比模擬研究和實驗研究。
  2. At last, control circuit of one cycle controlled bridge switching power amplifier is improved with the basic idea of one cycle control. the simulation results show that the amplifier of improved control circuit not only solve the question of output dc offset, but also keep the voltage gain lowered by voltage compensation technique

    最後，根據單周控制的基本思路，改進了單周控制的全橋開關功率放大器的控制電路。模擬結果表明，改進控制電路后的系統不但解決了輸出直流偏置問題，而且解決了電壓補償方法所造成的放大器增益下降問題。
  3. ( 3 ) modeling of the asymmetrical half bridge converter in the thesis, a small average circuit model of asymmetrical half bridge converter power stage is established by method of state space averaging. in term of it, a system model of total converter is founded. the characteristic of stabilization and dynamic is analysed and the compensator is designed basing of it

    （ 3 ）不對稱半橋dc dc變換器的建模分析採用狀態空間平均法建立了不對稱半橋變換器功率級的小信號平均電路模型，在此基礎上建立整個變換器系統模型，對系統的動態特性和穩定性進行了分析並設計了補償器。
  4. This modeling method is applicable to most of facts and hvdc devices, not only to those devices including thyristor - controlled reactor ( tcr ), such as thyristor - controlled series capacitor ( tcsc ) and static var compensator ( svc ), but also to those devices including converter bridge, such as hvdc device and static synchronous compenstor ( statcom ), etc. it deduces the mathematical models of tcsc, hvdc, svc and statcom devices with the proposed method

    該方法能適用於大多數facts裝置和hvdc裝置，不僅可用於含有晶閘管可控電抗器（ tcr ）元件的裝置如可控串聯電容補償（ tcsc ） 、靜止無功補償器（ svc ）等的建模，也可用於含換流橋的裝置如hvdc裝置、靜止同步補償器（ statcom ）等的建模。本論文採用動態相量法建立了tcsc 、 svc 、 hvdc及statcom裝置的數學模型。
  5. As an example, the paper presents the design of static adjustable reactive compensation with step - down transformer for ying shuiqiao traction substation ( tsc ), the design of the over compensatuion of dynaminc state imbibe system during no travelling crane ( tsr ), it did synthesis optimize of the mostly equipments " technology parameter, at the same time did the analysis and evaluation in the base of colligate control strategy using computer emulate

    在對包蘭線的迎水橋變電所進行了模擬試驗的基礎上，制定了綜合控制策略，把裝置實際應用於該變電所，裝置的實際運行情況表明：補償效果好，功率因數提高到0 . 94 。
  6. A resolution method in software is applied to calibrate zero point and full scale of the circuit. software approach to nonlinear correction for sensor and circuit is presented. therefore system error is eliminated, and measurement accuracy of temperature is improved. the signal of acidity electrode is detected by a differential amplifier circuit, which consists of operational amplifiers tlc2254 with high input impedance and low drift

    採用橋路和單運放差動放大電路對溫度傳感器信號檢測放大，軟體校正溫度傳感器和測量電路的非線性，軟體校準測量電路的零點和滿度，消除測量電路的系統誤差，提高補償溫度的測量精度；採用高阻、低漂移運放tlc2254組成高阻差動放大電路用於酸度電極信號測量。
  7. The main contents to be studied and solved are shown as follows : designing scheme of the error compensation system, studying and designing the signal conditioning circuit, designing the data - acquisition circuit, designing and realizing the max1457 software development system. the compensating circuit is designed in virtue of the signal conditioning chip max1457 as its core. the data - acquisition circuit is designed in virtue

    硬體方面，根據總體方案設計了以信號調理晶元max1457為核心的補償電路;以max1401為核心的數據採集電路，用來採集傳感器的電橋電壓和max1457輸出電壓;設計了max1457電源電路， max1457的電源電壓是失調dac和靈敏度dac的參考電壓，採用了ad586給max1457提供精密5v電源電壓。
分享友人
分享到 Line

分享到臉書