觸發調壓器 的英文怎麼說

中文拼音 [chùfādiàoyāqì]
觸發調壓器 英文
varitran
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 發 : 名詞（頭發） hair
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 壓 : 壓構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 觸發 : detonate by contact; touch off; trigger; strike
  1. The modulating signals of firing delay angle at the rectifier and firing lead angle at the inverter, and the excitation voltage are chosen to be control variables. the offset of the current of dc line and the extinction angle and the power angle of generator are chosen to be control outputs. then a nonlinear controller is designed for the system under study according to direct feedback linearization theory

    以整流側觸發延遲角的調節信號、逆變側觸發超前角的調節信號以及發電機勵磁電壓作為控制變量，以直流線路電流、逆變側關斷角以及發電機功角的偏移量作為目標輸出，用直接反饋線性化方法設計了系統的非線性控制器。
  2. In the paper, on the basis of research of static state and transient state in the scr and series connection valve circuit, the high voltage scr changing current valve device has been developed for ac - dc - ac high voltage commutatorless motor. the series connection valve circuit has been designed and simulated. the hardware design and software programming of trigger pulse system and monitoring system in the photo - electronic - photo fashion has been completed

    無換向器電動機在火電廠等工礦企業的電機調速節能領域中有十分廣闊的應用前景，本文在對晶閘管元件和串聯閥電路的靜態特性和動態特性研究的基礎上，研製了用於交直交電流型高壓無換向器電動機的高壓晶閘管換流閥裝置，進行了串聯閥電路的設計和模擬，完成了電光電方式的觸發脈沖系統和監測系統硬體設計及軟體編程，並進行了裝置的實驗調試。
  3. Voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  4. Abstract : voltage segment network constituted by electron switch of bta and controlled by single chip microcomputer constitutes a new fast electronic regulator. for bta cross zero touch off, sine wave which is exported is integrity. a new way to generate stable ac current is found with feed back control system by single chip microcomputer. so a new high power ac current regulator is developed

    文摘:採用單片機控制雙向可控硅作為電子開關所組成的電壓分節網路，組成新穎快速的電子調壓器；由於雙向可控硅過零觸發，所以其輸出是不失真的完整正弦波；再用單片機組成反饋控制系統，從而找到了交流穩流的新方法，研製出一個大功率交流穩流電源
  5. The technology of alternating - current - boosting by way of constant current is successfully used to charge capacitors with 25 kilojoules of energy in only eight seconds. rail - gap switch with performances of long life and highly steady state are designed. and the high voltage pulse generator, which can produce low - excursion and fast - rise pulses, are designed by using double trigger circuit and hydro - thyristor as switch

    在大功率恆流充電技術上，成功的應用了交流調壓式恆流技術，可以在8s內讓電容器儲存25kj的能量;設計出了長壽命、高穩定的軌道開關;採用氫閘流管做開關，使用雙觸發電路，研製出了低抖動、快前沿的高壓脈沖發生器（點火機） ;採用單片機和pld ，研製出了精度為10ns的延時同步機。
  6. Divider, coaxial line, trigger, signal processing, data acquisition, acquisition control and waveform analysis software is included in the device. when the device operate in the system, overvoltage is transferred to coaxial line by the divider. if the overvoltage amplitude is higher than initialization value, data acqusition card start sampling. when sampling is over, computer save data to file. engineer can analyse parameter of waveform by appropriative software reading data from file

    當裝置在線運行時，系統中出現的過電壓信號通過分壓器傳遞到同軸電纜，通過觸發電路判斷，如果大於預先設定的值則啟動採集卡的同時采樣，采樣結束后，計算機把數據存盤並以文件格式保存，管理人員隨時通過調用專用軟體調取文件進行各種參數分析。
  7. Overvoltage amplitude is higher than initialization value, data acqusition card start sampling. when sampling is over, computer save data to file. engineer can analyse parameter of waveform by appropriative software reading data from file. in the trial measurement, the device shows good performance. simulant trial and actual result indicate that method in the paper acquire approving effect, and the device can be used in the lokv distribution network

    當裝置在線運行時，系統中出現的過電壓信號通過分壓器傳遞到同軸電纜，通過觸發電路判斷，如果大於預先設定的值則啟動採集卡的同時采樣，采樣結束后，計算機把數據存盤並以文件格式保存，管理人員隨時通過調用專用軟體調取文件進行各種參數分析。
  8. On the base of widely investigating and researching, author deems that the conventional reactive power compensation devices used by consumer had many defects with among others : lower response time, remaining residual voltage on the compensation capacitors, and so on. because of existing improper trigging time, it is impossible to realizing balance compensation for 3 - phrase unbalance loads

    本文在充分調研的基礎上，認為目前採用的傳統的無功功率補償裝置存在響應速度慢、觸發時刻不合適、補償電容器上有殘壓、不能實行三相平衡補償、對電網產生污染、不能消除負荷本身產生的高次諧波等弊病。
  9. Temperature kits : contact must be properly fixed in the evaporator export pipelines, real - time communication evaporator components to temperature degrees, the material will be filled through interlinked capillary pressure due to the expansion of corrugated boxes ; swelling corrugated boxes on the pressure for change in the thrust pole with an adjustment screw and spring - loaded ball - type valves to adjust the resistance of the degrees of refrigeration volume precision adjustments

    感溫包：是必須妥善接觸固定在蒸發器的出口管道上，感知蒸發器實時回氣溫度的部件，它將充填物質的熱脹冷縮壓力通過相通的毛細管提供給膨脹波紋箱；膨脹波紋箱依據壓力的變化推動推力桿結合過熱度調整螺絲和彈簧的阻力來調整球型閥的開度，實現製冷量的精確調整。
  10. The main circuit is consisted of 18 thyristors circuit and protection circuit. with the help of control subsystem, it can get the output of low frequency voltage ( current ) with the shape of sine wave ; the core of the control subsystem is the cpu of 87c196kc, and the synchronization circuit, the pulse - widen circuit, and the power - enlarged circuit form the accessorial subsystem of the control system. it possesses all the functions of digital triggering, digital tuning, analog / digital conversion ; the input transfer can isolate the input and output ; and the circumfluence reactor can reduce the circumfluence

    主迴路採用由18個晶閘管組成的三相零式電路，並輔以晶閘管的保護電路，通過控制可以得到低頻正弦波的電壓（電流）輸出；控制迴路主要以87c196kccpu為核心，其外圍電路包括同步電路，脈沖拓寬電路，功率放大驅動電路等，完成了數字觸發、數字調節、模數轉換等功能；進線電源變壓器具有變壓和隔離作用；環流電抗器則實現了有效抑制主迴路瞬時脈動環流的功能。
  11. The control circuit of digitalized soft - starter with the three - phase ac voltage regulating was designed. the digital phase shifting trigger based on the 80c196kc mcs and gal16v8 programmable device was developed. the control method for digital phase shifting trigger was given and its principle of operation and designing was discussed

    設計了三相晶閘管交流調壓數字軟起動器的硬體控制電路；研製了採用80c196kc單片機和gal16v8可編程器件構成的數字移相觸發系統；給出了數字移相觸發控制方法，分析和討論了該方法的工作和設計原理；採用了一種參數自整定的混合型模糊pid控制方法。
  12. Manufacturer of electrical panel control components, industrial plugs and sockets, ac solenoids, buzzers, and other power and electromechanical components

    -專業研發生產固態繼電器固態調壓模塊固態調壓器整流模塊可控硅移相觸發器變頻調速器的廠家。
  13. With the strong dsp as the control unit, the design of main circuit structure is provided, and the control policy for the main circuit loop, the tuning of the triggering angle for thyristor are given

    在具體的系統實現中，變換器主迴路選擇環流控制方式，採用高性能dsp作為模糊控制核心，通過加權平均判決的模糊決策演算法對變換器主迴路晶閘管的觸發角進行調制，從而有效控制輸出電壓波形。
  14. It emphases the selection of secondary voltage of the step - down transformer, the control and protection of thyristor, the calculation of compensation capability and group capability, the technique of cross - zero switched on / off capacitors or reactor, the solution of avoiding possible resonance in switching on / off groups of capacitors or reactor and the measure of the best time to switch ( including the design of the computer survey and control system, instrument deliver system, delay operate and protect system ). although thyristor as a no - contact switch can avoid almost the problem of contact switch with contact, it can not solve the over - voltage, over - current and transient process itself as switching on / off capacitors or reactor. so we must develop a set of thyristor - switched control and protect system with great reliability so that it can realize of cross - zero switching on / off capacitors or reactor at any time

    晶閘管具有過零、動作快速的特點，本研究以晶閘管為電容器和電抗器的分組投切開關，重點研究了協調變壓器二次電壓的選擇、晶閘管觸發控制及保護、動態補償容量及分組容量的計算確定、過零投切電容器和電抗器技術的實現、以及分組投切電容器和電抗器可能發生諧振的處理計算方法，給出實現最佳補償投切選擇方法（測控系統、儀表變送系統、操作和保護系統的設計步驟） ，研製了一套高可靠性晶閘管觸發控制及保護系統，實現對無功的靜止可調補償。
分享友人
分享到 Line

分享到臉書