試驗電壓 的英文怎麼說

中文拼音 [shìyàndiàn]
試驗電壓 英文
experimental voltage
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 壓構詞成分。
  • 試驗 : trial; experiment; test
  • 電壓 : voltage; electric tension; electric voltage
  1. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、氣強度、絕緣阻、接地連續性、泄漏流、微波泄漏、功率、溫升、濕熱、灼熱絲、水平燃燒、垂直燃燒、漏起痕、球、防雨淋、防濺水、粉塵、鹽霧、耐久性(壽命)機負載源線彎折、源線提拉、拉扭力測、燈頭互換性、安全結構檢查等。
  2. For the circuit - breakers of rated voltage 252kv up, the synthetic test methods are introduced according now condition because of the limitation of the transformer short - circuit capacity. the correlative prescribes on switching line - charging current in gb / t1984 - 200x " alternating - current high - voltage circuit - breaker " are discussed according to the test results and theoretic analysis

    由於開合空載架空線路源側的阻抗有明確的規定,這就要求源必須具有足夠大的短路容量,實室很難滿足要求,因此,一般對較高等級的斷路器採用合成方法,本文介紹了利用現有條件,對252kv以上等級的斷路器採用合成時的線路。
  3. Research on the dissipation factor measurement technique for the variable frequency test

    變頻諧振試驗電壓下介質損耗測量技術研究
  4. Specimen dimensions and procedure for shear testing resistance spot and embcossed projection welded joints

    剪切阻點焊和印凸焊焊接點的樣品尺寸和抽樣程序
  5. Electric cables - voltage levels for spark testing

    纜.火花試驗電壓
  6. 2 for an impulse source there shall be a peak reading instrument voltmeter connected directly to the electrode head, indicating continually the potential of the electrode with or without a grounded test wire in the chamber

    脈沖火花機,表直接接在極上,顯示的是測線沒有接地的情況下的峰值
  7. Guide for methods of power factor measurement for low - voltage inductive test circuits

    路功率因數的測量方法指南
  8. A motor that is be directly coupled to a fan - blade or blower - wheel load is to be operated at the applicable test voltage and under no - fan, no - load conditions with the shaft running free

    直接耦合到一個風扇葉片或鼓風機葉輪負荷的馬達,將在適用的試驗電壓下做無風扇,無負荷,軸空轉狀態的運行。
  9. The main contributions to the study on the flashover of insulators in vacuum are as follows : 1. a set of test system for the studies on flashover of insulators in vacuum has been developed, which consists of vacuum system, electrode system, e - dot pulse voltage measurement system, surface charge measurement system, current monitor system and luminescence signal measurement system

    本文主要完成了以下工作: 1 .通過設計加工真空及極系統,研製e - dot沖擊測量系統、真空中表面荷測量系統、沖擊流和表面微弱光信號測量系統,建成了國內第一套用於研究真空中絕緣子沿面閃絡現象的平臺。
  10. Under the test conditions of ud = 2800v and 350hz switching frequency, the current in three phase inverting test reached to loooar. m. s, which can fully meet the requirements of 350km / h emu with 2600v link voltage and 950ar

    在中間直流環節u _ d = 2800v ,開關頻率為350hz的條件下,逆變的流達到了1000ar . m . s ,完全能夠滿足350km h高速動車組對變流器中間2600v 、輸出流為950ar . m . s的要求,表明了地面機組的研究獲得了成功。
  11. The existence of air gaps will inevitably distort strongly electrical field distribution and cause to a significant voltage drop across the gap, which causes severely non - uniform electrical field near the icicle top

    運行和研究表明,絕緣子串在運行試驗電壓下覆冰時其高端總是存在空氣間隙。
  12. This paper introduce, now in electrical system, the high - voltage tests include part - charge test for transformer, ac withstand voltage test for transformer, ac withstand voltage test for switch, ac withstand voltage test for hv cable, when the tests is on, the power sup - - ply will be too poor

    文中就當前力系統中的一些現場高所面臨的源問題,這些包括變器的局部放和交流耐、高開關、高交聯纜、 gis等的交流耐,提出採用新型變頻源對高設備進行測
  13. It compares and analyses the equipment test voltage emendated to standard atmosphere conditions with the equipment nominal withstanding voltage. and then it concluded that : the emendation value educed by " humidity ratio " integrated emendation method is basically equal or close to the equipment nominal withstanding voltage ; but the values by two traditional emendation methods are mostly higher. it also proves that, " humidity ratio " integrated emendation method is more perfect than any other methods, and it can reflect the influence degree of atmospheric parameters on electrical equipment outer insulation discharge voltage actually

    文中選擇「比濕」綜合校正法和兩種傳統校正法,分別對西高所為羊八井、拉薩、羊湖110kv變所設備所做的人工氣候室模擬數據及雲南中所做的zs - 110工頻放數據進行校正計算,將試驗電壓的校正值與設備的標稱耐受水平進行比較分析;認為: 「比濕」綜合校正法的校正值與設備耐受水平基本相等或接近,而兩傳統校正法的校正值大多高於設備耐受水平;進一步證明, 「比濕」綜合校正法是目前諸多校正法中較為完善的,能真實地反映大氣參數對氣設備外絕緣放的影響程度的校正法,在高海拔力工程設計中應推廣應用。
  14. Test voltage terminal to case : 2000vac for 60s

    額定流的130 %試驗電壓
  15. Nominal voltages and test voltages for automotive electric equipments

    汽車氣裝置的標稱試驗電壓
  16. Insulating test voltage

    絕緣試驗電壓
  17. Rated capacitance : f - 50f

    試驗電壓
  18. Test methods for determining electrical properties of electric cables and wires. determining insulation resistance. voltmeter - ammeter method

    性能方法絕緣試驗電壓-流法
  19. The technology of research include following. the computer order control to attain testing condition of relay ' s turn - on and off. to control of testing ac voltage by adoption of advance control strategy

    測控技術包括:實現模擬繼器接通與分斷負載條件的順序控制技術;採用先進控制策略的試驗電壓控制技術;參數檢測技術;參數波形的實時顯示技術;以dsp (數字信號處理器)為核心的數據高速採集技術。
  20. On the base of the iec standard of dc suspension insulators, we designed a new ion migration test for 500kv dc ceramic support insulators, including the regulation between the bulk resistance and the temperature, the test samples, the test voltage and the temperature for long - term ion migration test, and the amount of accumulative charges

    以懸式絕緣子離子遷移標準為基礎,完整的設計了500kv直流支柱式瓷絕緣子離子遷移,其中包括研究了品體積阻隨溫度場強變化的規律,成功的設計了品,確定了長期離子遷移試驗電壓( 40kv )和溫度( 130 ) ,計算了50年累計荷量( 0 . 173c ) 。
分享友人