試驗頻率 的英文怎麼說
中文拼音 [shìyànbīnlǜ]
試驗頻率
英文
test frequency-
First, the theory of fretting wear and studies on fretting fatigue were introduced and the parametric method was used in the process of creating the model of dovetail joints in ug software. the elastic contact problem is analyzed in finite element method ( fem ) and is used to the parameters " distribution and contact stress of the joint are obtained on the base of ansys code. with the effect factor of load frequency, the prediction method of fretting fatigue life of dovetail joint under low and high / low cycle complex load is proposed
本文介紹了微動損傷的機理和微動疲勞壽命的研究方法；利用ug軟體對燕尾榫聯接結構創建了參數化實體模型；基於ansys軟體平臺求解彈性接觸問題，獲得了榫聯接結構接觸應力及接觸狀態量的分佈；在已有微動疲勞壽命預測模型的基礎上，引入載荷頻率影響因子，對低周、高低周復合載荷作用下的燕尾榫聯接結構進行了微動疲勞壽命的預測，與試驗結果對比表明採用本文提出的方法預測榫聯接結構的微動疲勞壽命是有效的。By making some assumptions, collision frequency were presented. then the the flocculation kinetics model was established through population balance equation. comparison of experimental data and modeling results indicate that there are the same trend between the two. so the model can predict floes number and size during flocculation of yellow river ' s loess particles without using empirical parameters. the tem and sem were used to obsever floes in the study of floe structure. the flocculation was divided as flocculi, floc and floe aggregate. the floes structure model was established by assumption that particles position in floe accords with tetrahedron. the fractal dimension of model and experimental floes was found to be coincidentso the model can reflect the structure of flocs formed in flocculation of yellow river ' s loess particles by macromolecule flocculant at a certain extent
最後，本文還對絮凝動力學和絮體結構進行了研究，在前人研究的基礎上，針對高分子絮凝黃河泥沙，對絮凝過程作了一些符合試驗條件的假設，建立了顆粒碰撞頻率表達式，應用了顆粒數量平衡方程，從而建立了絮凝過程的動力學生長模型，模型計算結果與試驗數據對比表明，二者趨勢一致，在沒有使用經驗參數的情況下基本上能夠描述黃河泥沙絮凝過程中絮體數量和尺寸分佈的變化過程；對絮體結構的研究中，應用掃描電子顯微鏡和透射電子顯微鏡對絮體進行了觀察，將絮體分為絮粒、絮團和絮網三個不同的生長階段，通過假設顆粒結合位置符西安建築科技大學博士學位論文合正四面體，建立了絮體結構模型，計算得到的模型絮體分形維數基本與試驗中的實際絮體相符，在一定程度上能夠反映高分子絮凝黃河泥沙生成的絮體結構。Test method for moduli of elasticity and fundamental frequencies of carbon and graphite materials by sonic resonance
用音響共振法測定炭精和石墨的彈性模量與基本頻率的試驗方法The experiment apparatus has been developed, which is based on software ( labview ) and hardware ( pci board ni 6024e ). the displacements and generative force at the tip of the ipmc actuators were measured with respect to the different voltages, frequents and various waveforms which include square, sinusoidal, and triangular wave
實驗選取了不同電壓幅值，不同頻率的方波、三角波、正弦波三種波形作為電激勵信號，利用高速攝像記錄ipmc的位移變形，並通過力傳感器實測了ipmc試樣末端的輸出力。Test method for measuring relative complex permittivity and magnetic permeability of solid materials at microwave frequencies
測量微波頻率下固體材料相對復合電容率和磁導率的試驗方法Standard test method for measuring relative complex permittivity and relative magnetic permeability of solid materials at microwave frequencies
微波頻率下固體材料相對復介電常數和磁導率測量標準試驗方法The test result also displays that sometimes the normal vibration associated with squeal firstly occurs prior to the tangential vibration. the tangential vibration does not occur until the normal vibration gets stronger
試驗發現，有時發射摩擦噪聲的振動首先在法向出現，當這個法向振動比較強時，相同或相近頻率的切向振動才發生。Surface transverse wave has the 1. 6 high frequency than rayleigh type surface acoustic wave ( using the same technology the frequency of devices of stw has about 1. 6 high frequency than rayleigh type surface acoustic wave ). the paper introduces the theory, design parament, technology and result expeiment of surface acoustic wave ( includes rayleigh surface acoustic wave and surface transverse wave, simple stw ) with low insertion loss, high q and researches the high frequency, low phase noise oscillator with 1ghz stw resonator as frequency element. and describes measurement method and finally experimantal result of the low phase noise surface acoustic wave oscillator
本文研究了以低損耗、高q值聲表面波（其中包括聲表面瑞利波- - rayleighsurfaceacousticwave ，和聲表面橫波等）諧振器的工作原理、設計參數、製作工藝及其實驗結果，並且研究了以1ghzstw諧振器為頻控元件的高頻率、低相位噪聲聲表面波振蕩器，以及低相位噪聲聲表面波振蕩器的測試方法和最終的測試結果。The test proves that the caudal fin oscillation frequency, the maximum amplitude of vibration of caudal fin, the caudal fin strikes the water angle influence the fish ’ s speed ; the curve experiment has obtained curve radius of inertia advance curve and static curve ; the ups and downs experiment proves that the pectoral fin on different angle influences the fish to move ups and downs
加減速試驗論證了尾鰭擺動頻率、尾鰭后緣最大擺幅以及尾鰭的最大擊水角度對魚體速度的影響;轉彎試驗測得了機器魚慣性前進轉彎和靜止轉彎時的轉彎半徑;在機器魚的升潛試驗中論證了胸鰭不同轉角對升潛運動的影響。The key components in laser gyro is he - ne ring laser, and the reciprocal action theory between light and medium is the base in studying the ring laser, use the lamb half classical theory, and on the base of density matrix theory, the optical brounch equation was established, which described the movement of amplifying medium atom in the ring syntonic cavity, and according to the medium polarize theory the self consistent equations was deduced, which describe the light intensity and phasic of the counter - propagating wave. on the basis of this equations, adopted the simulation software matlab and virtual instrument programming language labwindows / cvi, we can do some simulated experiments in study the phenomenas such as amplify and dispersive characteristic of medium, mode pushing effection, burned hole effection and pattern competition, lock - in of frequency and the characteristic of light intensity and phasic of the counter - propagating wave in laser gyro
激光陀螺的核心部件為he - ne環形激光器，而掌握光與介質的相互作用理論是研究激光器的關鍵，採用拉姆半經典理論為主，在密度矩陣理論的基礎上，推導環形諧振腔中描述he - ne氣體增益介質原子運動的光學布洛赫方程，運用介質極化理論得出描述激光陀螺反向行波的光強、位相所滿足的自洽場方程組，在此基礎上，運用matlab模擬軟體和虛擬儀器編程語言labwindows / cvi ，對激光陀螺中的介質增益色散特性、頻率牽引效應、燒孔效應及模競爭、閉鎖效應及環激光的光強和相位特性進行模擬試驗研究，並且運用全量子理論，對激光工作原理進行分析，得出二能級系統單模輻射場的光子數密度分佈，得出激光場的光子統計分佈，模擬激光場的動態建立過程。Calibration of vibration and shock pick - ups - method of test for resonance frequency of undamped accelerometers on a steel block
振動和沖擊傳感器的校準.鋼鑄錠無阻尼加速度計共振頻率的試驗方法Standard test method for impedance and absorption of acoustical materials using a tube, two microphones, and a digital frequency analysis system
管子雙擴音器和數字頻率分析系統用傳聲材料的阻抗和吸收的試驗方法In order to ascertain the character of cable - replaced bridge, in addition, the thesis calculates mode shapes and natural frequencies of the bridge using algor software and estimates the result of dynamic load test and calculation in details
為了評價換索后橋梁的工作特性，最後利用algor軟體對換索后的結構進行了振型和自振頻率分析，並對動載試驗檢測和計算成果作了詳盡的分析和評價。Realization of appdomain - based fast data reading technology
預應力梁固有頻率的試驗研究Second, we optimize the codebook and choice a part of the codeword which is used most efficiently. the result is not degraded too much while the complexity is reduced. at the end of the paper the development prospect of cs - acelp and speech coding are described
對lsp參數量化中的第一級碼書的128個碼字的使用頻率進行了統計試驗，選用了128個碼字中使用頻率高的112個碼字作為新碼書，語音質量基本不變但降低了碼書搜索的復雜度。I turns out to be that the position and degree of damage can not be well detected only by eigenfrequency, while only can detect if the damage has appeared. however, severe damage can be diagnosed if the modal shape and natural period are used
利用以上指標對試驗構件的損傷進行識別與定位，研究結果表明，僅憑獲取的固有頻率不能準確判斷結構構件的損傷狀態及損傷位置，只能初步判斷結構中是否出現損傷。Line frequency and voltage tests for electronic measuring instruments
電源頻率與電壓試驗Through studying the working mechanism of the composing, the paper referred the bearing ' s analyzing model and designing flow. through shearing test of high damping rubber, the paper analyzes the influence of shearing shape, shearing strain range and inspiriting frequence on the characteristic parameters ( dynamic shear elastic module, dissipation engineering module, wasted gene ). according to the rule of equivalent energy, the paper gets the hysteretic curve of hdr ' s equivalent bilinear model and parameters ' calculating formula
本論文通過對這種分離式減震支座各組成部分工作機理的研究，提出了該分離式減震支座整體的計算分析方法和設計流程；通過高阻尼橡膠剪切試驗，分析了高阻尼橡膠剪切面形狀、剪應變幅值、激勵頻率和試件高度對特徵參數（動態剪切彈性模量、耗能模量、損耗因子）的影響。In the former, two computing modes of fem are built, aimed at the coupling of variable - profile pylon, curved - axis arch and flexible cable. the software algor feas is used to get the results of dynamic numerical analysis, such as natural vibration frequency, vibration mode, dynamic displacement, dynamic stress, which are compared with the results of shaking table test research to draw to important conclusions. these conclusions provide not only potent basis for the design and construction of nanjing century tower, but also reference for other pylon - cable - arch structures similar to the project
在動態數值分析中，針對世紀塔變截面的塔身，曲線軸線的拱以及柔性拉索相互耦合時清況，建立兩種有限元計算模式，利用有限元軟體algorfeas得到動力數值分析的結果，如：自振頻率、振型、動位移、動應力等等，再和振動臺試驗研究成果作比較，得到一些重要的結論，從而為南京世紀塔工程的設計和施工提供強有力的依據，而且為類以於世紀塔工程的其它塔-索-拱結構的設計也提供一定的參考。Based on that penetration depth of eddy current is theoretically different for different operationalfrequency, the flaw depth quantitive measurement method based on the characteristicalfrequency was expounded. to find the best testing model and position, it analysed and discussedthe factors which effected measurement. the mathematic relationship between the specialfrequencyand flaw depth was established to realize the accureate measurement of flaw depth. it primarily researched the technology of alternating current magnetic field leakage testing ( ac - mfl ) in our country
在利用頻率掃描技術的基礎上，提出了基於拐點頻率的渦流檢測缺陷深度測量方法，對影響測量的多種因素進行了分析和實驗研究，得到了最佳的測試位置和測試方法，建立了拐點頻率和缺陷深度的定量關系，為深度的測量提供了新的途徑。分享友人