諧振式調壓器 的英文怎麼說

中文拼音 [xiézhènshìdiàoyāqì]
諧振式調壓器 英文
resonance type voltage regulator
  • 諧 : Ⅰ形容詞1 （和諧） in harmony; in accord; in tune 2 （詼諧） humorous Ⅱ動詞（商量好; 辦妥） come t...
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 式 : 名詞1 （樣式） type; style 2 （格式） pattern; form 3 （儀式; 典禮） ceremony; ritual 4 （自然科...
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 壓 : 壓構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. Firstly. operation principle of induction heating is introduced and the actuality of the power supply for induction heating is summarized. then, the scheme of structure of the power supply is established : uncontrolled rectifier and buck chopper constitute dc circuit. in this part, operation principle of a kind of soft switching buck chopper is presented mainly and the conclusion that the power semiconductor devices operate in soft switching is also illustrated by analysing the operation principle of all stages ; series resonant inverter is selected as inverter circuit via comparing the advantage and shortcoming of parallel resonant and series resonant. moreover. the work principle of series resonant inverter is analysed and the calculating method of the best dead time is put forward as well

    文中首先介紹了感應加熱電源的工作原理並綜述了國內外的研究現狀。接下來分析並制定了電源主電路的構成方案：在對比幾種功率調節方式的基礎上選擇了不控整流加斬波調壓作為直流部分。在這部分里，重點研究了一種軟開關buck變換器，通過分析各階段的工作原理說明了開關器件如何工作在軟開關狀態；對于逆變器部分，在比較了串、並聯逆變器優缺點的基礎上選擇了串聯諧振逆變器，並詳細分析了串聯逆變器的工作原理，提出了最佳死區的計算方法。
  2. In the second chapter, equivalent circuit of the eddy current sensor is firstly analyzed. based on that, the carrier signal generating circuit that is realized by the lc periodic circuit is introduced, thus, the carrier signal of standard frequency is obtained through the trimming capacity. subsequently, the disc type rotational armature generator and the rotational coupling transformer are separately leaded in to realize the power supplies of the carrier signal generating circuit and output of the measuring signal

    在傳感器設計一章中，首先對渦流傳感器進行等效電路分析，在此基礎上分析了由電感、電容諧振電路構成的載波信號發生電路，並通過微調電容獲得了標準頻率的載波信號；接下來提出了採用盤式旋轉電樞發電機解決載波信號發生電路電源供給問題的方案，同時通過旋轉耦合變壓器的引入，使得測量信號輸出問題很好地解決；本章最後給出的一組實驗曲線充分說明了這一方案的可實現性。
  3. The main ideas of the thesis and the contributions to the resonant dc - link area are also listed in this chapter. a novel control strategy for the two - amplitude actively clamped resonant dc - link is proposed in chapter ii. it neglects the bus short circuit time adjuster and stabilizes the clamping voltage by a pi regulator so that the obtained link frequency is improved and the link losses are greatly reduced

    第二章針對雙幅控制技術在單相橋式電壓源逆變器中的應用為範例進行研究，提出了直流母線無短路控制和通過pi調節環穩定箝位電壓的雙幅諧振控制策略，進一步提高了母線振蕩頻率，減少了直流環節損耗。
  4. This paper realized frequency modulation using the video signal to directly control the resonance loop ' s diode of the vco at the early stages, and then through using radio frequency bipolar junction transistor, designed a lc voltage controlled oscillator which was emulated by advance design system. in addition, it also implemented the design and debugged the hardware circuit

    本文第一次實驗採用視頻信號直接控制vco諧振迴路變容二極體的方式實現頻率調制，並且利用射頻雙極性晶體管（ bjt ）設計了一種lc壓控振蕩器，通過ads軟體進行了參數模擬，最後進行了硬體電路的製作和調試。
分享友人
分享到 Line

分享到臉書