諧振電子管 的英文怎麼說

中文拼音 [xiézhèndiànziguǎn]
諧振電子管 英文
resonator-tron
  • 諧 : Ⅰ形容詞1 （和諧） in harmony; in accord; in tune 2 （詼諧） humorous Ⅱ動詞（商量好; 辦妥） come t...
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 電子 : [物理學] [電學] electron
  1. The detail study on the interaction between the electron beam and standing wave of complex cavity gyrotron with gradual transition and gyroklystron has been done in this dissertation, supported by the pre - study important items " the study on 8mm third harmonic gyrotron with a permanent magnet system " and " the study on 8mm high power gyroklystron ". the main works of this dissertation are listed as following : 1. the study on the rf distribution of the complex cavity with gradual transition is presented, in which the multi - modes coupling are taken into account

    本論文就是結合該課題組的「九?五」重點項目「 8mm三次諧波永磁包裝迴旋管技術的研究」及「十?五」重點項目「 8mm高功率迴旋速調管技術的研究」 ，對以諧振腔為互作用高頻系統的迴旋脈塞器件中兩種典型的器件? ?迴旋振蕩管及迴旋速調管中電子注與駐波場的互作用進行了深入細致的探討和研究，其中迴旋振蕩管採用的是漸變復合腔。
  2. The basic principle, main properties, typical parameters, technical characteristics and general situation of klystron are introduced. the electron beam prebunching in the modulated cavity and shift tube of relativistic klystron amplifer ( rka ) is studied analytically, a self - consistent equation of radiation generated by the prebunched electron beam in the radiation cavity is derived using the field method of particle ? wave interaction instead of the electrical circuit method, and in terms of it, the gain in the linear regime calculated, a field analysis method is proposed. the theory analysis shows that the characteristic parameters, such as resonance frequency, real part of gap - impedance, external quality fadtor in all kinds of klystron output circuits including single - beam, multi - beam, single - gap, multi - gap, single - beammulti - gap, multi - beam multi - gap klystron output circuit, can be calculated by the field analysis method

    本文系統的介紹了速調管的工作原理、主要特點、發展概況、主要性能指標和技術特點，解析的研究了電子束在相對論速調管放大器的調制腔和漂移管中的預群聚;用粒子波互作用的場方法導出了在輻射腔中預群聚電子束產生輻射的自洽方程，同時對線性區的增益進行了計算。理論分析表明，場分析法可用於計算單注單間隙、多注多間隙、單注多間隙和多注多間隙速調管輸出迴路的諧振頻率、間隙阻抗實部和外觀品質因數等特性參數。
  3. A fem software as an important tool, work has been done as follows : the method using fem to design anomalous structure of transducers was adopted ; the vibration modes of the elastic pipe, ultrasonic transducers and system has been analyzed in piezoelectric coupled field. resonant frequencies of the transducers have been matched quite well with resonant frequencies of pipe, which can make it easy and accurate to design a transducer. the values of equivalent dynamic capacitors and dynamic inductances of ahead nine orders have been gotten derived by fem method, and fem equivalent circuit of the transducers has been built

    以ansys有限元軟體為主要分析工具完成了設計工作;在經典換能器設計理論和前人經驗的基礎上，對不規則形狀的換能器採用了有限元的方法設計;在耦合場中分析了換能器、導管及整體裝置的振動情況，使換能器的諧振頻率與導管的諧振頻率達到了較好的匹配，使設計變得更加容易和準確;利用有限元方法建立了振子的等效電路模型，求出了其前6階模態的等效動態電容電感值，為阻抗匹配和驅動電路的設計提供了依據。
  4. The couplers of accelerator structures are important components of electron knear. the efficient delivery of power from rf sources to accelerator structures depends crucially on the coupler cavity. the input coupler cavity is to be well matched, that is to say, it must have proper coupiing. and it must be tuned to the synchronous frequency. in this way, we can obtain the maximum power. in the past, the decision of the coupler cavity dimensions is very difficult

    加速結構的輸入耦合腔是電子直線加速器的重要組成部分。功率從功率源輸送到加速管中，就依賴于輸入耦合腔。輸入耦合腔在整個結構中必須有良好的匹配即有恰當的耦合度，還必須工作在諧振頻率。
分享友人
分享到 Line

分享到臉書