變阻整流器 的英文怎麼說

中文拼音 [biànzǔzhěngliúqì]
變阻整流器 英文
varistor rectifier
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 整 : Ⅰ形容詞1 （全部在內; 完整） whole; all; complete 2 （整齊） neat; tidy; orderly Ⅱ動詞1 （整理; 整...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向流動角度出發，提出了一種lcc諧振型恆頻移相單相高頻鏈逆變電路拓撲，在調制系數0 . 1 m 0 . 5情況下，控制移相角按正弦規律變化，使諧振電壓脈沖列的幅值追蹤參考正弦電壓信號，經過整流、濾波、低頻逆變，從而獲得正弦度較好的輸出電壓。理論分析和實驗結果證明對于阻性負載或阻感性負載，移相全橋具有超前橋臂零電壓開通，滯后橋臂或者零電壓開通（ _ 0 ）或者零電流關斷（ _ 0 ）的軟開關特性，而低頻逆變器的各個開關均實現零電壓條件下的開通與關斷。
  2. According to the request of this subject, we have developed the system hardware and software for the slave device and the inspection software running on the pc. in this paper all of the followings is illustrated detailedly, such as the research on the principles of measurement and its realization, three means of water - level measurement that are separately based on photo electricity coder, pressure sensor and potentiometer ; selection of the microchip, we choose an advanced integrated soc ( system on chip ) microchip c8051f021 as the main controller ; realization of signal sampling, processing and its conversion in the mcu ; application of high precision 16 bits adc cmos chip - - ad7705 in our system, designing its interface with the microchip and relevant program ; using a trickle charge timekeeping chip ds1302 in the system which can provide time norm and designing of its i / o interface and program ; additionally, a 4 ~ 20ma current output channel to provide system check - up using ad421. in the system, ad421, ad7705 and the microchip compose spi bus ; to communicate with the master pc, here we use two ways which are separately rs232 and rs485 ; moreover, there are alarm unit, keyboard unit, power supply inspection unit and voltage norm providing unit in the system

    針對研製任務的要求，課題期間研製了下位機系統硬體和軟體，開發了上位機監控軟體，其中所作的具體工作包括：測量原理的研究和在系統中的實現，在本次設計中用三種方法來進行水位測量，分別是旋轉編碼器法、液位壓力傳感器法和可變電阻器法；主控晶元的選擇，我們選用了高集成度的混合信號系統級晶元c8051f021 ；實現了信號的採集和處理，包括信號的轉換和在單片機內的運算；高集成度16位模數轉換晶元ad7705在系統中的應用，我們完成了它與單片機的介面設計及程序編制任務；精確時鐘晶元ds1302在系統中的應用，在此，我們實現了用單片機的i o口與ds1302的連接和在軟體中對時序的模擬，該晶元的應用給整臺儀器提供了時間基準，方便了儀器的使用；另外，針對研製任務的要求，還給系統加上了一路4 20ma模擬信號電流環的輸出電路來提供系統監測，該部分的實現是通過採用ad421晶元來完成的，本設計中完成了ad421與單片機的spi介面任務，協調了它與ad7705晶元和單片機共同構成的spi總線系統的關系，並完成了程序設計；與上位機的通信介面設計，該部分通過兩種方法實現： rs232通信方式和rs485通信方式；系統設計方面還包括報警電路設計、操作鍵盤設計、電源監控電路設計、電壓基準電路的設計。
  3. The equilibrium current in 24 - pulse traction rectifier system is analyzed. the relation between critical load and resistance of traction rectifier transformer is discussed

    摘要分析了24脈波牽引整流系統中的均衡電流，討論了臨界負載與牽引整流變壓器阻抗參數的關系。
  4. The primary objective of this dissertation is to study the intelligent control, such as the neuro - fuzzy control, for the suspension vibration of a full - vehicle model with four mr dampers installed between the sprung - mass and the four un - sprung masses, respectively

    因此，本文以安裝四個磁流變阻尼器的整車懸架為研究對象，探索以神經模糊控制為主要特徵的智能控制策略。
  5. The dissertation focuses on the semi - active vibration control for the linear suspension of the full - vehicle model in chapter 4. it develops a two - stage control strategy, dividing the full - vehicle suspension and the four mr dampers into two different parts. the upper stage controls the full - vehicle suspension by using the lqg with all the control objectives taken into account and determines the desired restoring

    該方法將多輸入多輸出的非線性系統經過輸出解耦變換，簡化成四個單輸入單輸出的子系統，通過分別對單級anfis模糊系統的離線辨識和在線調整相結合，產生四個磁流變阻尼器所需要的控制電壓，以此對非線性整車懸架系統的實施智能控制。
  6. For region of high resistance, the structure of inside of the archetype of exhaust muffler was adjusted with multi - scheme, but the shape was kept. according to the characteristics of the flow fields, unreasonable structures have been improved to obtain the exhaust muffler with the better performance. the pressure loss of remodelled exhaust muffler was decreased by 27 % as compared with that of original one

    在對原有型式排氣消聲器流場數值模擬結果進行分析后，以消聲器外形結構尺寸保持不變為原則，對其內部局部阻力大的部位進行了多方案的結構調整，確定了排氣消聲器的改進結構，從而得到氣動性能較好的排氣消聲器。
  7. If the speaker needs more current ( its overall impedance drops ) then a lower amplifier output impedance will allow that current to be drawn out of the amplifier without causing much of a change in the applied voltage - and that means less distortion

    如果揚聲器需要更大電流（揚聲器的整體阻抗降低） ，那麼一個低輸出阻抗的放大器可以容許在輸出相應電流的同時，所施加的電壓變化更小，這也意味著失真更小。
  8. If the speaker needs more current ( its overall impedance drops ) then a lower amplifier output impedance will allow that current to be drawn out of the amplifier without causing much of a change in the applied voltage - and that means [ i ] less [ / i ] distortion

    如果揚聲器需要更大電流（揚聲器的整體阻抗降低） ，那麼一個低輸出阻抗的放大器可以容許在輸出相應電流的同時，所施加的電壓變化更小，這也意味著失真更小。
分享友人
分享到 Line

分享到臉書