豎井 的英文怎麼說

中文拼音 [shùjǐng]
豎井 英文
pothole; aven; cenote; silo; well; (vertical) shaft; pit豎井井筒 vertical shaft; 豎井掘進 shaft sinking; 豎井開采礦 shaft mine; 豎井開挖 shaft excavation; 豎井鉆井機 shaft drilling machine
  • : Ⅰ形容詞(跟地面垂直的; 從上到下的) vertical; upright; perpendicular Ⅱ動詞(使物體跟地面垂直) se...
  • : Ⅰ名詞1 (從地面往下鑿成的能取水的深洞) well 2 (形狀像井的東西) sth in the shape of a well 3 (...
  1. Geotechnical investigation and testing - graphical presentation of logs of boreholes, trial pits, shafts and adits

    土工調查和檢驗.礦孔試驗坑豎井和入口測記錄
  2. Shaft sinking - abutment for guide ropes - safety requirements and testing

    豎井.導向鋼絲繩用支座.安全要求和試驗
  3. Dynamic stress computation of hoisting cable in shaft

    豎井提升鋼絲繩動荷應力計算
  4. Shaft sinking - riders for winding kibbles - safety requirements and testing

    豎井.提升吊桶導向架.安全性要求和試驗
  5. The air flows down to a shaft and thus loses potential energy.

    空氣向下進入豎井,因而失去勢能。
  6. Specification for shaft impact pulverizer

    豎井錘擊式磨煤機.技術條件
  7. For laying in doors, in tunnels and in cable trench, able to bare external mechanical forces and certain puling force

    室內、隧道、電纜溝、豎井等能承受機械外力和一定拉力的場所。
  8. Using a vortex - flow drop shaft to convey water from a high level to a diversion runnel under the condition of high water - head and large discharge is a new kind of technology in the scheme of reusing a diversion tunnel as a discharge tunnel

    近年來,為解決高水頭、大流量導流洞改建泄洪洞的技術難題,旋流式豎井泄洪洞逐漸成為研究熱點之一。但迄今為止,該技術尚未得到推廣應用,其主要原因在於人們對豎井螺旋水流運動特徵缺乏足夠的了解和深入的研究。
  9. It runs down a shaft to the seventh floor.

    它沿一個豎井向下直通到第七層。
  10. In this thesis hydraulic experimental studies and theoretical analyses on the vortex - flow drop shaft were conduced and the following results were accomplished : ( 1 ) in the model test some hydraulic characteristics including the shape of air core in the center of the drop shaft, the radial distribution of water flow velocity and the distribution of pressure on the wall of the drop shaft were measured under the condition of high water head above 250m and large discharge above 1400m3 / s. ( 2 ) a kind of computational method for the spiral water flow in the air core region of drop shaft was discussed and applied and the results agree the experimental data well. ( 3 ) the total ratio of energy dissipation in the drop shaft can reach 90 % and the energy dissipation in every region was discussed quantitatively

    本文通過試驗研究與理論分析對旋流式豎井泄洪洞應用於高水頭、大泄流量情況時存在的一些水力學問題進行了研究和探討,取得以下主要成果:一、結合小灣工程導流洞改建,對高水頭( 252m ) 、大泄流量( 1400m ~ 3 s )條件下旋流式豎井中的水流運動特徵進行了比較全面的測量,包括空腔形態、徑向流速分佈及壁壓強等;二、提出了豎井空腔段螺旋水流水力計算方法,其計算結果與實測值吻合良好;三、利用試驗與計算結果,對旋流式豎井的消能機理進行了探討,對豎井各部分的消能能力有了總體認識;四、對豎井下部消力的合理深進行了優化試驗研究,發現消力合理深度為0 . 9d左右;五、通過試驗研究,歸納出豎井水流總摻氣量估算方法,為導流洞排氣方案的設計提供了參考依據;六、在高水頭、大流量條件下,豎井空腔段下部流速很高,盡管水流螺旋運動引起的離心力可以確保壁壓強保持正壓,但空化數依然較低,因此豎井的空化空蝕始終是工程界關注的重大問題。
  11. Delivery points include vertical wells and / or horizontal trenches

    注射點包括豎井和/或水平渠道。
  12. Experiment study on hydraulic condition at the intake of inverted siphon with drop shaft

    豎井式倒虹吸管進水口水力條件的試驗研究
  13. After analyzing the adaptability of molepipe drainage, an underground water table regulation is given out. finally, the efficiency of the drainage technique is determined after its comparison with gutter drainage and vertical drainage, and deep research on the effect of molepipe drainage on water table in a typically selected area

    對暗管排水的適應性進行分析,提出了灌區地下水調控標準,與明溝排水和豎井排灌相比較,對暗管排水典型區調控地下水位的效果進行深入的分析研究,以確定這一排水技術的效果。
  14. Temporary winding change construction of main shaft in huxi coal mine

    湖西煤礦主豎井臨時提絞改裝施工
  15. In order to ensure the safety of engineering, it should be careful to use the test result of normal drilling sampling, the pitting sampling, shaft sampling, or double - tubles and thin - wall soil collecting methods should be used

    為保證工程安全,對常規鉆孔取樣試驗成果的使用應當慎重,對重要工程宜採用探坑、豎井取樣,或採用雙筒薄壁取土技術。
  16. Device model experiments of shaft - well two - direction tubular pumping station

    雙向豎井貫流泵站模型泵裝置模型試驗
  17. Abstract : in this paper, designs for foundation pit drainage, concrete pouring as well as side wall form, etc in shaft well construction are discussed

    文摘:介紹了豎井施工中有關基坑排水、混凝土澆築以及側壁模板等設計問題。
  18. Determination method of shaft centre coordinat

    豎井中心坐標的確定方法
  19. Laying under water in silo or occasions that can

    固定敷設在水下豎井或要求能承受拉力的場所
  20. New methed of quick excavation construction in super - deep shaft

    超深豎井快速掘進施工新方法
分享友人