負載反饋法 的英文怎麼說

中文拼音 [fùzǎifǎnkuìfǎ]
負載反饋法 英文
loading back
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 饋 : 動詞（饋贈） make a present of
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 負載 : [電學] load
  1. Load modulate technology based on sub - carrier wave for fuze setting information feedback

    基於副載波的負載調制技術實現引信感應裝定信息反饋的方法
  2. Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads

    第四章介紹了多執行器復合控制實驗系統和實驗方法；介紹了實驗採用的流量控制的pid演算法；並測定了執行器控制閥和閥芯位移相關的系數；做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗；通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。
  3. As the scheme of packet distributed influence the performance of parallelism, in this paper, the hdw ( hash - based dynamic weight ) scheme for allocation packets in network processors is presented. the scheme is building and keeping one mapping relationship between packets ’ identifier and pes in a table of hash. the mapping formula is derived from the hrw ( highest random weight ) scheme, it is complemented by a feedback control mechanism designed to monitor processor ’ s utilization

    由於報文分配策略影響網路處理器并行性能，我們提出了hdw （ hash - baseddynamicweight ）負載分配演算法，基於報文流標識與pe間建立映射關系，並將映射關系保存在哈希表中，映射關系基於hrw （ highestrandomweight ）演算法，增加了負載反饋迴路監控pe負載狀況，通過動態調整策略阻止pe間負載偏差。
  4. At last this chapter researches two ways that make system performance optimal, test way and pole allocation way. the affections of feedback parameters, air pressure and load quality are analyzed. chapter 5 introduces the theory, application and foreground of the vsc ( variable structure control ) system

    最後一部分研究了實現系統狀態反饋控制的方法，包括試湊法和極點配置法，並分析了各反饋參數、氣源壓力和負載質量對控制性能的影響。
  5. By constructing the necessary condition and sufficient condition for feedback to exist in a circuit, can derive the methods of short circuit or open circuit for the load or the signal source resistance respectively of the feedback network, to analyze the configurations of the negative feedback circuits

    通過構建電路存在反饋的必要條件和充要條件，可引出令反饋電路的負載和信號源內阻分別短路或開路的方法，用於分析負反饋電路的組態。
  6. Its principium is that the receiver feedback a binary bit that indicates the information of overload or under load to the sender, and the sender adjusts the load with aimd algorithm according to the binary information

    其主要原理是接收方反饋一個二進制位的過載或欠載信息，接收方根據此二進制信息，採用線性的加法增加乘法減少演算法調節發送方的負載。
  7. The aimd has got a widely apply for its briefness and ease. at the other hand, it contain limited information because it has only two status : overload or under load. it cannot represent the true demand of the receiver and at the same time the policies of window adjust destroy the demand of smoothness of load, so it cannot afford the request of real - time streaming media

    Aimd從演算法的簡單性和實際網路容易實現的角度考慮，反饋給發送方的信息有限，只有過載或欠載兩種二進制狀態； aimd演算法根據瓶頸資源的擁塞狀態向所有用戶發送相同的反饋信號，並不能真實反映接收節點對發送方負載量的要求;同時， aimd的窗口調整策略破壞了負載平滑性的要求，不能滿足當前實時流媒體應用， aimd的這些不足，體現了一種性能和系統復雜度之間的折衷。
  8. Before the development of the system, the article describes the above - mentioned aspects, as the bases of the system development. the article emphasizes related auto - controlling technologies : open - 100p and close - 100p, and control mode of negative - feedback, the scatter and quantization of the simulate signal, the conception of a / d and d / a conversion and code / encode, the basic sampling principles of the simulate signal. the article introduces the operation method and process of the system by means of the load spectrum

    文章對相關的理論進行了陳述，以作為系統開發的理論依據，重點闡述了自動控制系統中包括開環閉環在內的幾大主要控制模式，以及有關的負反饋控制方式，模擬信號的離散與量化，模數轉換、數模轉換、編碼譯碼的概念，及模擬信號采樣的基本原理? ?采樣定理，並以載荷譜法為例，簡述了所研究的系統將要採取的工作方式及工作過程。
  9. It expounded the research direction of server cluster and e - mail system. the second chapter discussed linux cluster architecture, it analyses ip load balancing technology and schedule algorithm of linux virtual server cluster and presents dynamic - feedback load with balancing scheduling algorithm

    第二部分為linux集群的體系結構，詳細論述了linux虛擬服務器的集群的ip的負載均衡技術和負載聯接調度的演算法，以及新提出的動態反饋負載調度演算法的設計與實現。
  10. This paper, based on analyzing the architecture of linux virtual server cluster, presented a solution of double load balancer based on nat for e - mail system ; based on analyzing scheduling algorithms and the short of linux virtual server cluster, presented a dynamic - feedback load with balancing scheduling algorithm and its implementation. there are five chapters in this paper. the first chapter is the background materials of the research

    本文在對linux虛擬服務器集群體系結構的深入分析和研究的基礎上，針對電子郵件系統提出採用nat方式的雙負載均衡服務器的集群郵件系統的解決方案；在全面分析linux虛擬服務器集群連接調度演算法的基礎上，針對linux虛擬服務器集群本身對實際服務器的監測功能的不足，提出動態反饋負載均衡連接調度演算法並加以實現。
  11. The proportional flow valve control system with speed - electric feedback applied in hydraulic elevators can eliminate disturbances of nonlinear source such as oil temperature and load change. in this system, the proportional valve plays a key role

    採用轎廂速度一電大閉環反饋控制方法的電液比例閥控系統，可以排除油溫及負載變化等因素引起的非線性干擾，極大地提高了液壓電梯的工作性能。
  12. Onceaoc is designed. the container can be capable of adapting their behavior to the changing environments though dynamically weaving multiple aspects at run - time. process - collocation and host - collocation is supported to improve the performance of communication in onceaoc. to improve the dependability and scalability of wass, a middleware - based adaptive load balancing service is designed

    針對w亡b應用服務器負載平衡服務的特殊需求，論文設計了一種基於中間件的自適應負載平衡服務，闡述實現該服務的若干關鍵技術及其解決辦法，包括可熱插拔、負載策略可替換、負載反饋與自適應控制、狀態遷移以及容錯技術等。
  13. It brings about the problems of low flow - used ratio and bad harmony in flow dividing control when simultaneously operating multi - actuators with different inertia loads. this paper is aimed to solve these problems by method based on pressure decrease sensing and meter - in flow rate feedback control of actuators. in this paper, several important points including theoretical analysis, computer simulation, and experiment study will be explained

    本論文主要針對因執行器所驅動慣性負載的差異而引起流量利用率低和協調性不佳的問題，提出了一種基於壓差傳感和執行器進油側流量反饋的分流控制方法，並進行了相應的理論分析、模擬研究和實驗研究。
  14. Aimd algorithm exhibits a tradeoff between performance and complexity. in this paper, at the base of feedback, the theory of forecast is introduced : certain amount of data is stored, the neck resource forecast the load of current scope of time according the stored data, then it feedback the information to the sender

    本文在反饋控制的基礎上，引入預測反饋控制理論，提出了一種新的反饋控制演算法:接收節點存儲一組歷史負載值，並根據歷史負載預測當前時間片發送方的負載量，同時反饋給發送方，發送方根據反饋信息調節自己的負載水平。
分享友人
分享到 Line

分享到臉書