質量比電阻 的英文怎麼說

中文拼音 [zhíliángbǐdiànzǔ]
質量比電阻 英文
mass specific resistance
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 量比 : fnc
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. The highest density and the low resistivity and the best magnetostriction in a composite rod were obtained when the proportion of binder to powders " weight is 4 : 100

    膠與磁性粉末的質量比為4 ： 100時，粘結體的密度最高，電阻率最低，磁致伸縮性能最佳。
  2. Besides, scan rate and cycle period also affect the result ; co - deposition of dualistic oxide is a focus of research, as an element in the same group, ir is selected. deposition rate of composition is decreased by the adding of ir composition, and when the proportion of ir exceeded 50 %, composition procession can be ceased. but cooperation of ir and ru oxide can highly increase the specific capacitance of active material ; annealing treatment under a certain temperature can help to change the hydrate ru composition into mixture state ru oxide, accordingly increase the stabilization of active material

    研究表明:電解液的配製過程中，氯化釕濃度、溶液ph值、陳化時間、溶液溫度對電鍍效果均有影響，其中溶液ph值是最主要的影響因素;在儀器的使用條件探索中，理論結合實驗確定了本電鍍液體系循環伏安電勢窗的理想范圍，並發現循環伏安掃描速度和掃描周期對電鍍結果也有較大影響;混合氧化物的共沉澱是目前研究熱點，在此選用與釕同一族的銥作為共沉澱元素，銥的加入會阻礙氧化物的沉積速度，銥的比例超過50 %會使沉積作用停止，但是二元氧化物的協同作用使沉積的活性物質比容量大大提高;一定溫度下退火后處理作用會使水合釕化物轉變成混合價態的氧化釕，從而提高活性物質的穩定性。
  3. The membrane properties were found to be dependent upon the content of styrene. the membrane physic - chemical properties compare to nafion 117 except that their chemical stability has to be further improved to make them acceptable for practical use in the proton exchange membrane fuel cell. the proton transport through the membrane follows the " liquid - like " proton conductivity mechanism y and the water balance is important for the working condition of the fuel cell

    對磺化膜的研究分析表明：膜的性能參數如離子交換容量、吸水率、水合系數、形體穩定性、導電性能、化學與熱穩定性等依賴于膜中苯乙烯含量，且接枝苯乙烯相互間的位阻效應對膜性能影響很大；膜的性能可與nafion膜相比較；質子在膜中的傳導遵循「似液體」質子傳導機理；電滲析與擴散作用使膜保持水平衡。
  4. The calculation program using the matlab has been worked out to get the numerical solutions of the proposed models. the experiment has first been conducted in the laboratory to get the fundamentals thermal and moisture properties ( such as materials density, specific heat capacity and thermal conductivity ) and also the material moisture absorption isotherms of adobe building materials. the methods of measuring the surface mass transfer coefficient and material moisture content have been proposed

    首次對生土建築材料物性參數進行了實驗測試，得到了常用生土建築材料的密度、比熱和導熱系數等參數值，得到了生土建築圍護結構的等溫吸濕平衡曲線的擬合函數關系式；此外，研究了生土建築圍護結構表面質交換系數實驗測定方法，探索了利用電阻率測量生土建築圍護的安窪築科技人學博十學位論文結構內部含濕量的測試方法。
  5. Mass specific resistance

    質量比電阻
  6. At the same time the number of holes for liquid flowing, gas flowing and blocked to the number of total holes was defined as liquid flowing ratio, gas flowing ratio and blocked ratio. the experiment was made with in - diameter 500mm column using water - air system, the ratio was first delected in detail by multi - path conductivity gauge for the compound tray with free area 20 % and 25 % respectively

    採用多路電導測試儀，在直徑500mm的冷模塔內，以空氣-水為介質，首次較系統地測量了開孔率為20和25的復合塔板的通氣、通液和阻塞篩孔的數量比例，獲得了通氣率、通液率和阻塞率隨氣液變化的基本規律。
  7. Secondly, we measured the electrical properties of the ion - implanted samples by hall method ( square carrier concentration, square resistance and carrier mobility ). after comparing and analyzing, we can know that the electrical properties were affected by the difference of mn dose, the implantation of c and the annealing temperature

    其次，利用霍爾測試方法測量了每種離子注入樣品的電性質（方塊載流子濃度、方塊電阻及載流子遷移率） ，通過比較分析了解到mn元素注入劑量、 c元素的注入以及退火溫度的不同，都會對樣品的電性質產生影響。
  8. Compared with green light - emitting device, blue oled has many problems such as brightness, efficiency, stability, and color saturation, in this study we investgaited the blue oleds systemically : 1 ) double heterosturcture oled was charaterized. due to the introducing of electron transport layer alq3 and hole - blocking layer balq3, the energy matching was more reasonable and the carrier injecting was more effective in the double - layer device. the maximum efficiency and luminance of this device attained to 1. 90 lm / w and 10, 000 cd / m2, respectively

    其次，由於一直以來藍光oled器件的研究處于相對落後的狀態，其發光亮度、效率、穩定性和色純度都無法綠光器件相比，所以本論文在以下幾個方面對藍光器件的性能進行了系統的研究: 1 ）研究了雙異質型藍光oled器件，由於本研究引入了空穴阻擋層，使得載流子的復合和激子的擴散被限定在發光層內，器件的發光效率達到了1 . 90lm / w ，最大亮度達到了10000cd / m2 ，比傳統結構器件的效率和亮度提高了約一個數量級; 2 ）制備了結構為ito / npb / balq3 / alq3 / mg : ag的oled器件，研究發現，當改變各有機層厚度時，器件的電致發光光譜發生了從綠光到藍光的移動。
  9. When comparing the electrical resistance with some other common damage parameters, the damage evolution law expressed by them is obtained. and the relationship between resistance and fatigue cycle numbers has been studied essentially

    將電阻參量和其它一些常用損傷參量進行比較，得到其它參量表示的損傷演變規律，分析了電阻隨材料疲勞循環次數變化的本質。
  10. In fundamental theory, adaptive optics, electrostatic actuation, flexure beam theory and squeeze film damping are researched ; in fabrication, bulk micro fabrication process and surface micro fabrication process are researched and compared, then the structure parameters and layout of a 8 x 8 micromirror array are designed using summit foundry ; in analysis, analytical and numerical method are used to perform static analysis, modal analysis, transient analysis, frequency analysis and to characterize the farfield performance of this 8x8 micromirror array. finally, in order to realize large scale micromirror array with lower snap down voltage, advices are given for further research

    在基本理論方面，通過對自適應光學，靜電力驅動，彈性梁理論和擠壓薄膜阻尼的研究，確定了微變形鏡的配置方案；在加工方面對體加工工藝， mumps工藝和summit工藝進行了研究與比較，並選用殘余應力小，表面質量好的summit工藝對8 8的微變形鏡陣列原型進行了結構設計與版圖設計；在分析方面主要對微變形鏡單元的靜態特性，模態特性，瞬態響應，頻率響應和8 8規模的微變形鏡陣列的遠場光學模型進行了研究，確定了微變形鏡的性能參數。
  11. An analogy was employed between the mass transfer for the faciliated transport with fixed carrier membrane and the electron transfer in a resistor - capacitor ( rc ) circuit

    通過將固定載體膜內的質量傳遞與電阻電容迴路中的電子傳遞相類比，提出適用於非對稱膜固定載體促進傳遞的數學模型。
  12. First, it is associated with the prepared conditions of spectral pure graphite electrode ; second, compared with the untreated graphite, the surface functional groups of ? oh and ? cooh on the treated one increased dramatically with hot concentrated h2so4 and the impurities on electrode surface decreased significantly with ultrasonic rinse. a sequence reaction mechanism was proposed for the eis of mn ( ) / mn ( ) on different graphite electrodes. the spectral graphite and the treated one can be suitable for the inert electrode of mn ( ) / mn ( ) cathode

    分析原因認為：一方面與光譜純石墨電極的制備條件有關；另一方面，與未處理石墨電極相比，處理石墨表面含氧官能團? oh 、 ? cooh明顯增多，而且超聲清洗又使其表面雜質含量減少，並提出了一個反應機理解釋mn （ iii ） / mn （ ii ）電對在三種石墨電極上阻抗譜的不同，說明光譜純石墨和處理石墨均可以作為mn （ iii ） / mn （ ii ）正極電對的惰性工作電極。
  13. The result indicates, due to the increment of porosity and strength, and the enlargement of pore diameter and the decrement of the resistance of zn electrode made by casting, the usage factor of the active material of zn electrode and the capacity in factor of the zn electrode were increased

    指出：由於採用鑄造法可提高電極的孔隙率、強度、增大電極的孔徑、降低電極的內阻，從而使得電極的活性物質利用率，電極的實際比容量得以極大的提高。
分享友人
分享到 Line

分享到臉書