超穩定膠乳 的英文怎麼說

中文拼音 [chāowěndìngjiāorǔ]
超穩定膠乳 英文
over stabilized latex
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 穩 : 形容詞1 （穩定; 穩當） steady; stable; firm 2 （穩重） steady; staid; sedate 3 （穩妥） sure; rel...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 乳 : Ⅰ動詞（生殖） give birth to Ⅱ名詞1 （乳房） breast2 （奶汁） milk 3 （像奶汁的東西） any milk lik...
  • 穩定 : 1 （使穩定） stabilize; steady 2 （穩固安定） stable; steady 3 （物質的性能不易改變的作用） stabi...
  1. The results of performance testing showed that the additive of nano - powders can evidently enhance the latex coatings " weathering resistance, scratch resistance, water resistance and alkaline resistance, and do not reduce other performances ; polybasic nano - composite powders have more efficient than single nano - powder ; the dispersing method have biggish effect on performances. observing the stability of nano - additive of exterior latex coating showed there was no viscidity rising, no delaminatiom sedimentation in two months. tryout by plant showed that nano - weatherability additive can obviously enhance the weathering resistance of latex coating and water resistance, and no reducing other capabilities

    對其性能研究的結果表明，納米粉體材料的引入，可以明顯提高乳膠漆的耐候性、耐洗刷性和耐水耐堿性能，對其它性能無不良影響；納米多元復合粉體比單一粉體的改性效果明顯；納米粉體的添加工藝對改性乳膠漆性能有較大的影響，採用同普通填料一致的添加方式制備的試樣與採用超聲波預分散后在配漆階段加入制備的試樣相比，後者在穩定性、耐候性等方面的性能都有所提高。
  2. That " exceed plate " series all - purpose adhesive, white latex properties of products stabilizes, is a healthy chinese green environmental protection product, depths accept favourable comment of extensive consumer

    「超越牌」系列萬能膠、白乳膠產品性能穩定，是中國綠色健康環保產品，深受廣大用戶的好評。
  3. With the reference of many relevant materials, the author prepared a fined molybdenum disulfide powder with a average size of 800nm by ball milling, and a nano - copper with average size of 30nm in micromulsion solution method, and synthesized surface - modified titanium dioxide nanoparticles with average size of 40nm in organic media via sol - gel method. the tribological performances of three particles were studied by universal test as well, with the result of fined molybdenum disulfide powder with good reducing wear and antiwear performance at low load, nano - copper with good reducing wear and antiwear performance at high load, surface - modified titanium dioxide nanoparticles maintaining stable reducing wear and antiwear performance from low load to high load due to its characteristics of organic and inorganic nanocomposite. the results indicate that the nanocomposite is the most perspective oil additive. the reducing wear and antiwear mechanism of nano oil additive was studied with in - situ tribochemical principle. nano additives possess broadly developing prospect with its above - mentioned performance

    在參閱了大量文獻的基礎上，分別採用了球磨法、微乳液法、溶膠?凝膠法制備了超細二硫化鉬、納米銅粒子、表面修飾納米二氧化鈦，經原子力顯微鏡測試，獲得的超細二硫化鉬的粒度平均在800nm以內，納米銅粒子平均粒度約為30nm ，表面修飾納米二氧化鈦平均粒度約為40nm ，在萬能摩擦磨損試驗機上測試了三種粒子的摩擦學特性，結果表明：在合理的添加濃度范圍內，超細二硫化鉬在低載時具有優良的減摩抗磨性能，納米銅在高載時具有比較好的減摩抗磨性能，表面修飾二氧化鈦粒子因具有有機與無機復合物的特性，從低載到高載都保持穩定的減摩抗磨性能。
  4. A free radical polymerization mechanism for ultrasonically irradiated emulsion polymerization was proposed. ( 2 ) ultrasonically irradiated encapsulating emulsion polymerization was first used to prepare polymer / inorganic nanoparticles composites

    二、採用超聲輻照包裹乳液聚合法制備了長期穩定的、聚合物包裹無機納米粒子的膠乳體系，處理后得到聚合物/無機納米粒子復合材料。
分享友人
分享到 Line

分享到臉書