距離偏差 的英文怎麼說

中文拼音 [jùlípiānchā]
距離偏差 英文
along track bias
  • 距 : Ⅰ名詞1 （距離） distance 2 （雄雞、雉等的腿的後面突出像腳趾的部分） spur （of a cock etc ）Ⅱ動詞...
  • 離 : Ⅰ動詞1 （離開） leave; part from; be away from; separate 2 （背離） go against 3 （缺少） dispens...
  • 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 距離 : 1 （相隔的長度） distance; range; gap; space; spacing; separation 2 （相距） be apart from; be aw...
  1. An isolated point " s statistic excluding method is proposed in this paper to eliminate crassitude error in clouding data, which include plenty of oddity data. the method based on the distance between two neighbour points can eliminate the data beyond normal distribution. a error limitation of angle and chordal highness method is used to filtrate clouding point

    針對大量含奇異點的數據點雲，本文提出了剔除粗大誤差的孤立點統計排異法，該方法根據對相鄰點距離的統計，剔除在正態分佈以外的點；對大量數據的精減，利用角度和弦高的最大允許偏差法進行點雲精減。
  2. And then, some common methods of gdm, such as the ahp method, the weighted geometric mean method ( wgmm ), the borda - kendall method, the minimum variance ( mv ) method, the clustering analytic method, the cook - seiford distance measure, cb measure, the maximum and the minimum expected values, the concordance and discordance indices, etc., are used to discuss some consensus problems of gdm, including the consistency of the complex judgment matrix in ahp, the consensus methods of the aggregation of individual preferences ; the aggregation of analytic hierarchy process methods based on similarities in decision makers " preferences, a consensus measure on multiple criteria group decision making

    接著本文採用了群體決策中常用的一些方法（如： ahp法，加權幾何平均法， borda - kendall方法，最小方差法，聚類分析法， cook - seiford距離測度法， c _ b測度法，最大最小期望值法，一致性非一致性指標法等）對群體決策中的幾個一致性問題進行了研究，這些問題包括： ahp中復合判斷矩陣的一致性，個體偏好序集結的一致化方法，基於決策者偏好相似性的層次分析模型的集結中的一致性問題和多準則群體決策的一致性測度。
  3. It makes sampling data regularized by means of man - machine interactive mode and procedure method, respectively. the driven data of the cutter guide is generated, which is based on sampling data processed. it proposes an intelligent data reduction algorithm which bases on the combination of straightness of curves, equidistance and distance deviation principle

    首先採集並分析了內輪廓數據，分別運用程序處理方式和人機交互方式實現采樣數據點的規則化處理;根據處理后的測點數據生成磨頭驅動數據;並提出了一種基於曲線曲率、等距及距離偏差帶的自適應數據壓縮方法。
  4. If a bay is inclined to the general line of the base at an angle of 10 mm in 24m, the error will be 0. 1 ppm.

    如果一個尺段偏離基線總方向的角度相應於24米距離上的10毫米，則誤差為0110-6。
  5. If a bay is inclined to the general line of the base at an angle of 10 mm in 24m, the error will be 0. 1 ppm

    如果一個尺段偏離基線總方向的角度相應於24米距離上的10毫米，則誤差為0 1 10 - 6 。
  6. Experiments on the two drifters showed that the model, with independent variables of sea surface geostrophic current, ekman drift, and mean circulation, has the best efficiency of simulating real trajectories

    利用該回歸模型，模擬出南海2個漂流浮標軌跡和真實軌跡距離偏差較小且二者運動趨勢基本一致。
  7. In the retrofocus project, a retrofocus structure with two elements is used in the object lens to enlarge fov and back working distance, in the head of which the negative meniscus have the effect of balancing aberration and deviating rays like a prism. and a standard hyperhemisphere immersion lens with high refractive index is put behind the object lens to satisfy the receiving of a detector with smaller photosensitive

    反遠距設計方案中物鏡採用二片式反遠距結構，增大了視場和后工作距離，彎月型負透鏡在前，具有平衡像差和棱鏡的偏向作用;物鏡後放置高折射率標準超半球型浸沒透鏡，滿足小光敏面探測器接收。
  8. The optical near - field distribution and propagation properties of solid immersion lens system are analyzed in detail when illuminated by linearly polarized focusing gauss beam. the change of the optical intensity and beam dimension at the bottom of solid immersion lens with different refractive index and different distance are discussed. the simulated results reveal that the higher the refractive index is, the stronger the optical intensity and the smaller the beam dimension at the bottom of the solid immersion lens will be

    編制了對固體浸沒透鏡近場超高密度光存儲系統進行模擬的二維時域有限差分程序，實現了對固體浸沒透鏡光存儲系統的數值模擬；著重研究了線偏振的高斯光束通過固體浸沒透鏡的光傳輸和近場光場分佈特性；分析了固體浸沒透鏡底面出射光強、光斑直徑隨固體浸沒透鏡折射率的變化、光透過固體浸沒透鏡后的強度、光斑直徑隨離開固體浸沒透鏡底面距離的變化。
  9. The radial motion will not only bring the range ambulation and windage to the one - dimension range - profile, but also bring the aberrance and blur produced on given condition that radar signal which is with large product of wide - time and wide - band

    對于大時寬帶寬積信號，目標高速運動不僅會造成目標一維距離像的距離走動和距離偏差，還會造成畸變和模糊。
  10. Pivoting 90 degrees, raab pans westward across the sagebrush - stubbled desert until he spots an identical tube and another building, also four kilometers distant. “ when we talk about locking the laser beam ” that shines inside those tubes, raab says, “ we mean holding the light waves steady to better than the width of an atom ? over that distance

    拉布說：當我們談到鎖住（管道內的）雷射光束時，意思其實是：在光束行經四公里的距離后，我們可以將其偏差控制在一個原子的寬度之內。
  11. A simulation of the guidance scheme applied to the example tilt rotor vehicle exhibits satisfactory behavior in the presence of wind and initial errors

    模擬結果表明，在初始擾動和有風作用下，垂直距離偏差均達到很小。
  12. By calculating parameters including the link length, the azimuth angle, the elevation, the optical power that the inter - satellite optical cdma communication system will receive, the variation range of the azimuth angle and the elevation from the optical antenna of atp are understood well. by analyzing the factors to impact bit - error - rate ( ber ) from the received power, multi - user disturbing, background noise, wavelength, bit rate etc, measures to guarantee high performances of the system are obtained, especially those for smoothing the fluctuation of the received optical power from host platform vibration

    分析研究了衛星光cdma通信系統中衛星仰角、方位角和距離，給出了探測器能夠接收到的光功率以及atp子系統捕獲及跟瞄的范圍;對衛星光cdma通信系統性能模型和基於衛星振動系統性能模型的研究，分析了多用戶干擾、接收光功率、背景光噪聲、振動偏差以及碼速率對系統誤碼率的影響，給出了相應的改進措施。
  13. Some teams may cover twice the distance due to their route and navigation errors

    有的隊由於路線及識圖越野出現偏差，可能要走兩倍于直線距離的路程。
  14. Analyze item by item the position of unintact cycle, the running clearance of unintact cycle, locking - deform, datum dimension regulating, repeatly install, power voltage wave and marking running etc. at the same time, we give the calculating formula to calculating the running marking random error, and use it to calculate the system error of big diameter measure instrument - - datum dimension frame error, gyro - wheel diameter error, error caused by circumstance temperature, error caused by backing distance, angle error, delay error of data collecting circuit, lathe main shaft running error, workpiece install partial error

    對不完整圓的位置、不完整圓的轉動間隙、鎖緊變形、基準尺調整、重復安裝、電源電壓波動、標記轉動等隨機誤差進行了逐項分析，並給出轉動標記隨機誤差的計算公式。對大直徑測量儀的系統誤差?基準尺尺架誤差、滾輪直徑誤差、環境溫度引起的誤差、後退距離引起的誤差、角度誤差、數據採集電路延時誤差、車床主軸回轉誤差、工件安裝偏心誤差分別進行了計算，最後對誤差進行合成。
  15. Usually the rake body makes the static readings high, and by shortening the tipstatic-orifice distance the error can be eliminated.

    一般排管架使靜壓讀數偏高，縮小管端靜壓孔的距離可以消除這個誤差。
  16. Analysis indicates the " low pressure closed reticular flow region " results in the non - equilibrium of pressure along the primary jet ' s orifice. to obtain as large vectoring angle as possible, the optimal ranges of angles, frequencies, velocity amplitudes, and distances from the microjet actuator to the primary jet exit were discussed. the relationship between the vectoring angle of the primary jet and the phase - difference of two adjacent actuators was analyzed

    分析了「拉」模型單作動器模式下，微射流作動器的入射角度、驅動頻率、速度幅值及與主射流間的距離對主射流偏轉程度的影響，並確定了作動器工作參數的最佳范圍;分析了「拉」模型雙作動器模式下，不同的相位差對主流偏轉程度的影響。
  17. This is a simple method to measure the distances between us and nearby stars. however, we cannot measure many stars by this method because the angle is very small. for larger distances, we have to use other methods of measurement

    視差法是量度天體距離最簡單的辦法，但這個方法只適用於小部分的天體上，由於絕大部分天體距離地球實在太遠，視差所造成的角度偏移根本小得難以量度。
  18. Since the controller concerned did not positively apply vertical separation between the two aircraft or take prompt recovery action when they came close to each other, a loss of standard separation occurred

    由於控制員未有為兩架航機提供適當的高度間隔，或在兩機接近時立即採取糾正行動，因而導致這次標準距離出現偏差事件。
  19. To make use of the maximum signal margin with the maximum scanning distance tolerance, the switching threshold should be set at the mid - way point between the background and mark signals

    在使用具有最大掃描距離偏差的最大信號邊限時，轉換門限應該設置在背景與標識信號的正中間？
  20. Abstract : the problem of distance bias controls with overlapping structure is discussed. a decentralized lqg control scheme is proposed by using inclusion principle. the s i mulation results are given by this method for this distance bias control design

    文摘:討論具有重疊結構的距離偏差控制問題.利用包含原理，提出一種分散lqg控制的設計方法，並給出利用該方法對距離偏差控制進行設計的模擬結果
分享友人
分享到 Line

分享到臉書