軌跡方程 的英文怎麼說

中文拼音 [guǐjīfāngchéng]
軌跡方程 英文
locus equation
  • 軌 : Ⅰ名詞1. （路軌;軌道） rail; track 2. （比喻辦法、規矩、秩序等） rut; path; course Ⅱ動詞[書面語] （遵循; 依循） follow
  • 跡 : 名詞1 （留下的印子; 痕跡） mark; trace 2 （前人遺留的建築或器物等） remains; ruins; vestige 3 （...
  • 方 : Ⅰ名詞1 （方形; 方體） square 2 [數學] （乘方） involution; power 3 （方向） direction 4 （方面） ...
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 軌跡 : 1 [數學] （某點在空間移動的路線） locus; trajectory; trail; travel; path; way; [電子學] trace; li...
  1. Abstract : in this paper ， a ray - optics analysis is performed to investigate the asymmetry of dual beam scanning field produced by a rotating polygon. some basic equations of dual beam scan are derived ， such as ， the position vector for the incident point ， the scalar expression for reflected ray ， scan pattern on observation plane ect. the far - field asymmetry of the scanning field has been discussed

    文摘:應用幾何光學理論研究了多光束轉鏡掃描場的非對稱性，導出多光束掃描入射點位置矢量、反射線標量表達式、觀察面上的掃描軌跡方程，並研究了掃描遠場的非對稱性。
  2. The change of indoor contaminating material concentration is dynamical simulated by adjusting the flow of fiowrator. at the same time, the path formulas of simulate pollutant source is modified by experiment, and providing theoretical base for dynamic simulation

    通過調節轉子流量計的流量來達到動態模擬室內污染物質濃度的變化情況，並根據對實驗結果的修正得出裝配式潔凈室室內模擬污染源的軌跡方程，為動態模擬提供了理論依據。
  3. Neglecting the influence of some factors, such as liquid ' s viscidity etc., upon the process of empty bubble breaking, the authors analyze the pressure variation on bubble ' s wall in all directions when it shrinks, and deduce the equation of its moving track towards the rigid side wall under the function of asymmetry pressure

    摘要通過對忽略液體粘性等一些因素對空泡潰滅過程的影響，分析了空泡在收縮過程中，泡壁四周壓強的變化，得出空泡在此不均勻壓強的合力作用下向剛性邊壁運動的軌跡方程。
  4. This paper summarizes the cause of jump at bridge abutment and damage degree, and researches the jump mechanism in the segment having bridge abutment slab and not having bridge abutment slab, and puts forward the trajectory equation when the vehicles jump

    本文對橋頭跳車病害產生的原因、危害程度進行了歸納分析，對設置橋頭搭板路段和未設置橋頭搭板路段的跳車機理進行了分析研究，提出了車輛在橋頭跳車時的軌跡方程。
  5. On the basis of the known actual contour equation of cam in the disk typed cam mechanism with swinging oblique bottomed follower, this paper expounded another method for determining inversely the track equation of cutter center and the motion law of follower, and three key techniques in numerical inverse seeking were solved successfully by adopting the method of curve matching

    摘要根據已知擺動斜底從動件盤狀凸輪機構的凸輪實際廓線方程，闡述了反求確定刀具中心軌跡方程和從動件運動規律的另一種方法，並採用曲線擬合等方法成功地解決了數值反求中的3個關鍵技術。
  6. In the paper, based on the method of low pair replacing with high pair, the problem of cam design was transferred to that of linkage design. by means of rotary unit vectors, the equations of displacement, velocity and acceleration of the replacement mechanisms were developed. and then, the virtual linkage ' s length and direction were deduced

    論文基於高副低代原理，將平面凸輪機構設計與再現函數的平面連桿機構設計統一為同一種方法，運用圓向量函數建立代換機構的位移、速度、加速度矢量方程式，求取虛擬連桿桿長和方向，由此展開凸輪理論廓線、實際廓線、曲率半徑和壓力角的求解，並得出用圓形刀具加工凸輪時刀具中心的軌跡方程。
  7. Second, the author introduced a new stability region, and programmed a trajectory of variable zmp, which was defined as a cosine curve ; the author also designed a cog - compensated method to keep the cog ’ s height ; based on dynamics of 3 - d inverted pendulum, the author educed the cog ’ s trajectory equation of the robot in the three - leg - support phase, and used third - order splint function to ensure the acceleration continuity of the robot ’ s cog in the four - leg - support phase. at last, walking patterns of the corresponding gait are generated through programmer design

    然後，提出了一種新的支撐區域選取方法，採用了按餘弦規律變化的zmp運動軌跡;為了維持機器人行走時重心高度不變，採用了一套有效的質心高度保持方法;基於三維倒立擺模型，推導了機器人三腳支撐期質心運動軌跡方程;採用三次樣條曲線插值規劃了四足支撐期加速度連續的質心運動軌跡。
  8. Based on variable zmp and dynamics of 3 - d inverted pendulum, we educed the cog ( center of gravity ) ’ s trajectory equation of the robot in the single - support phase and transition of locomotion phase. and we used third - order spline function to ensure the acceleration continuity of the robot ’ s cog in the double - support phase. thereby, the smooth trajectory of cog was gained by planning

    由基於可變zmp和三維倒立擺的動力學原理，推導出了單腳支撐期內和步行方式轉換期間機器人的質心運動軌跡方程;並採用三次樣條曲線來保證機器人在雙腳支撐期質心加速度的連續性，從而由規劃得到了光滑的質心運動軌跡。
  9. Abstract : based on the principle that the radical force of each roller should be equal roughly during the stagger spinning process, matching relationships among reductions of rollers on slope are defined after considering fully various influence factors of radical force. then locus equation of each roller is defined by using geometry relationship

    文摘:基於錯距旋壓過程中各旋輪的徑向力大致相等的原則，在充分考慮了影響徑向旋壓力的各因素后，確定了處于斜坡時各旋輪的壓下量之間的匹配關系，進而利用幾何關系分別求得各旋輪的運動軌跡方程。
  10. Abstract : this paper analysed the kinematic properties of ball joint hi nged on the piston rod and steering drag link of a separated assistant steering m echanism, and the equations of the path and mathematical model of pressure angle were established

    文摘:分析了分置式轉向助力機構的液壓缸活塞桿與轉向直拉桿相鉸接的球頭銷的運動特性，建立了其軌跡方程及壓力角的數學模型。
  11. Simplification of conicoids and trace equations of traces of a point in 3 - minkowski space

    1中二次曲面的化簡與點的軌跡方程
  12. The three basic steps are as follows : firstly, the flow field is computed. secondly, the droplet trajectory equation is solved in order to determinate the limiting droplet trajectories and local collection coefficient. thirdly, a new iced shape is defined according to ice accretion model

    其基本步驟一般分三步：計算物體的繞流流場；求解水滴軌跡方程以確定極限水滴軌跡和收集系數；根據冰增長模型來確定新的結冰翼型形狀。
  13. Equations of base circle center of the n - p points on logix gear profile

    點的基圓圓心軌跡方程
  14. Disussing on the function of track

    的軌跡方程的商榷
  15. Probing into track function

    的軌跡方程
  16. Based on the strategy, this paper gives the equation of caudal oscillating track when the robotic fish swimming forward with a certain speed by using two - link caudal fin

    根據以上模型，本文給出了機器魚在某個時間段勻速下機器魚兩關節尾鰭擺動軌跡方程。
  17. The correctness of the moving track equation and the feasibility of the correct method are proved by the simulation of the moving track equation with matlab

    對上述中的運動軌跡方程通過matlab進行了模擬，論證了運動軌跡方程的正確性及所提出修正方法的可行性。
  18. Work is done to find out the relationship between scroll wraps profile and the track of machining tool. a general equation about the relationship is recommended

    摘要對渦旋型線加工的刀具中心軌跡程序進行了分析，提出了通用刀具中心軌跡方程並簡單介紹了其應用情況。
  19. According to the newton ' s second law, the droplet trajectory equation is established, the flow field calculated by n - s equation is regarded as the base of droplet trajectory equation solved

    根據牛頓第二定理，建立了水滴軌跡方程，將解n - s方程得到的流場解作為水滴軌跡方程的定解條件。
  20. The chapter 3 and 4 are the core of this dissertation. under the theory of ship manoeuvre capability, it calculates the moving track and strap especially affected by wind and current. base on the analysis of those parameter, the basic theory is provided on navigational safety in the bridge waters

    以試驗及調研的數據為依據，運用第三章建立的數學模型分析、計算船舶在橋區運動的軌跡及航跡帶，重點計算在風、流等因素影響下的船舶橫向漂移量，並對船舶在橋區運動軌跡方程的參數及橋區影響船舶橫向漂移量的因素進行分析，為船舶在橋區安全航行提供理論依據。
分享友人
分享到 Line

分享到臉書