軸吊架 的英文怎麼說

中文拼音 [zhóudiàojià]
軸吊架 英文
shaft hanger
  • : 軸Ⅰ名詞1. (圓柱形的零件) axle; shaft 2. (對稱部分的直線) axis 3. (圓柱形的纏繞器物) roller; spool Ⅱ量詞(用於纏在軸上的線以及裝裱帶軸子的字畫)
  • : hangsuspend
  • : Ⅰ名詞1 (用來放置東西或支撐物體等的東西; 架子) frame; rack; shelf; stand 2 (毆打; 爭吵) fight;...
  1. Fsb series fluoroplastic alloy pump is composed of pump body, impeller, back cover, seal, support, pump shaft, bearing, coupling, fasten bolt, nut and base plate

    Fsb系列氟塑料合金泵由泵體、葉輪,后蓋,密封性,支,泵承,連器,緊螺栓,螺母,底板組成。
  2. The top end bracket shall be fitted with a stainless steel lifting bail and shall be capable of supporting the combined weight of the pump and motor

    頂部尾應該配置不銹鋼環,應該能夠支撐泵和電機的總重量的壓力。
  3. The top end bracket shall be fitted with a lifting bail and shall be capable of supporting four ( 4 ) times the combined weight of the pump and motor

    頂部尾應該配置環,應該能夠支撐泵和電機的總重量四( 4 )倍的壓力。
  4. Based on practical project of inspecting, appraising and reinforcing a main heavy factory building, especially its steel crane girder system, of the second steel mill belonging to taiyuan steel & iron corporation, whose technology renovation leads to increase tonnage of many heavy cranes and vertical load of frame - bent structure, first the structure and its members were investigated, inspected, calculated and analyzed, and their reliability was appraised respectively and the strengthening projects or the measures to remedy were given. then, in accordance with the requirement to strengthen the girders under non - stop production, the feasibility of strengthening the crane girders by adding steel diagonal braces underneath the existing girders has been studied by inspecting and evaluating the strengthening effect of the crane girders and comparing with other reinforcing scheme

    本文結合太鋼(集團)有限公司第二煉鋼廠主廠房由於生產工藝改造要求,加大多臺重型車噸位及bc跨( 1 ) ( 8 )線框排各層豎向(設備)荷載后,對廠房結構,尤其鋼車梁系統進行檢測鑒定與加固設計的實際工程,首先對廠房結構進行了現場調研、技術檢查、測試以及內力和承載能力的計算與分析(考慮抗震) ,並根據檢測、計算與分析結果,對廠房結構、構件的可靠性進行了評定,並綜合提出鑒定結論和加固處理建議。
  5. After an introduction to the research on the software for the design of the variant steel arched girder construction, the creation of the structural model, the structure of the supporting seat, the design of the variant arched girder, and the measures taken to ensure the stability of the plane surface of the arched girder, the thesis goes to study the methods for the hoisting and the angle setting of the long - span arched girders, as well as the bolting of the axle pin in the hinge support

    論文首先對變異鋼拱結構設計可採用的軟體、結構模型的建立、支座構造形式、變異拱梁的設計,以及保證拱梁平面外穩定所採取的措施等進行了研究,然後研究了大跨度變異鋼拱弧形梁裝、角度的調整、鉸支座穿銷等的施工方法,最後對施工完成後的位移進行了實際量測。
  6. Its mast can be installed in inclination according to the requirement of construction the angle between the axis of mast and vertical line should be 10, while the floor of cage always remains level

    該系列升降機無對重,導按施工需要而傾斜安裝導線與鉛垂線夾角10 ,但籠地板始終與水平面平行。
  7. The curve of arch rib, rib section bending, splice of rib sections, seperator of tube, bracing plates, bracing system, meeting of arch, concrete pumping, hangers, tie - rods, the tower of the cable crane and the guy ropes, technical specifications of cfst arch bridge are discussed

    對鋼管混凝土拱橋的拱線選用、鋼管節段彎制、節段拼接、管內分隔倉、綴板設計、聯結繫系統、合龍設計及其細節、管內混凝土的泵送、桿、系桿、纜索機與扣索塔、技術規范等12個問題進行了探討。
  8. The speed reducer upper on the main machine makes central axis rotate through shaft coupling, and roller hanger rotates with central axis, and rollers on the hanger roll around the inside of ring

    安裝在主機頂部的減速機,通過聯器連接中心旋轉,中心帶動磨輥旋轉,磨輥裝在上沿磨環內周一起滾動。
  9. The speed reducer upper installed on the main machine makes central axis rotate through shaft coupling, and roller hanger rotates with central axis, and rollers on the hanger roll around the inside of ring

    安裝在主機頂部的減速機,通過聯器連接中心旋轉,中心帶動磨輥旋轉,磨輥裝在上沿磨環內周一起滾動。
  10. One can receive individual offers fast around trailer for six - wheelers, chassis and at the same time on trailer, aluminium chassis and suspender and beyond that also on frames by mail from anhaenger fahrzeugbau meierling gmbh co kg

    Anhaenger fahrzeugbau meierling gmbh co kg公司積累了多年經驗,在自己的網頁上這家企業為您介紹其它的專門產品,例如關于鋁制底盤,掛車,車身底盤、底、飛機起落、升降罐籠、車,臺座、支桿,半拖車、單拖車。
  11. ( 2 ) using tractor as power, makes it mobile and agile, and, the tractor can be used to do another work if it is not used to drive the tunnel. the tractor with simple hoist implement can assemble the wind tunnel by use of the oil cylinder of tractor itself without another special implement

    ( 2 )使用拖拉機為動力,機動靈活,實驗時,使用一根傳動連接拖拉機和風洞實現動力傳遞,實驗后脫開連接不影響拖拉機其它方面的使用,同時,拖拉機配備簡易的后利用液壓懸掛可以裝風洞,從而不必為風洞配備專用裝設備。
分享友人