軸向光線 的英文怎麼說

中文拼音 [zhóuxiàngguāngxiàn]
軸向光線 英文
axial ray
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  1. Currently in initial production, the off - axis viewing device （ oavd ） is a small viewing unit that mates with a weapon s existing receive - mounted optical sight and provides an image of the target transmitted through the scope and reflected 50 to the line - of - sight back to the firer

    目前，初期生產的離軸式觀察裝置（ oavd ）是一種與裝在支座上的光學瞄準具相配的小型觀察器，它能將透過物鏡的目標圖像折射50到視線方向，再提供給射手。
  2. By analyzing and experimentally verifying the model, new ways of improving mixer performance were put forward. ( 1 ) heat water should be used in the mixer ' s temperature control to make the mixer work with optimal parameters. ( 2 ) the surface materials of the mixing chamber and rotors should be chosen rationally to change material surface energy and increase friction on them. ( 3 ) when the compound was processed under higher pressure of floating weight, shallow groovers or stripes parallel to the axle of the rotor should be made on the mixing chamber internal wall to increase the real contact area and improve mixing effect

    通過對模型的分析和實驗驗證，提出了提高密煉機混煉效果的新途徑： （ 1 ）密煉機溫度控制採用溫水冷卻，使密煉機處于最佳工作狀態； （ 2 ）通過合理選擇密煉室和轉子表面材料以改變材料表面能來增大膠料與它們之間的摩擦力； （ 3 ）在上頂栓壓力較大的條件下，在密煉室內壁與轉子軸線同方向加工淺的光滑槽可明顯改善混煉效果。
  3. This paper derived the transfer matrix of the bilayer structure composed of left - handed and right - handed materials, and computed the density of states ( dos ) along the axis of the finite one - dimensional photonic crystal, which was constructed out of n such bilayer structures periodically

    摘要推導出了由左右手材料構成的雙層結構的轉移矩陣，計算了由n個該雙層結構周期性排列所形成的一維有限長度光子晶體沿其軸線方向的態密度。
  4. All my samples with good orientation are prepared by rf sputtering. then we invest surface morphology and crystal structure, optical and electrical properties of zno films by afm, xrd, hall testing, ultraviolet - visible spectrum photometer and xps et al. zno films are fabricated on gaas substrate

    本文用射頻反應磁控濺射制備了高度c軸擇優取向的zno薄膜，採用原子力顯微鏡（ afm ） 、 x射線（ xrd ） 、 hall測試儀、紫外?可見分光光度計和x光電子能譜等分析測試手段，研究了樣品的表面形貌、晶體結構、光學和電學性能等。
  5. Based on the theory of geometrical optics, the relationship between the axial force exerted on the micro - sphere particles in the mie scattering field and the main parameters of laser is calculated quantitatively when the absorption is considered. the results not only show the relationship between the axial force and some parameters, that include the absorption coefficient of microscopic particles, the laser wave - length, power and so on, but also are useful for choosing parameters in experiments

    摘要以射線光學模型為基礎，對微粒直徑遠大於激光微束的米氏粒子在考慮對光的吸收時軸向力與光源參數的關系進行了計算，計算結果給出了軸向力與微粒的吸收系數、波長、激光功率等參數的關系，為實驗中參數的選擇提供了依據。
  6. It is a professional manufacturer of series of linear motion bearings, flange linear bearings, lengthened flange linear bearings, linear slippers, linear guides linear shaft chromeplate non - chromeplate, precise linear guides aluminium support guides, spherical plain bearings rod ends, spherical plain radial bearings, bolt type roller and needle roller bearings. we also can make other nonstandard bearings at any time. our products are used widely in various industrial machineries of weaving, printing, medical, precise machine tool, packing, metallurgy, spaceflight, automatic recording instrument, etc

    麗水市豪滾軸承製造有限公司座落在浙江麗水市水閣工業區，是一家專業生產：直線運動球軸承系列法蘭直線軸承系列加長型法蘭直線軸承系列直線滑塊系列直線導軌光軸鍍鉻不鍍鉻精密直線導軌系列鋁支撐導軌桿端關節軸承系列向心關節軸承系列螺栓型滾輪滾針軸承系列，隨時可訂做各種非標型軸承，產品廣泛用於紡織機械印刷機械電動工具醫藥機械精密機床包裝冶金航天自動記錄儀等各種工業機械的配套。
  7. And then, zno thin films were synthesize on quartz and silicon substrates by sol - gel dip - coating and spin - coating. the properties of the films and the effects of growth parameters on the quality of zno films were studied using x - ray diffraction, optical absorption, photoluminescence techniques, etc. to modify the energy gap of the zno, mg2 + was added in the sol - gel solution, and mgxzn1 - xo films were prepared by the same method as that for zno films

    利用溶膠凝膠法成功地在石英玻璃和單晶矽片等襯底上制備出了c軸擇優取向的zno薄膜，並利用x射線衍射儀、紫外-可見光光譜儀、熒光光譜儀等對zno薄膜的結構和性能進行了測試、分析，並研究了熱處理參數等條件對zno薄膜性能的影響。
  8. For the first time, the solenoid collecting magnetic field optical transducing principle is presented in this paper, and it is proved that the way to measure current by polarized light encircling conductor and that by polarized light threading solenoid axes are equivalent

    為了解決aoct的長期運行穩定性問題，首次提出了「螺線管聚磁光學傳感原理」 ，證明了偏振光圍繞著無限長通電導體測量電流與偏振光通過通電螺線管的軸向方向測量電流，在光學傳感測量電流的意義上是等價的。
  9. 5. the sensing properties of multimode fiber gratings was investigated experimentally and theoretically in this paper. experimental results show that the bragg wavelength of grating in multimode graded - index fiber is linearly dependent on its temperature and axial strain and its repeatability is good

    五、對多模光纖光柵的傳感特性進行了實驗研究與理論分析，結果表明這種光柵三個反射峰的布喇格波長隨溫度和軸向應變變化均呈現出良好的線性關系，並且重復性相當好。
  10. We consider two situations : ( i ) the light is polarized in the z - direction ; ( perpendicular to the cross - section of the wire ). ( ii ) the light is polarized in the x - direction ( parallel to the cross - section of the wire )

    考慮了兩種不同情況：輻射光沿阱線的軸線方向偏振（ z方向） ；輻射光?河北師范大學碩士研究生學位論文平行於軸截面偏振（設為x方向） 。
  11. The project is used which measuring instrument moved along axis and the measured quartz tube rotated and fixed ort a position. according to data of outer diameter and wall thickness of different sections and positions, it can calculate the parameters of section area, ellipticity, wall thickness error, flexibility and so on

    系統將激光掃描綜合測量儀、直線與回轉伺服控制系統和計算機有機地結合，採用測量儀軸向移動，而被測石英管在固定位置上轉運而不移動的測量方案，根據測量出多個截面和多個不同位置的外徑和壁厚數據，計算出被測石英管的截面積、橢圓度、偏壁度、彎曲度等其它參數。
  12. Single mode optical fiber laser confocal scanning microscopy is a new technology in microstructure studying. the speciality of the system is limiting the out - of - focus light reflected from out - of - focus plane in object to restrict the blur of image. therefore, the plane resolution and axial resolution of the system could be improved to sub - micron grade

    單模光纖激光共焦掃描顯微成像系統是研究微觀結構的一種新技術，其本質是抑制目標物體離焦面所反射的光線進入系統，從而抑制這些離焦光線造成像點彌散斑增大的影響，使系統的橫向與軸向解析度得到大幅度的提高，能實現亞微米級的層析。
  13. We consider two situations : ( i ) the light is polarized along the z - direction, in which case the first allowed dipole transition is to the first subband ( nx - 1, ny = 1 ) ; ( ii ) the light is polarized along the x - direction ( paralleled to the transverse cross - section of the wire ). the first allowed dipole transition is to the second subband nx = 2 relative to the x - direction and to the first subband nr = 1 relative to the y - direction of the wire

    考慮了兩種不同惰況：輻射光沿階線的軸線偏振k方向x輻射光平行於軸截面偏振（設為二方向山偶極躍遷的選擇定則使得體系從初態躍遷到末態分別為電于的第一于帶和第二子帶，二名的光電離0截面隨光于能量的變化截然不同
  14. The dead - end is designed to terminate optical ground wire opgw while minimizing any compression stresses that may be transferred to the core or optical elements within

    此線夾不但能保護光纖不受損傷，傳遞軸向拉力，還能增加光纜抗振能力，延長使用壽命。
  15. With the development of conventional catv system and the completion of its equipment ' s tow - direction upgrading ， hfc （ hybrid fiber coax ） has become an important way to provide the two - direction integrating broadband service to users

    隨著傳統有線電視網路及其設備雙向改造的完成， hfc （ hybridfibercoax ） ，即光纖同軸混合網已成為向用戶提供雙向寬帶綜合業務的重要途徑。
  16. Experiments have demonstrated that, under the condition of constant temperature ( 20 ), the frequency error of double - frequency laser interferometer with two longitudinal modes could be controlled within 10 " 9 even with conditions such as with cool or hot air blowing, it can still be kept within 10 " 7. self - organised fuzzy control methods can be realised in a single - chip processor which contains fuzzy optimisation and self - organisation functions. the above - mentioned system possesses the following advantages : simple

    / znl （式中c為光速， l為諧振腔長， n為空氣折射率，其值約790mhz ） ，原理上對目前可能要求的測量速度都能滿足;它發出的光為一對互相垂直的線偏振光，與塞曼型雙頻激光干涉儀相比，它不用外加軸向磁場及1 / 4波片，因此結構簡單，造價低廉。
分享友人
分享到 Line

分享到臉書