軸性透射 的英文怎麼說

中文拼音 [zhóuxìngtòushè]
軸性透射 英文
axial homology
  • : 軸Ⅰ名詞1. (圓柱形的零件) axle; shaft 2. (對稱部分的直線) axis 3. (圓柱形的纏繞器物) roller; spool Ⅱ量詞(用於纏在軸上的線以及裝裱帶軸子的字畫)
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • : Ⅰ動詞1 (滲透; 穿透) penetrate; pass [seep] through 2 (暗地裡告訴) tell secretly; let out; lea...
  • : Ⅰ動詞1 (用推力或彈力送出) shoot; fire 2 (液體受到壓力迅速擠出) discharge in a jet 3 (放出) ...
  1. The main results achieved in this thesis can be summarized as follows : 1. by means of the fourier series expansion, an approximate analytical propagation equation of flattened gaussian beams ( fgbs ) passing through an apertured paraxial abcd optical system is derived, and illustrated with numerical examples, when the transmissivity of the aperture is t ( x ) = cos ( x )

    用傅立葉級數展開法研究了平頂高斯光束通過有光闌限制的近abcd光學系統的傳輸特,導出了光闌率為t ( x ) = cos ( x )時的近似解析傳輸公式,硬邊光闌的情況可作為= 0的特例得到。
  2. On the basis of theories of physics, geometrical optics and photometry, the optical properties of collimated light beam incident upon single fiber perpendicular to the fiber axis are studied. by exploring the behaviors of reflected light and transmitted light from single fiber, the distribution of the light is described and the proportionalities between the intensity of the reflected, transmitted and scatered light are obtained respectively, and the different laws governing the intensity of diffused light and transmitted light from single fiber between near and far field are discussed. experiments demonstrate that the decrease of projecting light in far field is in direct proportion for the increase of fiber diameter, which serves as the theoretical basis for a series optics equations, as well as for the designment for photoelectric deviccs for detecting fibers

    結合物理學的基本原理和幾何光學的基本規律以及光度學的基礎理論等三方面,研究了單纖維在平行均勻光束垂時的光學質.分析了單纖維反光和光的特徵,光強分佈及反光、光和散光的相對大小;討論了在近場和遠場條件下,漫反光和光光強的不同規律;通過實驗驗證了遠場時,纖維的漫光強度與纖維直徑成正比的關系
  3. A switchable and spacing - tunable dual - wavelength linear cavity edfl is demonstrated experimentally using this kind of bragg grating for wavelength selection. it exploits the birefringence characteristic of the fbg induced by transverse strain. transverse strain loading on the fbg allows the wavelength spacing to be controlled while axial strain shifts both wavelengths together

    2 .對向及側向應力共同作用下的光纖布拉格光柵的及反光譜特進行了理論及實驗研究,並首次把向及側向應力共同作用下的光纖光柵應用於光纖激光器進行波長選擇,得到了室溫下穩定工作的波長及波長間隔可調的可開關雙波長的摻鉺光纖激光器。
  4. For bilateral symmetry objects, the techniques on symmetry - point detection and symmetry - axis extraction are presented based on harmonic conjugation relationship. for rotated symmetry objects, the techniques on rotated units description and rotated symmetry center extraction are presented based on center invariants of objects. further more, by using 3d invariants and 2d projective transformation, an approach to recover shape from part symmetry objects is realized on some conditions

    ( 3 )深入分析了2d對稱目標視成像的幾何特點,將共點四線交比用於目標輪廓上的關鍵點的特描述中;利用調和共軛關系,提出了一種針對左右對稱型目標的對稱點檢測和對稱提取的演算法;利用交比關系構造了目標的形心不變量,提出了一種針對旋轉對稱型目標的旋轉對稱單元判定、旋轉中心提取的演算法;進一步利用3d不變量和2d影變換,實現了一定條件下的對稱目標的形狀恢復技術。
  5. The outcome suggest that, firstly, the change of light transmission with the continuous change of parameters is periodic ; secondly, as far as the degree of effect is concerned, the light transmission of air - spaced prisms is much more sensitive to the change of the parameters than that of the glue spaced ones ; thirdly, as to the prisms glued with the same dielectric, the effect of prisms whose optical axis parallels to the glued layer is intense than those whose optical axis parallels to the plane determines by the normal of incident face and that of the cut face

    研究認為,激光偏光棱鏡的光強比隨各參量的連續變化都呈現出一定的周期;各參量對空氣隙型偏光棱鏡的影響要比對膠合型棱鏡的影響大的多;同種介質膠合的棱鏡,各參量對光平行於切割斜面的設計類型比光平行於切割面的法線和入端面的法線所組成的平面的設計類型的影響要大。
  6. If a optical anisotropic medium wafer is put into the mid of a polarizer and a analyser, the spectral transmission of the optical system can calculated. the transmission is determine by the birefringence and the thickness of the medium

    對各向異介質處于相互正交的兩個偏振片之間構成的光路,其光譜過率與介質的延遲量有關,即與介質的雙折和厚度有關。
分享友人