軸用鋼配筋 的英文怎麼說

中文拼音 [zhóuyònggāngpèijīn]
軸用鋼配筋 英文
axle steel reinforcing bar
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 鋼 : 鋼名詞（鐵和碳的合金） steel
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 筋 : 名詞1 （肌的舊稱） muscle2 [口語] （肌腱或骨頭的韌帶） tendon; sinew 3 [口語] （可以看見的皮下靜...
  1. The influence of such parameters as axial load index, aspect ratio and percentages of lateral reinforcement, on seismic performance of reinforced concrete frame column in hong kong and analyses the distribution relationships of flexural deformation, shear deformation and slippage of longitudinal reinforcement in joint zone

    根據試驗結果，討論了軸壓比、配箍率、剪跨比等參數對其抗震性能的影響，分析了水平荷載作用時塑性鉸區的彎曲變形、剪切變形和縱向鋼筋粘結滑移變形所產生的位移在框架柱總水平側移中所佔的比例及其變化規律。
  2. For the cantilever beam, the theoretical stiffness and limited capacity are slightly less than the test ones if considering only the steel beam and the reinforced bars in the negative moment zone with the concrete in the tension zone ignored

    結果表明：簡支組合扁梁，忽略彈性中和軸以下受拉的混凝土的影響，採用等效換算截面方法計算所得的剛度和極限承載力與試驗結果比較吻合；懸臂梁只考慮混凝土板中配置的負彎矩鋼筋，忽略混凝土，計算所得的剛度和極限承載力比試驗結果略微偏小，但相差不大。
  3. A seismic shear capacity equation for ductility and non - ductility columns is proposed to amount for the reduced shear contribution of concrete as to the increasing of displacement ductility levels. 6. the behavior of columns * transverse displacement within yield hinge regions is also discussed based on truss - arch model. 7. the seismic shear capacity design equation of columns with various ductility levels is proposed in statistic method on the basis of test data collected from japan and china to simplify the equation resulted from truss - arch model

    對國內外試驗資料進行了統計分析，詳細分析了剪跨比、軸壓比及配箍特徵值對框架柱構件抗剪承載力的影響，得到了反復荷載下框架柱塑性鉸區域極限承載力計算的統計公式；在理論推導公式及統計公式的基礎上，參考國內外規范，首次管品武；鋼筋混凝土框架柱塑性鉸區抗剪承載力試驗研究及機理分析提出了鋼筋混凝土框架柱塑性鉸區域剪切承載力抗震延性設計實用公式。
  4. It is found by comparison that as the structural forms of special - shaped columns and short - shear walls are used, the structures should be arranged reasonably so as to meet the needs of lateral stiffness, and axial compression ratio should be controlled strictly so as to meet the needs of constructional reinforcement to prevent the probably curling and shear failure for the purpose of meeting the needs of the construction of small high - buildings

    對比討論發現：採用鋼筋混凝土異形柱和短肢剪力墻的結構形式時，應當進行合理的結構布置以滿足結構整體抗側移剛度的要求，同時嚴格控制豎向構件軸壓比並滿足配筋構造以防止構件可能出現的翹曲和剪切破壞，這樣才能同時滿足小高層住宅對建築和結構的需要。
  5. 2. based on the test results published over the word of steel fiber reinforced concrete beams without web reinforcements and with stirrups, the effects of steel fiber to shear resistance and the relationship of steel fiber to stirrups are analyzed, the improvements of steel fiber to failure states of reinforced concrete beams without web reinforcements are discussed. it is proposed that the formula of shear resistance of steel fiber reinforced concrete beams based on the model of the current design and construction spectification of steel fiber reinforced concrete structures ( cecs38 : 92 ), used of the uniaxial tensile strength of steel fiber reinforced concrete, and combined with different formulas specified in current design codes of concrete structures issued by different trades

    根據收集到的國內外對鋼筋鋼纖維混凝土無腹筋梁和鋼筋鋼纖維混凝土有腹筋梁的斜截面受力性能試驗研究成果，對鋼纖維在增強鋼筋混凝土無腹筋梁和有腹筋梁斜截面承載力方面的作用及其在箍筋抗剪承載力的關系進行了總結分析，對鋼纖維改善鋼筋混凝土梁破壞形態方面的作用進行了分析討論，提出了採用鋼纖維混凝土軸心抗拉強度指標，基於現行cecs38 ： 92 《鋼纖維混凝土結構設計與施工規程》計算模式、能夠與目前國內各行業現行混凝土結構設計規范中不同的鋼筋混凝土梁受剪承載力設計方法配套使用的鋼筋鋼纖維混凝土梁受剪承載力設計方法。
分享友人
分享到 Line

分享到臉書