載荷不同時率 的英文怎麼說

中文拼音 [zǎihébùtóngshílǜ]
載荷不同時率 英文
load diversity
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 荷 : 荷名詞（蓮） lotus
  • 不 : 名詞[書面語] （剁物所用的木墩） a block of wood
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 載荷 : load; loading載荷變化 load fluctuation; variation in load; 載荷裝置 load device
  1. Based on vibration principle, the paper establishes dynamics analysis model of output shaft with elastic support, according to fourer series spread principle of periodic function, the dynamic response formula is derived by separating complex vibration force into sum of many simple harmonic excitation function of whole number times frequency relations. the result shows that response of both sides support is synchronous when load distribution non - uniform coefficient is 1

    依據振動理論建立了具有彈性支撐的輸出軸的動力學分析模型，根據周期函數的傅里葉級數展開原理，將復雜的激振力分解成為多個頻率成整倍數關系的簡諧激勵函數，導出了動態響應表達式，結果表明，當載荷分配不均勻系數為1 . 0時的輸出軸兩端支撐同步。
  2. The paper presents a new comparative method. that is to make the different strengthened forms by externally bonded with different materials reach the same ultimate flexural capacity, and contrast with each load - deflection and moment - curvature curve, which are calculated by paper ' s program. mean

    本文引入新的對比方法，即不同材料的加固在最終均達到同樣的極限抗彎承載力時，比較其各自的彎矩一曲率和荷載一撓度變化情況，並自行編製程序進行計算。
  3. The new unit has following technical features : ( 1 ) the unit ' s load is balanced by means of the accumulator and hydraulic cylinder with special structure ; ( 2 ) the installed power of the unit can be reduced greatly by adopting the accumulator ; ( 3 ) variable frequency speed regulation ensures good energy saving effect, and the closed oil circuit requires less hydraulic oil ; ( 4 ) a bi - directional hydraulic lock in the oil circuit ensures the stability and safety of the operation of the pumping unit

    新型機具有4個技術特點： （ 1 ）由於活塞柱塞式液壓缸的特殊結構和液壓蓄能器的配合使用，在平衡抽油機大部分載荷時，不需另外增加配重，可減小抽油機體積、質量和佔地面積； （ 2 ）抽油機下沖程時，與活塞柱塞式液壓缸相連接的蓄能器吸收能量，上沖程時儲存在蓄能器中的能量補充載荷上行所需的能量，大幅度降低抽油機裝機功率； （ 3 ）利用變頻容積調速節能效率高，閉式油路節省液壓油，同時大大減小液壓泵站的體積； （ 4 ）在閉式油路中採用雙向液壓鎖可使抽油機的啟停更加平穩、迅速，其工作的穩定性和安全性更好。
  4. With the different loading ratio of parallel to axis and normal to axis direction, damage defects will occur bulking problem. by varying the degree of material anisotropy relative to the loading axis such as poisson ' s ratio and shear modulus, crack growth bulking strain value parallel to or normal to the loading axis is different. the parameters controlling the growth or arrest of the delamination damage are identified as the geometry and the depth of defects and radius of cylindrical etc. at last, it was investigated that the delamination damage is often induced by the tip of matrix damage under higher stress

    研究結果表明:殼體筒段受軸向拉伸和內壓載荷作用時，軸向和環向載荷的比率不同，母層和子層可能發生拉伸屈曲，也可能發生收縮屈曲，或者同時發生拉伸和壓縮屈曲;母層與子層各向異性存在差異，即泊松比與剪切模量不匹配時，將使子層板的邊界上承受壓縮和剪切作用，當分層達到臨界狀態則發生屈曲，當母層與子層的各向異性差異越大，則發生分層屈曲的可能性越大;分層損傷的屈曲應變值與子層自身的彈性模量、分層子層的形狀、厚度以及圓柱半徑等因素有關。
  5. The combined effect of the soil, structure and seismic wave was considered in the analysis and the time - dependant curves of earthquake - induced differential settlement of the building were obtained according to differential probability of seismic ground motion

    考慮了土層、建築物荷載分配、地震動波形等影響因素對不均勻震陷的協同作用效果，依據不同超越概率下的地震動給出了建築物不均勻震陷時程曲線。
  6. Under different load, when we apply this software to any time, region and cooling way, we can get the hottest spot increment and aging rating. to manufactory, the software means sounder thermal design, which will meet the load, putted forward by user, while to user, the software equal to a master who can help them decide the capacity rating of the transformer, which will fit the load. by using the software, the potential danger and the waste, caused by unfit load choice may be avoided

    研究開發了計算乾式電力變壓器負載能力的計算軟體，可對于各種絕緣結構，各種冷卻方式和任一地區、任一時間下運行的變壓器在不同運行載荷下的最熱點溫升絕緣老化率進行分析和計算，同時利用該軟體製造廠可以依據用戶提出的運行負載量給出相應的熱設計方案，用戶可根據運行負載情況利用軟體計算所需變壓器的額定容量，避免額定容量選擇不當造成隱患和浪費。
  7. The test results indicated that : crack similitude of reinforced concrete simple beams is not equal to model scale under the working load ; when the amount and surface shape of reinforcing bar are same, the similitude of crack width, crack amount and crack spacing of reinforced concrete simple beams of different scales are all nearly equal to the square root of model scale ; when the amount and surface shape of reinforcing bar are different, the similitude of crack amount and crack spacing are still nearly equal to, whereas the crack width is not only approximately proportional to, but the influence of the amount and surface shape of reinforcing bar on crack width should be considered also at the same time

    試驗結果表明：在使用荷載下，鋼筋混凝土簡支梁的裂縫相似率並不等於幾何相似比；當鋼筋根數及形式相同時，不同模型比尺下的鋼筋混凝土簡支梁的裂縫寬度、裂縫條數及裂縫間距的相似率，均約等於模型幾何相似比的平方根；當鋼筋根數及形式不同時，裂縫條數及裂縫間距的相似率仍然約等於，而裂縫寬度的相似率近似與成正比，但應同時考慮鋼筋根數與鋼筋表面形狀對裂縫寬度相似率的影響。
  8. When there is original stage support only, the load ratio of surrounding rock gets more and more bigger with the increasing of crust stress, correspondingly, the load ratio of initial stage support gets smaller. when the initial stage support and the second support act each other, the load ratio of surrounding rock is more than fifty percent, and it has little change with the increasing of crust stress. the whole analysis of the surrounding rock and support shows that the bottom arch of liner and the feet of liner have serious stress concentration, so do the sidewalls and the foot of a wall of the surrounding rock

    通過屈曲理論分析結果對比表明，彈性屈曲和突變失穩分析的結果比非線性屈曲分析的結果要大得多，非線性分析由於考慮了材料非線性和幾何非線性，因而結果與實際接近實際；當只有初期支護時，隨著地應力的增加，圍巖的荷載分擔率增大，相應地，初期支護的荷載分擔率就減小了；當有初期支護和二次襯砌共同作用時，圍巖的荷載分擔率在50以上，這一分擔率隨地應力的增加其變化不大；支護和巖體的整體分析表明，襯砌底拱及拱腳處應力集中嚴重，隧道巖體側墻及墻角圍巖的應力集中也較大。
  9. According to the characteristic of nine - area diagram of substation vol / var coordinated control, this system gives the defination of fuzzy sets and the degree of membership of input / output variables, and designs corresponding control rules. the results of simulation demonstrate the system can satisfy the constrains of the day - adjusting times of the switching of on - load transformer and paralleled compensation capacitors, and ensure voltage quality, reactive power basical balance. considering the var requirement in different load time period and the control demand in load saltation, a improved control scheme is provided. the results of simulation show the improved scheme can meet the demand of vol / var in different load time period, protect the wrong operation when either voltage or reactive power appears saltation, and decrease the times of regulation of the switching of on - load transformer and paralleled compensation capacitors finally, a background software module of substation vol / var coordinated control is designed, based on the supervisory control and data acquisition system of substation

    模擬結果證明該系統能在各種負荷條件下確保電壓合格和無功基本平衡，且能滿足變電站對有載調壓變壓器分接頭日調節次數和並聯補償電容器組的日投切次數的限制。通過考慮不同負荷時段對無功功率的需求和負荷突變情況下的控制要求，對上述模糊控制策略進行了改進，模擬結果證明改進后的控制策略能滿足不同負荷時段對電壓和無功的要求、抑制電壓或無功突變情況下的誤動作，且有效地減少了有載調壓變壓器分接頭和並聯補償電容器組的調節次數。最後基於變電站scada系統設計了一后臺電壓無功綜合控制軟體模塊。
  10. Nevertheless, the widely existed overconstraints in the mechanisms will make the quality of the mechanisms very sensitive to the inevitable manufacturing, assembly errors ( especially, the errors resulted from the shape and position between kinematic pair elements and their axes ). at the same time, because the internal and external uncertain factors such as non - plane characteristic of dynamic parameters of links ( such as mass distribution, inertia forces, etc. ), bending and twist of links, and the changes of environment and operating condition are inevitable, they will form the disturbance to planar constraints and make them possess the characteristic of " uncertain "

    但是，平面連桿機構中廣泛存在的過約束，造成機構對製造、安裝誤差特別是運動副元素的形位誤差十分敏感；同時，由於不可避免的內部和外部不確定因素的影響，常常會造成機構運動的「障礙」及系統中某些構件的變形和運動副中的附加動載荷，引起機械的振動、沖擊、噪聲等而導致機械的效率和工作性能的降低。
分享友人
分享到 Line

分享到臉書