輸入特性 的英文怎麼說

中文拼音 [shūrùtèxìng]
輸入特性 英文
characteristic of enhance
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 輸入 : 1 （從外部送到內部） import 2 [電學] input; entry; entering; in fan; fan in; 輸入變壓器 input tra...
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  1. Just below threshold, consistel1t to theoretical analysis, there are numbers of comb - like narrow linewidth lights due to resonating of ifltr8 - cavity ase light. novel experimental results of the erbium - doped - fiber ring resonator behaviors operating near threshold are reported in the chapter

    首先理論分析了當有源環形腔無注入光，且有源光纖環形腔在閾值以下時，由有源腔內ase輸出光表現出的腔輸出特性。
  2. Trying to measure what is happening with a scope or other instument is also problematical, because the instrument cables and input characteristics modify the network characteristics by their very presence when connected

    試圖用測量儀或其他工具測試此時的系統變化也不太行得通，因為一旦儀器接入系統，它的測試線和輸入特性會改變系統電路的特徵。
  3. Have analyzing the tracking - differentiator ( td ) i / o characteristic, to get a improving td which output uninfluenced by the input

    在分析非線性跟蹤?微分器（ td ）輸入輸出特性的基礎上，提出了跟蹤時間不隨輸入信號幅值改變的td 。
  4. ( 2 ) ln the third chapter of this dissertation, the behaviors of intra - cavity amplified spontaneous emission ( ase ) light in the active fiber resonators are firstly studied by both theoretical and experiment8l ways, when it is operating near the threshold

    二、在本文第三章中，研究無注入光時，通過分析腔內ase光輸出特性來研究有源光纖環形腔在近閾值點附近的濾波特性。
  5. The capacitance offset averaging network is used in the distributed track - and - hold circuit block of the designed system. finally, according to the analysis on error effects in adc, the mathematics error model is simulated. furthermore, the input - output characteristics including input -

    最後，基於對a / d轉換器系統中誤差的分析，對其誤差數學模型進行了模擬，得到了包含延遲、限幅、諧波失真等誤差的輸入輸出特性曲線。
  6. Firstly, the dissertation tells something about lonworks technology, the lontalk protocol, the peer - to - peer communicaton etc. secondly, it lucubrates s - 2000 control system based on lonworks, including the design method of the system, the key technology, the characteristic of the intelligent node, the i / o property, the structure of intelligent block, the neuron chip, the design of the data acquisition node and so on

    本文首先闡述了lonworks技術及其特點，總線系統所採用的lontalk協議， peer - to - peer對等通訊，基於lonworks總線網路通訊協議系統等。然後對基於lonworks總線的s - 2000控制系統進行深入研究，重點研究系統的設計方法和關鍵技術，智能節點的特點，輸入輸出特性及智能模塊分析， neuron晶元的分析研究，以及數據採集節點的設計，數據採集控制軟體，組態軟體的設計原理等方面。
  7. If line length is half wave at a certain frequency and both the load resistance rt and source resistance rs are higher than the characteristic impedance zo, then both the voltages at input and at load are maximum at that frequency and both the voltages at input and at load are minimum at half of that frequency

    負載端電阻及電源電阻均高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最高，在該頻率之半時則電壓均為最低。
  8. If line length is half wave at a certain frequency and the load resistance rt is lower while source resistance rs is higher than the characteristic impedance zo, then both the voltages at input and at load are minimum at that frequency and both the voltages at input and at load are maximum at half of that frequency

    負載端電阻低於傳輸線特性阻抗及電源電阻高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最低，在該頻率之半時則電壓均為最高。
  9. By experiment, the input - output characteristic of the liquid angular sensor is given

    並通過實驗，給出液體擺角傳感器的輸入?輸出特性曲線。
  10. The solution was a rather unique editor called yudit that enabled anyone with a degree of manual dexterity and enough fonts at his disposal to enter extremely complex multiscript texts

    解決方案是一種相當獨特的編輯器，稱為yudit ，它允許任何有一定手指靈活性並且有足夠多字體的用戶輸入特別復雜的多腳本文字。
  11. By using this matching software, input / output characteristic and drawbar performance are obtained for engine and hydraulic converter working together so that the matching rationality between engine and hydraulic converter can be judged, which is significant in type selection of hydraulic converter

    通地應用匹配軟體，得到發動機和液力變矩器共同工作輸入特性、共同工作輸出特性和牽引特性曲線，從而判斷二者匹配是否合理，對液力變矩器的選型具有重要的意義。
  12. The procedure of the test is as follows : first, the piezoelectric stack has been examined to test the performance parameters of the piezoelectric material ; second, the 2 - x actuator has been functioned with different static voltage to test its capability ; last, function the 2 - x actuator with voltage with different frequencies to test its dynamic properties. all the output of the actuator has been measured by the laser vibration measurement

    首先對壓電堆進行試驗，驗證壓電材料的性能參數;再對推挽式雙x驅動器施加不同的靜電壓驅動它，驗證作動器的驅動能力，最後對推挽式雙x驅動器輸入不同頻率的電壓驅動，測量該驅動機構的動態特性，試驗均採用激光測試儀測量推挽式雙x驅動器的輸出特性。
  13. The research indicated that, if the secondary combustion chamber was looked on as a controlled object, with the adjusting valve as a input, the pressure and the temperature of a selected point on the inside wall of the combustion chamber as outputs, then such controlled system would be a strongly non - linear, time varying system with number of random disturbances, which resulted in huge difficulty to build an analyzed mathematics model for the spray burning of the liquid fuel, so that classic control methods were all invalid

    研究表明，若將rbcc發動機的二次燃燒室視為一個控制對象，同時以燃燒室內壁面取定點處的壓強、溫度和調節閥的開度為輸入輸出變量，則該系統將是輸入?輸出特性非線性很強、隨機干擾嚴重的復雜時變系統。這導致建立燃油噴霧燃燒具體模型的很大困難，從而宣告了經典控制方案的失效。
  14. Finally a new theory about energy delivering in hollow waveguide is given. in this theory the input attenuation in both straight and bent hollow waveguide

    在這一理論體系中，我們得到了空芯光纖的輸入特性和光纖直線狀態下與彎曲狀態下的損耗公式。
  15. Chapter three : presents the fabrication process of micro - switch with cantilever beam and designed the masks. chapter four : designed circuit to actuate the micro - switch, analyzed the dynamic and static property of voltage doublers circuit

    第四章設計出了微開關驅動電壓的升壓電路，對倍壓整流電路的輸入特性和負載特性進行了分析，設計了實際電路圖。
  16. In this text, around the specification of frequency conversion machine, proceed some study, has finished some work as below primarily : this text will study the output characteristic and the output characteristic of variable frequency speed regulation system. the input characteristic include power quadrangle theory, the relation of cos ( ? ), and f

    本文圍繞著變頻系統的特殊性，進行了一些研究，主要完成以下的研究工作：本文對變頻調速系統進行了輸入特性和輸出特性的研究，輸入特性包括：功率四邊形理論，功率因數、效率和頻率三者之間的關系。
  17. 2. a theoretical analysis and numerical simulation considering pumping beam waist, q - switch, cavity design are presented. combine with the theoretical analysis and the request of fundamental wave, the appropriate cavity and q - switch are chosen

    2 .從諧振腔設計理論及調q技術進行分析，討論了ld泵浦固體激光器的輸入輸出特性及影響閾值的主要因素;結合理論和我們下面工作的要求，選擇合適的腔形及調q方式。
  18. In this work, based on the threshold condition of the fiber grating external cavity semiconductor laser ( fgesl ) which the phase of the fiber grating has been included, the effect of the temperature variation and the fg external cavity length on the lasing wavelength of the fgesl has been investigated theoretically. in addition, we have used the phase condition of fgesl to get the longitudinal mode distribution of fgesl, then the influence of the injected current on the output characteristics of fgesl has been studied

    基於此，本文中利用陽實際的反射相位分佈，計及半導體激光器（ ld ） 、外腔及光纖光柵（ fg ）三者的共同作用，根據fgesl滿足的閩值條件，從理論上研究了溫度及外腔長度的變化對fgesl激射波長的影響;根據fgesl中縱模所滿足的相位條件得到其縱模分佈后，利用fgesl滿足的多模速率方程，研究了ld的注入電流對fgesl輸出特性的影響。
  19. A theoretical study of input and output properties of four - level solid laser was performed according to the velocity equation, and the important role of the overlap integral j, was noticed and made a fully usage in optimizing the end - pumping solid state laser parameters such as : rod length > pump position pumping and oscillating beam waist size

    從四能級速率方程出發，理論推導了ld端面泵浦的固體激光器的輸入輸出特性，並指出重疊積分j _ 1對激光器輸出特性的極大影響，從而對其在不同泵浦條件下進行分析並以此得到端面泵浦條件下固體激光器的最優化設計參數的選取方法。
  20. In the end, this thesis tests the resonator with three methods in case that it is both open looped and closed looped, and gets the results listed below : 1 taking 1 mhz frequency width ld as the light source, using current injecting frequency modulation method, the output characteristic of the resonator is got, which proves that the laser used in the lab can be used to modulate the frequency using current injecting frequency modulation

    本文最後採用三種不同的方法對諧振式光纖陀螺進行了開環和閉環的實驗測試，並取得了以下實驗結果： 1 、用頻寬1mhz的ld作光源，採用電流注入調頻的方法，觀測到了諧振腔的輸出特性曲線。證明了實驗採用的激光器可以通過注入電流的方法實現調頻。
分享友人
分享到 Line

分享到臉書