輸出壓力表 的英文怎麼說

中文拼音 [shūchūbiǎo]
輸出壓力表 英文
delivery pressure gauge
  • : Ⅰ動詞1 (運輸; 運送) transport; convey 2 [書面語] (捐獻) contribute money; donate 3 (失敗) l...
  • : 壓構詞成分。
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  • : Ⅰ名詞1 (外面;外表) outside; surface; external 2 (中表親戚) the relationship between the child...
  • 輸出 : 1 (從內部送到外部) export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成電子控制檢測端子,並在檢測面板上布置了obd -診斷插座和燃油。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測;並通過obd -診斷座、 ecu檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除;動態數據讀取和波形測試和故障模擬等。此外,本論文還分析了傳感器和執行器典型故障波形。
  2. It is concluded that maximum bending displacement becomes larger as the input voltage gets larger and the frequency becomes lower, while the curve of bending displacement is affected by waveform. in comparison with the little effect by various waveforms, the generative force at the tip of the ipmc actuators increases as the input voltage gets larger and the frequency becomes lower

    結果明,電幅值和頻率對其位移變形的大小影響較大,波形對其位移變形的軌跡影響較大;電幅值和頻率對其的大小影響較大,而波形對其影響較小。
  3. On top of one of the fast - opening ends that closed to the pig receiver & launcher shall assemble vent valve, safety valve and pressure gauge, and at the bottom shall assemble drain valve, sideway inlet and vent valve to take out medium from the main pipe as the power of forcing pig and conveyance medium

    靠近收發球筒快開盲板一端上部應設防空閥、安全閥及、下部設排污閥、側面設進、油(氣、水)閥,以便從干管中取介質作為驅動清管器的動介質。
  4. Summarize : multi - input, can be used cooperate with various sensors / transducers, measure 、 display and alarm control the physical quantities such as temperature 、 humidity 、 liquid level and flux # 118alues and transform them to export, can read and write all parameters via the computer through serial communication, besides it can offer 24vdc power supply for 2 - wire transducers, four - bit led displaying, the multi - segment curve correcting function is selectable, one meter can equip four alarm relay outputs 、 one transform ( or communication ) output and one equipped power supply outputs

    萬能入,可與各類傳感器、變送器配合使用,實現溫度、濕度、、液位、流量等物理量的測量、顯示、報警控制和變送;通過串列通信口,可在上位計算機中實現全部儀參數的讀寫;還可為兩線制變送器提供24vdc電源; 4位高亮度led數字顯示;對入信號有多段折線修正功能可選;一臺儀最多可配4個報警繼電器、一路變送(或通信)和一路配電
  5. According to the test platform, the monitoring control system based on computers is designed, which can output voltage signals of rolling moment and swaying force that regular wave and irregular wave press on ships

    針對試驗臺架設計了以微機為中心的監督控制系統,該系統可以實時規則波和不規則波海浪作用於船舶的橫搖矩和橫蕩的電信號。
  6. Performance for a piezoresistive transducer pressure sensor to thermal and pressure environments can be predicted by finite element method. a simplified 1 / 8 model, considering silicon dioxide and nitride process as well as stack anodic bonding and adhesive bonding processes, was developed. the fem results were found to be comparable to experimental data. case studies suggested that pyrex stack induces certain amount of non - linearity, while it isolates hard epoxy nonlinear effect. flexible epoxy bonding or soft adhesive bonding is preferred to the packaging process. the viscoelasticity and viscoplasticity of bonding material will result in hysteresis and drift errors to sensor output. however, soft adhesive s influence on sensor can be ignored under relative stable environments. more over, detailed design and process information will help to improve modeling application

    熱、環境下阻變換傳感器的性能可以通過有限元方法預測.這里研究了簡化的1 / 8模型,模型考慮了二氧化硅和氮化硅生成過程及堆陽極鍵合和膠粘結合過程.結果發現有限元預測結果和實驗數據具有可比性.範例研究明,硼硅堆導致產生一定的非線性,但它隔離了硬環氧樹脂的非線性.在包裝過程中最好使用柔性環氧黏合或軟黏膠性結合.黏合材料的黏彈性和黏塑性將會導致傳感器的滯后和漂移誤差.然而,在相對穩定的環境下,軟黏合劑對傳感器的影響可以忽略.此外,詳細的設計和過程信息有助於提高模型的適用性
  7. Several kinds of fire detonator and stab detonator are tested by this new measurement system, and the test results show that the syst em has characteristics of good stability, high sensitivity and veracity on the detonator output and can reflect the change of charge and configuration very well

    本文利用油應變測試系統對多種火雷管和針刺雷管進行了測試,測試結果明該測試系統具有穩定性好、靈敏度高、測試準確的特點,能夠反映雷管裝藥量及裝藥結構的變化,並為提供雷管合格判據奠定了基礎。
  8. Differential pressure gauges with electrical alarm contacts or electrical output are suitable for controlling or regulating process sequences with the aid of the process pressure

    帶有電警報接點或電子的差動式能根據生產控制或調節工藝步驟。
  9. Author has investigated the air - volume affect the pressure oscillation in piping system from converse viewpoint. when the structure parameters of the air - volume are some certain value, the pressure oscillation in the exit of the piping system is magnified. this idea makes us a new way to design the power source of high pressure water - jet

    研究明:當設計的空氣室結構參數(空氣室的容積,安裝位置等)取某組數值時,管道口端的波動幅值遠大於系統波動幅值,從而為設計高脈沖水射流的動源提供了一條新的思路。
  10. The paper establishes a risk management model for natural gas stations based on risk theory and risk assessment model, takes into account the real working conditions and technical specifications of natural gas stations in our country, carries on the assessment from nine aspects, and presents the risk standard, the acceptable criterion, and the suggestive measures to control these risks

    摘要以風險管理技術和風險評價模型為基礎,結合我國天然氣氣站場設計、施工、運行時的工況,遵循我國氣站場技術標準和安全規范,建立氣站場的風險管理模型,包括氣站場位置及環境、站內埋地管道、地面設備、運轉設備、站內閥門、儀器儀、工藝流程、站內甲烷泄漏、站場安全系統等9個部分,提氣站場風險標準及可接受性準則,給了風險控制的措施。
  11. The expression can be used in calculation for relationships of the input voltage, output voltage and device geometry parameter

    用漸近解的分析方法對所求到的解進行簡化,導了硅橫向阻效應四端傳感器的達式。
  12. Overpressures up to 40 bar at 500 litres min can be detected with the membrane measuring element and output in easily readable form

    膜片式測量元件可以測量500升分鐘流量下最高達40 bar的過,並將測量結果以便於閱讀的格形式
  13. According to ordering information table confirms the transmitter model, and appoints such as pressure scope, output mode and basic structure member material of the transmitter

    根據訂貨信息確定變送器的型號,指定如范圍,方式和變送器基本的結構件材料等。
  14. The experimental results showed that under certain conditions of preloaded press and bias magnetic field, a satisfied static characteristic was obtained

    試驗結果明超磁致伸縮致動器在合適的偏置磁場及預作用下,能達到較佳的電流-位移及電流-響應特性。
  15. It with five independent relay contact outputs may direct replace the ? pressure meter of electric contact

    帶五個獨立繼電器接點可直接替代電接點
  16. Note 2 : pressure transmit controller with five independent relay contact output may direct replace electric contact pressure meternote 3 : one screen displays pressure value, the other displays alarm value

    注2 :變送控制器帶五個獨立繼電器接點,可直接替代電接點
  17. All stainless steel differential pressure gauges with electrical alarm contacts or current outputs, with or without liquid filling, accuracy class 1. 6, nominal size nd 100 160

    全不銹鋼差動式,帶有電警報接點或電流,有或沒有充液,精確等級1 . 6 ,標準尺寸徑100 160
  18. Model 2700 2710 all stainless steel differential pressure gauges with electrical alarm contacts or current outputs, with or without liquid filling, accuracy class 1. 6, nominal size nd 100 160

    全不銹鋼差動式,帶有電警報接點或電流,有或沒有充液,精確等級1 . 6 ,標準尺寸徑100 160
  19. Differential pressure gauges with diaphragm for the chemical industry, with or without damping, with or without electrical alarm contacts, with or without electrical output, nominal size nd 100 160

    膜片式差動式,適用於化學工業,有或沒有潤滑,帶或不帶電警報接點,有或沒有電子,標準尺寸徑100 160
  20. The measured output pressure was close to the designed value, which indicate that using the calculated value and experimental data to guide the designation of the combustion pot is reasonable and practical

    實驗結果明,燃氣做功元件的最大的實測值與理論設計值接近,明採用vlwr狀態方程方法和密閉爆發器實驗結果指導燃氣做功元件裝藥設計是可行的。
分享友人