輻射式加熱 的英文怎麼說

中文拼音 [shèshìjiā]
輻射式加熱 英文
panel heating
  • : 名詞(車輪中車轂和輪圈的連接物) spoke
  • : Ⅰ動詞1 (用推力或彈力送出) shoot; fire 2 (液體受到壓力迅速擠出) discharge in a jet 3 (放出) ...
  • : 名詞1 (樣式) type; style 2 (格式) pattern; form 3 (儀式; 典禮) ceremony; ritual 4 (自然科...
  • 輻射 : radiation; exposure; radio; beaming
  1. In section one, by using fice scheme and time - gcm, a model of trace gases and oh airglow affected by gravity wave is set up, then the propagation of nonlinear gravity wave and the effect on trace gases and oh airglow are analyzed. the result shows gravity wave excited by tropospause forcing can propagate stably to the mesosphere through the stratosphere so that energy and momentum can be transferred from one region to another. in this process, gravity wave undergoes growth, overturning, convection and breaking

    在第一部分的工作中,利用全隱歐拉格和全球層-電離層-中間層-電動力學環流耦合模( time - gcm ) ,對重力波的非線性傳播及其在傳播過程中對中高層大氣中氧族和氫族成分和與之密切相關的oh氣輝的影響進行了數值模擬,結果表明,從對流層向上傳播的重力波經歷了產生、發展、飽和、對流產生直至破碎的非線性演化,大氣的非等溫結構速了重力波在中層頂區的破碎,重力波的非線性傳播是小尺度對流和湍流產生的一個重要的源。
  2. Also, they were favor for further explanations and canalization. the results of solar heating rate and infrared cooling rate and the model output were displayed as data forms and curves in the paper

    文中將率和冷卻率的計算結果以及與之相關的模計算結果(可見光波段的大氣收支和紅外波段的大氣收支)以數據表和曲線圖的形列出。
  3. We specialize in manufacturing & developing the high efficiency self recuperative gas burners, which are widely used in direct heating and the radiant tube in various industrial heat treatment furnaces

    本公司專業生產和開發高效率空氣自身預燒嘴,廣泛應用於各種工業處理爐的明火或
  4. Standard guide for installation of gypsum products in concealed radiant ceiling heating systems

    隱蔽天花板系統中石膏製品安裝的標準指南
  5. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對爐幾種工況進行力計算、冷態試驗的流場分佈及阻力測定和態試驗的爐膛溫度場分佈及管壁溫度等參數的測定,確定將管爐爐膛內直流燃燒改為旋流場燃燒和增筒,增設煙氣含氧量分析,可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下,極好地改善爐膛內的燃燒狀況和對流效果,從而降低排煙溫度45 ,減少爐排煙損失,節約了煤氣量6 %以上。
  6. Single burner gas - fired overhead radiant tube heaters - part 1 : safety ; german version en 416 - 1 : 1999

    單燃燒器燃氣頂置器.第1部分:安全
  7. Multi - burner gas - fired overhead radiant tube heater systems for non - domestic use - part 3 : system f, safety

    非家用多燃燒器的燃氣架空器系統.第3部分:系統f .安全
  8. Multi - burner gas - fired overhead radiant tube heater systems for non - domestic use - part 2 : system e, safety

    非家用多燃燒器的燃氣架空器系統.第2部分:系統e .安全
  9. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管負荷和效率低的狀況,提出了若干技術改造措施包括,增大對流管表面積以增大對流段的負荷;增管的換面積;修正煙囪高度;換用新型燃燒器,變自然通風為強制供風,以增大燃燒器的發量,減小過剩空氣系數,節省燃料2 % 3 % ;在對流段和煙囪之間增設空氣預器以提高空氣入爐溫度;採用高溫塗料增強效果,從而增源對爐壁的量和爐管的傳量等。
  10. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管負荷和效率低的狀況,提出了若干技術改造措施包括,增大對流管表面積以增大對流段的負荷;增管的換面積;修正煙囪高度;換用新型燃燒器,變自然通風為強制供風,以增大燃燒器的發量,減小過剩空氣系數,節省燃料2 % 3 % ;在對流段和煙囪之間增設空氣預器以提高空氣入爐溫度;採用高溫塗料增強效果,從而增源對爐壁的量和爐管的傳量等。
  11. Multi burner gas - fired overhead radiant tube heater systems for non - domestic use - part 1 : system d, safety ; german version en 777 - 1 : 1999 a1 : 2001 a2 : 2001 a3 : 2002

    非家用架空多用燃氣爐器系統.第1部分: d
  12. Multi burner gas - fired overhead radiant tube heater systems for non - domestic use - part 2 : system e, safety ; german version en 777 - 2 : 1999 a1 : 2001 a2 : 2001 a3 : 2002

    非家用架空多用燃氣爐器系統.第2部分: e
  13. Multi burner gas - fired overhead radiant tube heater systems for non - domestic use - part 3 : system f, safety ; german version en 777 - 3 : 1999 a1 : 2001 a2 : 2001 a3 : 2002

    非家用架空多用燃氣爐器系統.第3部分: f
  14. Multi burner gas - fired overhead radiant tube heater systems for non - domestic use - part 4 : system h, safety ; german version en 777 - 4 : 1999 a1 : 2001 a2 : 2001 a3 : 2002

    非家用架空多用燃氣爐器系統.第4部分: h
  15. Single burner gas fired overhead radiant tube heaters and non - domestic gas - fired overhead luminous radiant heaters - requirements and test methods for establishing the rational use of energy - radiometric method c

    單端燃燒器燃氣頂置器和非家用燃氣頂置光器.確定合理使用能量的要求和試驗方法.測量法c
  16. Single burner gas fired overhead radiant tube heaters and non - domestic gas - fired overhead luminous radiant heaters - requirements and test methods for establishing the rational use of energy - radiometric method a

    單端燃燒器燃氣頂置器和非家用燃氣頂置光器.確定合理使用能量的要求和試驗方法.測量法a
  17. Single burner gas fired overhead radiant tube heaters and non - domestic gas - fired overhead luminous radiant heaters - requirements and test methods for establishing the rational use of energy - radiometric method b

    單端燃燒器燃氣的頂置器和非家用燃氣的光輻射式加熱器.確定合理使用能量的要求和試驗方法.測量法b
  18. Single burner gas fired overhead radiant tube heaters and non - domestic gas - fired overhead luminous radiant heaters. requirements and test methods for establishing the rational use of energy. radiometric method a

    燃氣單噴嘴裝于頂部的幅器和非家用燃氣裝于頂部的發光幅器.制定合理使用能源的要求和試驗方法.測量法a
  19. Single burner gas fired overhead radiant tube heaters and non - domestic gas - fired overhead luminous radiant heaters. requirements and test methods for establishing the rational use of energy. radiometric method c

    燃氣單噴嘴裝于頂部的器和非家用燃氣裝于頂部的發光器.建立合理使用能源的要求和試驗方法.測量方法c
  20. Single burner gas fired overhead radiant tube heaters and non - domestic gas - fired overhead luminous radiant heaters. requirements and test methods for establishing the rational use of energy. radiometric method b

    燃氣單噴嘴裝于頂部的幅器和非家用燃氣裝于頂部的發光幅器.建立合理使用能源的要求和試驗方法.測量方法b
分享友人