輻射管爐 的英文怎麼說
中文拼音 [fúshèguǎnlú]
輻射管爐
英文
radiant tube furnace-
It is designed according to electrical stove or microwave oven request. heating pipe adopts high temperature resistance mgo powder as the insulation medium and the stainless steel case is passed oxidation deal through the advanced web band protection oven 1050c in order to become the a special oxidation layer and improve the high temperature oxidation and bittern corrosive performance of the heating pipe. the heating tube has high power density and strong heat radion. this product with good safe performance can work normally after 3000hrs life test
加熱管選用耐高溫氧化鎂作絕緣介質,不銹鋼外殼經過先進的網帶氣體保護爐1050的氧化處理,形成一種特殊的氧化層,提高電熱管的抗高溫氧化及鹽鹵的腐蝕性能。電熱管的功率密度較高,熱輻射能力強。產品經長達3000h的壽命試驗后,仍能正常工作,安全性能好。We specialize in manufacturing & developing the high efficiency self recuperative gas burners, which are widely used in direct heating and the radiant tube in various industrial heat treatment furnaces
本公司專業生產和開發高效率空氣自身預熱式燒嘴,廣泛應用於各種工業熱處理爐的明火或輻射管加熱After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %
摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定,確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒,增設煙氣含氧量分析,可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下,極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果,從而降低排煙溫度45 ,減少加熱爐排煙損失,節約了煤氣量6 %以上。The new device consists of paint - drying box, heat carrier boiler, heating pipe, expansion tank, gas separator and oil tank, etc. the data of two applied examples shows that heat carrier paint drying method is able to make painting - drying cost drop by 88 %, compared with the conventional one, that it has some advantages such as uniform temperature field, good appearance and lower costs, compared with conventional hot air convection mode
該裝置主要由熱載體烤漆爐、輻射加熱管,熱載體爐、膨脹器、油氣分離器和儲油槽等組成。應用實例的測試數據表明,與傳統的遠紅外電加熱鋼瓶烤漆方式相比較,鋼瓶熱載體烤漆節能和降低能耗費用十分顯著,能耗費用降幅達到88 。與熱風爐對流烤漆方式相比較,熱載體烤漆方法不僅節能,而且烤漆爐溫度場均勻穩定,同時烤漆的外觀質量也得到了明顯提高。Production test of the production line is showed that anneal furnace combustion system with regenerative radiant - tube combustor compare with conventional radiant tube burner not only have superiorities on saving energy and environmental protection but also have advantages on temperature distribution and temperature control properties
生產線試生產的情況表明,退火爐燃燒系統使用蓄熱式輻射管燃燒器比使用常規輻射管燃燒器不僅在節能、環保方面具有優勢,而且在加熱均勻性和爐溫控制方面也有一定優越性。Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging
文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況,提出了若干技術改造措施包括,增大對流管表面積以增大對流段的熱負荷;增加輻射管的換熱面積;修正煙囪高度;換用新型燃燒器,變自然通風為強制供風,以增大燃燒器的發熱量,減小過剩空氣系數,節省燃料2 % 3 % ;在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度;採用高溫輻射塗料增強輻射換熱效果,從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging
針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況,提出了若干技術改造措施包括,增大對流管表面積以增大對流段的熱負荷;增加輻射管的換熱面積;修正煙囪高度;換用新型燃燒器,變自然通風為強制供風,以增大燃燒器的發熱量,減小過剩空氣系數,節省燃料2 % 3 % ;在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度;採用高溫輻射塗料增強輻射換熱效果,從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。For example, heating of the air could be a duct mounted hot water coil, duct mounted electric elements, duct mounted gas fired burner, reverse cycle air conditioning unit, room mounted panel radiator etc
例如,空氣加熱的方式有:通過熱水盤管風管送風,電加熱風管送風,燃油鍋爐取暖風管送風,製冷逆循環機組制熱,地板輻射採暖,等等。Multi burner gas - fired overhead radiant tube heater systems for non - domestic use - part 1 : system d, safety ; german version en 777 - 1 : 1999 a1 : 2001 a2 : 2001 a3 : 2002
非家用架空式多用燃氣爐輻射管加熱器系統.第1部分: dMulti burner gas - fired overhead radiant tube heater systems for non - domestic use - part 2 : system e, safety ; german version en 777 - 2 : 1999 a1 : 2001 a2 : 2001 a3 : 2002
非家用架空式多用燃氣爐輻射管加熱器系統.第2部分: eMulti burner gas - fired overhead radiant tube heater systems for non - domestic use - part 3 : system f, safety ; german version en 777 - 3 : 1999 a1 : 2001 a2 : 2001 a3 : 2002
非家用架空式多用燃氣爐輻射管加熱器系統.第3部分: fMulti burner gas - fired overhead radiant tube heater systems for non - domestic use - part 4 : system h, safety ; german version en 777 - 4 : 1999 a1 : 2001 a2 : 2001 a3 : 2002
非家用架空式多用燃氣爐輻射管加熱器系統.第4部分: hThe heater is cooking heat source in the microwave oven. generally 2 pcs. as one suite in series and the power of single tube is 400w 600w. bigger surface load and higher radiating coefficient make the microwave cooking food more quickly
本加熱器在微波爐中為燒烤熱源,一般一組為2隻串聯使用,單管功率一般為400w600w ,表示負荷較大,且石英管表示的熱輻射系數高,使微波爐燒烤食物更加快捷。分享友人