輻射電熱器 的英文怎麼說

中文拼音 [fúshèdiànrèqì]
輻射電熱器 英文
electric radiant heater
  • 輻 : 名詞（車輪中車轂和輪圈的連接物） spoke
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 輻射 : radiation; exposure; radio; beaming
  1. Hourly values of global solar radiation are measured at king s park by a thermoelectric pyranometer sealed thermo - pile dome solarimeter together with an integrating counter. a bimetallic actinograph is used as a back - up

    利用一具熱電總日射表球形罩封密的溫差電堆總日射表連同累積計數器，天文臺可以量度每小時的太陽總輻射數量。
  2. Hourly values of global solar radiation are measured at king s park by a thermoelectric pyranometer ( sealed thermo - pile dome solarimeter ) together with an integrating counter. a bimetallic actinograph is used as a back - up

    利用一具熱電總日射表（球形罩封密的溫差電堆總日射表）連同累積計數器，天文臺可以量度每小時的太陽總輻射數量。
  3. Bolometers and pyroelectric detectors are the most common thermal detectores in uncooled ir sensors technolgy

    非製冷熱成像探測器目前以微測輻射熱計和熱釋電探測器為主流。
  4. As one of the most important applications, cmr bolometer is fabricated using the lacamno3 films, which has a metal - insulator transition temperature at 300k. the archetypal bolometer is fabricated after the film is photolithographed, evaporated au electrodes and fixed

    以製作室溫超巨磁電阻測輻射熱儀為目標，將t _ （ mt ） 300k ， tcr 5的薄膜進行光刻、電極製作、封裝等處理製作測輻射熱儀原型器件。
  5. Plastics - simple heat release test using a conical radiant heater and a thermopile detector

    塑料.用錐形輻射加熱器和熱電堆探測器進行簡單熱釋放試驗
  6. As the microbolometer which is voltage biased express some characters different from other infrared detectors under the effect of electric heat and infrared radiation together, the computing method of parameters, such as responsivity, noise, noise equivalent temperature different ( netd ), noise equivalent power ( nep ), optical gain, detectivity and so on is given in this paper. some of these parameters are particular compared with other detectors, and some have difference between microbolometer and other detectors

    由於微測輻射熱計在施加偏置電壓的情況下，電熱效應與紅外輻射的共同作用使它表現出與其他紅外探測器完全不同的一些特徵，文中給出了響應率、噪聲、噪聲等效功率、噪聲等效溫差、光學增益、探測率等參數的計算方法，這些參數中的部分是微測輻射熱計獨有的，或者與其他的紅外探測器的同一參數有所區別。
  7. The resistivity of the films drops compared with the as - grown films, but the temperature of maximum magnetoresistance reaches 287k, very close to the room temperature. therefore it is not only an important improvement to fabricate the cmr bolometer which can work near room temperature, but also a prospective research for other applications such as magnetic - sensors, spintronics devices and infrared detectors

    同時，退火后薄膜的電阻率明顯下降，外加5t磁場時，最大磁電阻率溫度點上升到287k ，接近於室溫，這不僅為製作室溫超巨磁電阻測輻射熱儀打下了堅實的基礎，也為其它許多器件的應用提供了可能。
  8. This text draws the basic principle of infrared diagnoses based on the primary knowledge of infrared radiation, and analyse the imaging principle of infrared devices ; from the view of infrared diagnostic technology we discuss the fault models and the principium of infrared diagnosis on electrical equipments ; then this paper research the diagnosis of electrical equipments fault by using infrared devices, obtain the hot picture atlas of equipment fault and analysis the hot picture atlas ; the text analyse the various kinds of possible factor which might effect the results of infrared diagnosing in electrical equipments, and propose correspondingly countermeasure against these factor in order to improve the accuracy of measurement ; finally, by using infrared diagnosing techniques analyse and diagnose the interior or exterior fault in part of transformers and arresters in electric network of si chuan, and the results obtained from the text accord with practice

    本文在紅外輻射的基礎知識上引出紅外診斷的基本原理，分析了紅外成像儀的成像原理；並從紅外診斷的角度研究了電氣設備的故障模式及其診斷的機理；研究了利用紅外熱像儀對電氣設備的故障進行診斷，獲取設備故障熱像圖譜並進行熱像圖譜的分析；對影響電氣設備紅外技術診斷結果的各種可能因素進行了分析探討，並針對這些干擾因數，提出了相應的對策，以提高檢測的準確性；論文最後應用紅外熱成像技術對四川電網中的部分變壓器和避雷器典型的內外部故障進行了診斷分析，得到與實際相符的結果。
  9. Featured by wide band gap, high breakage electric field, high electron mobility, low dielectric constant, strong irradiation proof and excellent chemical stability, silicon carbide ( sic ), viewed as one of the most promising wide band gap semiconductors, is widely utilized in optoelectronic devices, high frequency and large power, high temperature electronic devices

    被譽為最有潛力的寬禁帶半導體材料一sic ，因其具有禁帶寬度大、擊穿電場高、熱導率大、電子飽和漂移速度高、介電常數小、抗輻射能力強、良好的化學穩定性等優異的特性，被廣泛地應用於光電器件、高頻大功率、高溫電子器件。
  10. Plastics - simple heat release test using a conical radiant heater and a thermopile detector iso 13927 : 2001 ; german version en iso 13927 : 2003

    塑料.用錐形輻射加熱器和熱電堆探測器進行簡單熱釋放
  11. This project is focused on microbolometer fpa. this program includes the development design and simulation tools, material research, fabrication process development, and detector and readout circuitry design, fabrication and characterization. the work done in this paper is described as follows : the theory of microbolometer fpa is expounded

    課題的重點放在非致冷微測輻射熱計焦平面陣列，這種非致冷紅外產品的設計研製工作包括：設計和模擬工具的研究、材料選擇和器件製作工藝的研究、探測器和讀出電路的設計研究、真空封裝和性能表徵的研究等。
  12. The new device consists of paint - drying box, heat carrier boiler, heating pipe, expansion tank, gas separator and oil tank, etc. the data of two applied examples shows that heat carrier paint drying method is able to make painting - drying cost drop by 88 %, compared with the conventional one, that it has some advantages such as uniform temperature field, good appearance and lower costs, compared with conventional hot air convection mode

    該裝置主要由熱載體烤漆爐、輻射加熱管，熱載體爐、膨脹器、油氣分離器和儲油槽等組成。應用實例的測試數據表明，與傳統的遠紅外電加熱鋼瓶烤漆方式相比較，鋼瓶熱載體烤漆節能和降低能耗費用十分顯著，能耗費用降幅達到88 。與熱風爐對流烤漆方式相比較，熱載體烤漆方法不僅節能，而且烤漆爐溫度場均勻穩定，同時烤漆的外觀質量也得到了明顯提高。
  13. Measuring method for insulation resistance of infrared heater

    紅外輻射加熱器絕緣電阻測量方法
  14. As umbirfpa is a new type of infrared detecting device, its work principle is complex and its performance is affected by many factors. in the initial stage of developing, the design experiment and theoretical understanding are little interiorly. furthermore, the problems such as sensitivity reduced, dynamic range shortened, nonuniformity increased come forth if umbirfpa is not designed properly

    Umbirfpa是一種新型的紅外探測器件，微測輻射熱計的工作原理復雜，其性能受到很多因素的影響，目前國內尚處于發展初期，缺少實際的設計經驗和理論認識，同時umbirfpa又是在集成電路工藝線上生產的，投資大、周期長，如果設計不當，不僅可能導致靈敏< wp = 13 >度降低、動態范圍縮小、噪聲增大、非均勻性增大等問題，更可能的是根本就不能用於成像，從而造成很大損失。
  15. Electric radiant heaters

    電輻射加熱器
  16. The main work is focused on the establishment of mathematic model for a microbolometer detector, in order to simulate the structure characteristic and the optical and electrical characteristics

    對微測輻射熱計陣列的探測器像元建立了數學模型，對其結構特性和光電特性進行計算機模擬模擬和優化設計。
  17. Tld standard practice for application of thermoluminescence - dosimetry systems for determining absorbed dose in radiation - hardness testing of electronic devices

    電子器件輻射硬化試驗中測量吸收劑量用的熱致發光劑量測量
  18. Basic function : heat source is anti - blast infrared - tube made of microcrystal quartz ;, continuosly variable mattress tilt, radiant head can two - directory rotate on horizon, x - ray cassette shelf under infant bed ; high - bright erdiate lamp detect lightness ; advanced microprocessor control temperature system, auto - heated mode, separately display set temperature and real temperature ; 4sound - light alarm capacity : set - off, fan, sensor, over temp.

    基本配置：採用了防爆型微晶石英紅外管作輻射熱源，嬰兒床斜傾角度有級可調，輻射頭可在水平位置上雙向隨意轉動，嬰兒床下內設有x光暗盒架，檢查照明採用高照度射燈，溫度控制系統採用先進的計算機控制，自動加熱方式，設定溫度和實際溫度分屏顯示，有四種聲光報警功能（溫度上下偏差、傳感器、斷電、超溫） 。
  19. Basic function : heat source is anti - blast infrared - tube made of microcrystal quartz ; continuously variable mattress tilt, radiant head can two - directory rotate on horizon, x - ray cassette shelf under infant bed ; high - bright eradiate lamp detect lightness ; advanced microprocessor control temperature system, autoheated mode, separately display set temperature and real temperature ; 4 sound - light alarm capacity ; set - off, sensor, over temp

    基本配置：採用了防爆型微晶石英紅外管作輻射熱源，嬰兒床傾斜度有級可調，輻射頭可在水平位置上雙向隨意轉動，嬰兒床下內設有x光暗盒架，檢查照明採用高照度射燈，溫度控制系統採用先進的計算機控制，自動加熱方式，設定溫度和實際溫度分屏顯示，有四種聲光報警功能（溫度上下偏差、傳感器、斷電、超溫） 。
  20. Because of its excellent properties, such as large band gap, high thermal conductivity and high breakdown electric field, sic is appropriate for the electronic devices which can operate at extremely high temperatures and high radiation

    Sic材料具有禁帶寬、熱導率高、臨界擊穿電場高等特性，特別適合高溫、強輻射等惡劣環境下工作的電子器件製造。
分享友人
分享到 Line

分享到臉書