轉接控制 的英文怎麼說

中文拼音 [zhuǎnjiēkòngzhì]
轉接控制 英文
switchover control
  • 轉 : 轉構詞成分。
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 轉接 : change-over; throw-over; switch; transfer; transit; reset; adapter coupling; built-up connection
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. In the prolegomenon, author makes a brief review on the history and technology development of hydraulic turn tables, their direct driving motors and their control systems

    文章在緒論部分簡明扼要回顧模擬轉臺、液壓模擬轉臺直接驅動伺服馬達及液壓模擬轉臺控制系統的發展概況、關鍵技術等。
  2. Basing on the analysis about the reason that how the superabundant torque appears, direct torque control strategy is used to realize the servo control of two asynchronous motors and load system ' s simulation. the measure method of superabundant torque of the system, the valid method of static state torque and the benchmark of dynamic torque are given by testifying the system ' s speediness through experiments

    在具體分析加載系統中多餘力產生原因的基礎上，採用直接轉矩控制策略，實現了兩臺異步電動機伺服控制和加載系統的負載模擬實驗，通過實驗驗證了系統的快速性；給出了系統多餘轉動慣量的測量、靜態轉矩的校驗和動態轉矩基準的實驗的基本方案。
  3. Permanent magnet synchronous motor ( pmsm ) drived by triphase sinusoidal current is research object in this paper. its mathematics models in several coordinate are set up, controlling principles of flux linkage and torque are discussed under dtc and the block diagram of pmsm with dtc is presented

    本文以三相正弦波驅動的永磁同步電機（ pmsm ）為研究對象，建立了其在不同坐標系下的數學模型，並深入探討直接轉矩控制中永磁同步電機的磁鏈和轉矩的控制思想，給出控制方案。
  4. In 1985, m. depenbrock proposed the direct torque control ( dtc ) method of asynchronous motor

    德國學者m . depenbrock在1985年針對異步電機提出了一種高性能電機控制方法?直接轉矩控制。
  5. The strategy of direct torque control is one of the variable frequency speed control scheme, which was developed in 1985 by prof. depenbrock and which was one of high performance control of induction motor drives after vector control

    1985年德國學者depenbrock提出了異步電動機的直接轉矩控制（ directtorquecontrol ）變頻調速思想， dtc是繼矢量控制之後發展起來的一種高性能交流調速技術。
  6. Research of dtc for doubly - fed wind generator

    雙饋風力發電機直接轉矩控制的研究
  7. On the basis of theory research, software and hardware design, the system experiment simulation in matlab toolbox is given, and the simulation results are analyzed and explained. the simulation results show the system has good static and dynamic performance

    在無速度傳感器直接轉矩控制系統理論研究和軟硬體設計的基礎上，利用matlab模擬工具箱完成了整個系統及各個部分的模擬，並對模擬結果進行了分析和說明。
  8. Stepping drive of synchronous motors, upgrading the design idea of stepping motors from combined electromagnet theory to rotary magnetic field theory, will make the capability and efficiency of the increment control system improved to a new level, which is the research purpose of ac step motion drive this paper begins with the direct torque control method for pmsm to expatiate ac step motion control theory distinctly

    用同步電動機實現步進傳動；將步進電動機的設計思想從組合電磁鐵理論提高為旋轉磁場，使增量運動系統的容量和效率發展到一個新的水平，這就是交流步進傳動的研究目的。為了比較清楚地闡述交流步進理論，本文首先從永磁同步電動機的直接轉矩控制演算法入手來分析。
  9. Simulation results showed that this control strategy can decrease the stator current anti improve the efficiency of the system

    模擬結果表明永磁同步電動機直接轉矩控制系統最大轉矩電流比控制可以降低定子電流，減小損耗，從而提高系統效率。
  10. In this paper, the maximum torque per ample ( mtpa ) control in permanent magnet synchronous motor ( pmsm ) direct torque control ( dtc ) driving system was studied

    摘要在永磁同步電動機直接轉矩控制和最大轉矩電流比控制理論基礎上，研究了永磁同步電動機直接轉矩控制驅動系統最大轉矩電流比控制的實現。
  11. According to the characteristics of dtc ( direct torque control ) in induction machine, this paper analyzed the estimation error of flux linkage and torque, and introduced an improved method of flux estimation, a compensation method based on low - pass filter

    摘要根據感應電機直接轉矩控制的特點，對低速下磁鏈觀測誤差產生的原因進行了分析，給出了一種磁鏈觀測的改進方法低通濾波器補償法。
  12. Finally a speed sensorless dtc system is carried out

    在此基礎上，實現了無速度傳感器的直接轉矩控制系統。
  13. Sensorless is a major feature of the pmsm dtc system

    無需速度傳感器反饋信號是本直接轉矩控制的一個優異的特性。
  14. The dtc system is a high - performance ac driving system. but conventional speed controller in dtc system is ped adjuster, which ca n ' t make the system have enough quick response, the ability to restrict the noise and strong robustness to the parameters of the system

    作為一種高性能的交流調速系統，在直接轉矩控制系統中，速度調節器通常都採用pid調節器，使得系統的快速性和抗干擾能力及對系統參數擾動的魯棒性不夠理想。
  15. In the paper, a speed estimator based on artificial neural network is designed according to the principle of direct torque control, the speed estimator is optimized by genetic algorithm, and the parameters of pid speed adjuster is also optimized by genetic algorithm. a stator linkage and torque observer based on stator resistance estimator using fuzzy neural network is also designed. eventually, the intelligent control of direct torque control system is implemented

    本文根據異步電動機直接轉矩控制原理，在應用人工神經網路進行速度辨識的基礎上，利用遺傳演算法對神經網路速度辨識器進行了優化設計；運用遺傳演算法對pid速度調節器的結構和參數進行了整合；在採用模糊神經網路對電機定子電阻辨識的基礎上，進行了定子磁鏈及轉矩的觀測，為最終實現無速度傳感器直接轉矩控制系統的智能控制創造了條件。
  16. The dissertation deals in details with the basic principle of direct torque control. according to the faults of traditional direct torque control and the requirement of an induction motor ' s control strategy change the method of regulating stator flux to make its path approximate to a circle as possible as could. to get quickly torque control, use a three - value regulator

    本論文介紹了電動機直接轉矩控制的基本原理，並根據傳統直接轉矩控制存在的缺點以及對電動機調速性能的要求，改變對定子磁鏈的調節方式，使定子磁鏈軌跡近似為一圓形，對轉矩採用三值調節器進行調節，以實現轉矩的快速調節。
  17. According to the faults of traditional direct torque control and the requirement of an induction motor ' s control strategy, the author changes the method of regulating stator flux to make its path approximate to a circle as possible as could and put forward a new way to use a three - value torque regulator

    本論文研究了異步電動機的數學模型，介紹了直接轉矩控制的基本原理，並根據傳統直接轉矩控制存在的缺點以及對電動機調速性能的要求，改變對定子磁鏈的調節方式，使定子磁鏈軌跡近似為一圓形。
  18. Furthermore intelligent shift control thinking and method are introduced detailed, and the intelligence control of fuzzy neural network is led to construct the model of the speed control of engine, the model of decision of shift, the model of clutch joint velocity and the model of the whole amt gearshift, simulation is carried out

    詳細地描述了智能換檔控制的思路和方法，引入模糊神經元網路智能控制技術，構造發動機轉速控制模型、檔位決策模型、離合器接合速度控制模型及amt換檔系統模型，並進行模擬模擬。
  19. The theory has been implemented and verified experimentally on two high performance pmsm dtc drive systems in the laboratories of department of electrical engineering, zhejiang university, china, and the centre for electrical machines and power electronics, university of technology, sydney, australia

    上述理論分別在浙江火學電機控制實驗室以及悉尼科技大學電機及電力電子中心的兩臺高性能永磁同步電機直接轉矩控制驅動系統上應用並實驗驗證。
  20. Direct torque control system and simulation of permanent magnet synchronous motor

    永磁同步電機直接轉矩控制系統和模擬
分享友人
分享到 Line

分享到臉書