轉速測量法 的英文怎麼說

中文拼音 [zhuǎnsùcèliángfǎ]
轉速測量法 英文
tachometric method
  • 轉 : 轉構詞成分。
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 轉速 : speed; revolution; rotation rate; speed of revolution; rotating speed; rotational speed轉速指示器...
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. A novel method measuring rotation speed based on linear ccd

    Ccd測量轉速的新方法
  2. However, it is necessary to acquire the antibody or the antiserum, which could specially react with the expression protein of die objective gene transferred into the transgenic plant according to the characteristics of high homology and immune cross - reaction among plant ferritin, using the special immune serum of pea ferritin, the content of plant ferritin could be detected for studing the ferritin expression of transgenic plant by the technique of immunoassay such as immunoprecipitation, eljsa and western blotting

    利用免疫檢測技術進行植物轉基因的表達檢測是一種簡單、靈敏、快速、可靠的方法，但其前提條件是要有與轉基因植物目的基因表達的蛋白質發生特異性免疫反應的抗體或抗血清。根據植物鐵蛋白之間有高度同源性和交叉免疫反應的特性，利用特異性的豌豆鐵蛋白抗血清，就可通過免疫沉澱、 elisa或western雜交等免疫檢測方法進行植物鐵蛋白含量等的檢測，從而更好地進行轉基因方面的研究。
  3. Experiments show that this method has high processing speed, low data quantity, great performance so, it ' s a good choice for large - capacity recognition applications. and it can work well even when the faces are acclivitous or with a little expression. as a research of obvious goal, we developed a prototype system named mandrill

    實驗證明，這種新的組合演算法具有速度快、特徵數據量小、識別率較高、適用於大數據量識別應用等特點，測試結果表明其在人臉有偏轉、有微量表情變化的情況下均具有較好的識別效果。
  4. A new method for measuring the muzzle velocity of multi - barrel rotary gun

    測量轉管炮炮口初速的一種新方法
  5. The numeric measurement of rotative velocity in the engine test

    發動機試驗中轉速的數字測量方法
  6. Based on refering to a great quantity of domestic and international data, this dissertation puts forward the standpoint that giving systematical diagnosis to mechanical and electrical equipment with the double turnplate strike crusher as example. by means of calculating critical rotation speed of inner turnplate, theory foundation is offered to the crusher ' s improvement. based on actual situation of the crusher, a portable observation and diagnosis system has also been developed on the basis of virtual instruments

    本文在查閱大量國內外文獻的基礎上，以雙轉盤沖擊破碎機為實例，提出了機電設備系統診斷的技術思路；通過計算內轉盤臨界轉速，為破碎機的改進提供了理論依據和方法；結合破碎機的實際使用情況，開發了性價比較高的、基於虛擬儀器技術的破碎機監測系統。
  7. Based on the correct evaluation of the means and covariance of the measurement error in cartesian coordinate system, the algorithm processes the radar measurements sequentially, and the linearization of measurement equation is no longer neccessary

    作者推導了有測速數據時的去偏轉換卡爾曼濾波演算法。此演算法估計精度和計算效率比以前的方法有較大改善，對測量方程不做近似處理。
  8. Exciting method is used to measure the damping, the four damping coefficients of the radial part and a damping coefficient of the thrust part can be obtained though hammering the testing bearing which is in a equilibrium position. based on the testing data, the dynamic characteristic curves of the radial - thrust floating ring hybrid bearing are drawn and compared with the theoretical curves

    採用激振法測量軸承的阻尼，對處于平衡位置的測試軸承分別沿水平方向、上45度方向及軸向進行錘擊，根據錘擊法原理求得各個轉速下軸承徑向部分內、外膜總阻尼系數以及推力部分內、外膜總阻尼系數。
  9. Aiming at the study actuality of fan performance monitoring system and analysis of fan performance curve changes affected by inlet - box and the different fixed - angles of guide blades in the course of installation, a fan flow monitoring model based on rbfnn in whole flow zone was established in this thesis. in the model, the method of no throttle and fan performance curve were used as basis. and on the basis of that model, fan performance curves of 4 - 73no. 8d were approached with experimental data of different speed, different opening - angles of guide blade and different resistance of pipeline, the precision and the error law of model were studied

    本文針對電站風機性能監測系統研究較少的現狀，在實驗的基礎上分析了現場加裝進氣箱和由於安裝造成的導流器葉片開度不一致對風機性能曲線的影響，並在此基礎上採用無節流方法測量流量，以風機調節性能曲線為依據，建立了基於徑向基函數（ rbf ）神經網路的風機流量全程監測模型；以實驗室4 - 73no . 8d離心風機為研究對象，探討了rbf神經網路差壓模型在變轉速、變導流器開度和變管網阻力等工況下的應用精度和誤差分佈規律；最後用visualc + +語言開發了風機性能在線監測系統。
  10. Firstly, based on the analysis of the principle of the capacitor discharge ignition system in the gasline engine and the characteristics of ignition parameters in the gasline engine, the author proposes the methods of ignition parameters measurement, including the speed of the gasline engine, ignition advance angle, ignition voltage, ignition current and igniton energy

    首先，在認真分析汽油機電容放電點火系統的工作原理及其點火參數的特性的基礎上，提出了汽油機轉速、點火提前角、點火電壓、點火電流和點火能量的測量方法。
  11. So they can not be used in on - line fault detection and condition monitoring. and the explanation of the time - frequency analysis is not easily accepted by the engineers. the experimental factors, such as rotational speed and measured position and fault distribution a

    文中還針對轉速、測點位置、故障分佈（位置） 、負載等因素對頻譜分析、包絡分析、時延相關解調等方法的診斷效果進行了大量的實驗研究。
  12. Based on many references form civil and abroad, the author mainly studies the measurment theory and method for flux, raising height, axial power and rotational velocity. avoiding many complicated and intermediate courses for power wastage analysis, introduces the electric measurement and using efficiency curve of motor in measureing axial power, and satisfies the automatization of the device. the paper also provides a new method, inductive winding, in measuring rotational velocity of electromotor, supplys limitations of other method in measuring rotational velocity of electromotor in water, and meet practical needs in developing diving electric pump for corporation

    作者在參閱大量國內外有關文獻，著重探討了水泵流量、揚程、軸功率、轉速的測試原理和測試方法，提出了採用電測法並結合電機效率特性曲線測量水泵軸功率，從而避免了損耗分析法中大量復雜的中間過程，滿足了試驗裝置的自動化測量要求；採用漏磁感應線圈法測量電機轉速，彌補了其它轉速測量方法對水下電機測試的局限性，適應了萊恩公司開發潛水電泵的實際需要。
  13. It introduces a precision and quick way to check proper alignment of rotating reel shaft in ship unloader with the gearbox output shaft

    摘要介紹1種可以高精度、快速測量碼頭卸船機捲筒旋轉軸與齒輪箱輸出軸對中的方法。
  14. In the time - domain, based on the principle of random sampling of dso. two way ( " time amplifing in dual slope integral " and " time - voltage convert " ) are implemented to measure the time between the system triger and writing clock. thus random sampling interpolate can be done to measure repeated signal in high frequency with the a / d convert and controller which frequency are lower

    在時域，根據數字示波器隨機取樣原理，用兩種方法（雙斜率積分時間放大測量方法和時間? ?電壓轉換測量方法）測量數字示波器系統觸發和采樣寫時鐘間時間間隔，用低速a / d轉換器及控制器進行模?數轉換和控制，以此進行隨機取樣內插，從而實現了對高頻率重復信號的測量。
  15. In addition, describes the trouble diagnosis of catalytic converter by using the comparing method of double waste - gases, the comparing method of cold and heat idle speed, the temperature differential method in idle speed, the vacuum measuring method and etc

    另外，闡述了利用兩次廢氣對比法、冷熱怠速對比法、怠速溫差法及真空測量法等方法對催化轉化器的故障診斷。
  16. The measuring method of low rotate speed of flying missile

    導彈飛行低轉速測量方法研究
  17. Firstly, i present a new structure of torque measurement ? rating torque sensor. secondly, introduce the fundamental principle of the dynamic torque. and then bring forward new methods of measuring flywheel moment and acceleration, which has been proved not only by theory, but also by experiment

    本文首先提出了轉矩測量的一種新結構? ?光柵靜態（平均）轉矩測量傳感器；然後闡述了動態轉矩測量的基本原理；接著提出了新的飛輪矩與加速度測量方法，並對其進行了理論推導及實驗證明；最後對提出的通用轉矩測量系統進行了硬體、軟體上的設計。
  18. A new method of measuring the rotation rate of cartridges is established to improve the precision of measurement of cartridge rotation rate by a long way

    提出新的彈丸轉速測量方法，大幅度提高彈丸轉速測量精度，並通過實例測量驗證其能滿足測試要求。
  19. Through the studies in the paper, especially the measurements of axial power, rotational velocity, error analysis and data processing can provide practical significance in improving the precision and automatization of the pump device

    通過本論文的研究工作，尤其所採用的軸功率、轉速測量方法、精度分析和數據處理，對今後提高水泵測試系統的精度及自動化程度具有實際意義。
  20. Finally the design of the general measuring system for torque has been finished. in this paper, i propose a general measuring system for torque and introduce it with five parts as follows : 1. research on the principle of torque measurement and analysis of the actualities of traditional instruments of torque at home and abroad

    針對提出的通用轉矩測量系統，本文主要在以下幾個方面做了工作：一、轉矩測量原理的研究，轉矩測量國內外現狀的分析；二、光柵轉矩傳感器的設計；三、飛輪矩與加速度測量新方法的提出；四、傳感器介面板晶元的設計和研製；五、轉矩測量軟體的編程及實現。
分享友人
分享到 Line

分享到臉書