逆解析 的英文怎麼說

中文拼音 [nìjiěxī]
逆解析 英文
inversion analysis
  • 逆 : Ⅰ形容詞1 （方向相反） contrary; counter 2 [數學] inverse; converse Ⅱ動詞1 （抵觸; 不順從） go aga...
  • 解 : 解動詞（解送） send under guard
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  • 解析 : analysis; resolution; analyzing; resolving解析幾何 [數學] analytic geometry; cartesian geometry; ...
  1. Modeling : this thesis develops a method different from traditional techniques that begins with the cylindrical projection of a generic model and its seamless global texture map using multiresolution technique, and then automatically fit the unwrapped cylindrical projected mesh to the texture map with an improved algorithm that based on 2d morphing to specify corresponding feature points ( or lines ). finally, we propose a formula of inverse cylindrical projection to recompose the deformed mesh, and after the texture mapping a photo - realistic individual facial model is created

    採用多解析度技術構造紋理無縫拼接圖，然後把三維網格模型投影到圓柱面上並展開，根據二維圖象變形技術中特徵點匹配演算法的數學思想，將匹配公式進行改進后應用於模型網格點的適配，在作了一定假設后推導出逆向圓柱映射的計算公式，再將適配后的柱面網格映射回去，最後進行紋理映射生成真實感的特定人臉的三維模型。
  2. The best scheme was chosen after analysis and comparing and the structure was designed. at same time, the kinematics analysis was conducted, coordinate transformation matrix using d - h method was set up, and the kinematics equation direct solution and inverse solution was deduced, the velocity jacobian matrix was constructed using vector product method, and the values of displacement and velocity of some special point including the wrist point were calculated. secondly, the working space of the robot was analyzed and the axes section of practical working space was drawn

    首先，作者針對機器人的設計要求提出了多個方案，對其進行分析比較，選擇其中最優的方案進行了結構設計；同時進行了運動學分析，用d - h方法建立了坐標變換矩陣，推算了運動方程的正、逆解；用矢量積法推導了速度雅可比矩陣，並計算了包括腕點在內的一些點的位移和速度；然後藉助坐標變換矩陣進行工作空間分析，作出了實際工作空間的軸剖面。
  3. Isar transmits wide bandwidth signals to obtain high range resolution. the cross - range resolution is obtained by the doppler frequency information of the target ’ s rotation

    逆合成孔徑雷達通過發射大帶寬信號獲得好的距離解析度，利用目標相對于雷達的轉動產生多普勒頻率梯度來獲取好的方位向分辨力。
  4. A general stack equation of mobile robot based on analyzing the motion of planar motion object and the mathematical models of four different kinds of common wheels is developed, accordingly, the mobility of mobile robot is addressed and the forward and inverse solutions to speed for specific configuration driven by differential speed are derived. utilizing the muir and newman convention, the description of the posture transformation matrices between different coordinate frames and the solution for the speed of point located on these frames are introduced. according to posture estimation, a more accurate method, dead reckoning algorithm, is developed for a specified configuration characterized by differential speed motorization, and simulations of this algorithm and other traditional methods are carried out using matlab while traversing a circular path

    本文對兩輪差速驅動移動機器人的運動學及其本體緩沖設計進行了探討，在對平面運動物體運動分析的基礎上結合四種常用車輪的數學模型，推導出了一個通用的移動機器人堆積方程，在此基礎上分析了移動機器人的移動能力、並針對兩輪差速構型推導了速度正解與逆解；使用muir和newman的運動學建模方法，推導了移動機器人上點及連桿坐標系位姿、速度變換關系矩陣及求解方法；在移動機器人位姿識別方法中結合差速驅動構型對航位推演算法進行了分析：推導了一種理論精度較高的航位推算演算法，並使用matlab對其與傳統的推算演算法在跟蹤圓弧軌跡情況下進行了模擬；最後針對本文所研究的機器人給出了一種比較系統、可靠的緩沖結構設計思路，較好地解決了移動機器人作業過程中外界因素及本身設計中引入的各種不確定誤差問題；本論文研究成果已在本實驗室所開發的樣機上得到實現，經過應用與考核證明其中的分析與設計是切實可行的。
  5. Analysis on cause of sino - us trade deficit

    中美貿易逆差成因解析
  6. In audio robust watermark algorithm, watermark is embedded in transform domain by using the speediness, simplicity and multi - resolution of wavelet transform. when extracting watermarking, the audio is decomposed by single - level discrete 1 - d wavelet transform, and watermarking is extracted by ica based on kurtosis maximization. this method ’ s computational cost is low

    音頻水印利用小波變換快速、簡單和多解析度的特點來嵌入水印，提取的時候，先對觀測音頻文件進行一級小波分解，然後用基於最大峰值的ica方法進行水印提取，這種方法避免了其他盲源分離方法必需的求逆運算，所以計算量小。
  7. Through the all - sided tectonic analyses, it can be deduced that there are two aspects will be the hidden defects to the dam and the engineering stability of the reservoir area. one is the dislocation interfaces resulting from the the majiaheba faultage ' s thrusting overriding and other causes of formation. the second is the region of strong deformation, such as the above of the dam, middle and high positions of the lava layers and the regions of overprint of the structure of ne to the one of nw, which should be taken into account especially

    通過區域和壩區錯動帶的全面構造解析，認為由馬家河壩斷層逆沖推覆作用而在壩區形成的向金沙江下游緩傾的錯動帶以及其它成因的錯動帶是壩區和庫區工程穩定的隱患，尤其是變形較強的壩址區上游區、中高層位以及北西向構造期的錯動帶疊加於北東向構造期錯動帶的部位，更應該引起足夠的重視。
  8. Firstly, finite element model of lathe spindle using finite element technique is established, and supporting bearings are treated as springs, unknown physical parameters and partial vibration displacement make up of new solving vector through using method of combination of academic modeling and experiment, mathematic model of solving stiffness of beating of lathe spindle is established using inverse analysis method of response problem finally

    建立了機床主軸的有限元模型，將支承軸承簡化為支承彈簧，通過理論建模與實驗相結合的辦法，將待識別的物理參數和部分振動位移組成新的求解向量，利用響應問題的逆分析方法建立了求解主軸軸承剛度的數學模型。
  9. Analyses and establish the kinematic model, obtains the forword and inverse kinematic equation, and simulate the motion of grasping

    分析並建立了運動學模型，得出運動學正逆解方程，並對抓持狀態下各手指的運動姿態進行了模擬。
  10. The direct kinematics and inverse kinematics for the robot arms and dexterous hand have been analyzed respectively with geometric and analytical methods

    同時還運用解析法和幾何法分析了機械臂、靈巧手正逆運動學模型。
  11. A lot of experience data are used to define characteristic parameters, and analytical methods are adopted to solve inverse kinematics problem

    方法在定義運動的特徵參量時利用了大量的經驗數據，並且採用解析的方法求解逆運動學問題。
  12. Based on the theoretical expression of the average intensity in the fourier transforming and imaging optical system with variable aperture, an algorithm is developed to change the intensity data versus the aperture radius into the bessel - fourier - transform - and - the - inversion of a function of the height - height correlation function. three samples of gaussian correlation are used for the experimental demonstration

    在理論分析和實驗測量中，我們採用了變孔徑的傅立葉變換和成像系統，由所得到的像面光強的解析式，建立了將平均光強隨孔徑的數值變化關系轉化為正逆傅立葉變換對，從而恢復出表面的高度?高度相關函數。
  13. This thesis presents a footprint - editing algorithm based on analytical inverse kinematics ( ik )

    本文提出基於解析逆向運動學的足跡編輯演算法。
  14. Firstly, by the method of laplace transform, one dimensional consolidation of one - layer gibson soils under time - depend loading is studied and the analytical solutions in frequency domain are obtained. on the basis of the solutions obtained and the computation through programming, the influence of some parameters and loading conditions on the consolidation behavior under trapezoidal, triangular and rectangular cyclic loading, is investigated. secondly, one - dimensional consolidation of one - layered gibson soils with semi - pervious boundaries is studied in this paper, and according to numerical examples, some characters of consolidation such as the effective stress and settlement in the soils under arbitrary loading are found

    首先運用了laplase變換獲得了單層gibson地基（壓縮模量隨深度線性增加的地基）在任意荷載下頻域內的一維固結解析解，通過laplace逆變換，基於以上解答用數值方法編製程序對單層地基在常見荷載（驟加荷載、緩加荷載、矩形波載、三角形波載）作用下的一維固結性狀進行了討論，並與傳統的太沙基理論進行了比較。
  15. General pkm has no analytic positive solutions, which mirrors in the analysis of kinematic and dynamic. jacobian matrix can not be gained ; when solving the problem with the digital algorithm of gauss - elimination, the coefficient matrix of linear equations group is high degree illness

    一般並聯機構沒有解析正解，反映在運動和動力學分析過程中為無法求得雅可比矩陣；當採用高斯消去法的數值解法解雅可比矩陣的方程組或求逆時會發現系數矩陣是高度病態的。
  16. In this thesis cannon error of system is discussed carefully, and the error is separated and set up model. on the basis of these and dummy extending of duality multinomial fit, the dummy close ring which can revise the shooting error is set up. the dummy close ring is realized by the adversity means which can find the shooting error

    本文仔細分析、討論了火炮系統的誤差，作者對誤差進行了分離和建模，為虛擬閉環校射功能的實現提供了條件，在此和射表虛擬延伸的基礎上利用逆解法求取了射擊諸元誤差作者建立了虛擬閉環校射理論。
  17. According to the geometry model constructed in this paper, kinematics analysis, inverse kinematics with its optimization, analysis and calculation of dynamics are introduced. the resolution of matrix reverse transformation and gradient projection based on fake reverse matrix are used in the computation

    建立了該手腕的幾何模型，針對該模型展開了運動學分析、逆運動學解的計算，計算使用了矩陣逆變換的解析法和基於偽逆陣的梯度投影法兩種方法。
  18. Then, a semi - analytical solution for the velocity response of the pile subjected to a semi - sine wave exciting force was derived by using invert fourier transform

    利用付立葉逆變換，給出了半正弦脈沖激勵下樁頂速度時域響應半解析解。
  19. Thus the resistance factor and vibration modes of the soil layer are obtained and used to analysis the pile response. by considering the interaction between the soil layer and the pile with boundary condition of continuity of displacement and equilibrium of force at the interface of soil layer and pile, the dynamic equilibrium equation of pile is solved and an analytical solution for the pile response in frequency domain is yielded, which is used to define complex stiffness and mobility at the level of the pile head. based on the convolution theorem and inverse fourier transform, a semi - analytical solution of velocity response in time - domain subjected to a semi - sine exciting force is given

    首先通過引入勢函數方法對土體位移進行分解，從而將土體動力平衡方程解耦，求解得到了土層的振動模態和阻抗因子，然後利用該解以小應變條件下樁土接觸面上力平衡和位移連續條件來考慮樁土耦合作用，求解樁的動力平衡方程，得到了樁頂的頻域響應解析解、復剛度和速度導納，利用卷積定理和傅里葉逆變換，求得了半正弦脈沖激振力作用下樁頂速度時域響應半解析解。
  20. The inverse synthetic aperture radar ( isar ), which can provide an all - weather, day / night capability to generate high - resolution two - dimensional images of the targets for recognition over a long range, has played a more and more important role especially in military application

    逆合成孔徑雷達（ isar ）能全天時，全天候，遠距離提供運動目標的高解析度圖像，為敵我目標識別提供信息，具有重要的軍事意義。
分享友人
分享到 Line

分享到臉書