透鏡的合軸 的英文怎麼說

中文拼音 [tòujìngdegězhóu]
透鏡的合軸 英文
centring of a lens
  • 透 : Ⅰ動詞1 （滲透; 穿透） penetrate; pass [seep] through 2 （暗地裡告訴） tell secretly; let out; lea...
  • 鏡 : Ⅰ名詞1 （鏡子） looking glass; mirror 2 （幫助視力或做光學實驗的器具） lens; glass 3 （姓氏） a s...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 透鏡 : [物理學] lens; optical lens
  1. The holographic lens, which is designed according to bragg condition to eliminate aberrations, has both high efficiency and low aberration, and can be used in a certain narrow - band condition. a example and its results are also given in this paper

    該方法採用雙片離軸全息透鏡復合，按使用條件在布喇格條件下進行消三級像差設計，製作設計的全息透鏡具有高衍射效率高、像差小的特點，可以滿足任意給定的窄帶光場合。
  2. The outcome suggest that, firstly, the change of light transmission with the continuous change of parameters is periodic ; secondly, as far as the degree of effect is concerned, the light transmission of air - spaced prisms is much more sensitive to the change of the parameters than that of the glue spaced ones ; thirdly, as to the prisms glued with the same dielectric, the effect of prisms whose optical axis parallels to the glued layer is intense than those whose optical axis parallels to the plane determines by the normal of incident face and that of the cut face

    研究認為，激光偏光棱鏡的光強透射比隨各參量的連續變化都呈現出一定的周期性；各參量對空氣隙型偏光棱鏡的影響要比對膠合型棱鏡的影響大的多；同種介質膠合的棱鏡，各參量對光軸平行於切割斜面的設計類型比光軸平行於切割面的法線和入射端面的法線所組成的平面的設計類型的影響要大。
  3. Abstract : the theoretical investigation of the coupling efficiency of a laser diode to a single mode fiber via a hemispherical lens on the tip of the tapered fiber in the presence of possible transverse offset and angular mismatch is reported. without the misalignment, coupling efficiency increases with the decreasing of taper length. with the misalignment, this relation is that the coupling efficiency decreases with each kind of offset

    文摘:介紹了一種用於半導體激光器-單模光纖耦合的圓錐端半球透鏡的耦合效率的理論計算.失配不存在時，耦合效率隨著錐長的增加而減小.失配存在時耦合效率隨軸向和角向失配的增大而減小
  4. Centring of a lens

    透鏡的合軸
分享友人
分享到 Line

分享到臉書