逐次逼近 的英文怎麼說

中文拼音 [zhújìn]
逐次逼近 英文
relaxation
  • : 動詞1. (追趕) pursue; chase; run after 2. (驅逐) drive out; expel; banish 3. (挨著次序) one by one
  • : Ⅰ名詞1 (次序; 等第) order; sequence 2 [書面語] (出外遠行時停留的處所) stopping place on a jou...
  • : Ⅰ動詞1 (逼迫; 給人以威脅) compel; force; drive; threaten 2 (強迫索取) extort; exert pressure ...
  • : Ⅰ形容詞1 (空間或時間距離短) near; close 2 (接近) approaching; approximately; close to 3 (親...
  • 逐次 : each time; gradually; successive逐次分析 sequential analysis; 逐次簡化 successive reduction; 逐次...
  • 逼近 : 1 (靠近 接近) press on towards; gain on [upon]; approach; crowd on; close in on; draw near 2 [...
  1. The successive approximation converter is of medium speed, and average resolution.

    逐次逼近式轉換器具有中等的速度和解析度。
  2. By means of constructional iterative equation, this paper presents a way to give out the existence and singularity of a type of equational root with gradual approach method

    摘要本文通過構造迭代函數,利用逐次逼近的方法給出了一類方程根的存在性與唯一性的判斷的一種解決方案。
  3. A global convergent inexact successive approximation method for mix complementarity problems

    混合互補問題非精確逐次逼近法的全局收斂性
  4. A globally convergent inexact successive approximation method for nonlinear complementarity problems

    非線性互補問題非精確逐次逼近法的全局收斂性
  5. A constant input is especially required in a successive approximation converter because the input is compared with a reference several times over the conversion period

    逐次逼近轉換器中一個固定的輸入特別重要,因為在一個轉換周期中輸入要和參考值比較好幾
  6. Dp with successive approximation for solving hydropower unit commitment problem

    逐次逼近動態規劃法求解水電機組組合問題
  7. There are two ways to perform successive approximation: using hardware and using software mixed with hardware.

    實現逐次逼近的辦法有兩種:使用硬體以及軟、硬體混合使用。
  8. This is analogous to the successive approximation given by the terms of a taylor expansion.

    這類似通過泰勒法展開各項所給出的逐次逼近法。
  9. After the description of structure design and system composition of the whole a / d converter in chapter 3, design of d / a converter, which is the important part of 10 - bit successive approximation register a / d converter, has been provided in chapter 4

    在第三章介紹了整個a d轉換器的結構設計和系統組成后,文章的主體部分第四章給出了本文所研究的10位逐次逼近式a d轉換器的重要組成部分? ? d a轉換器的設計。
  10. Based on discussion, the significance of the paper is summarized and the main contents of the paper are listed. 2. some schemes are compared in the design of mcu - based protection equipment ' s control section

    數據採集方面,比較了vfc與逐次逼近型a / d ,片內a刃與片外a了d的優缺點,考慮到將來的功能擴展和通用性設計了本裝置的數據採集系統。
  11. For the nonlinear two - point boundary value problem with both time - delay terms and time - advanced terms driven by the optimal control theory, we build a sequence of nonhomogeneous linear two - point boundary value problems according to the successive approximation approach of constant differential equation

    再利用常微分方程的逐次逼近法,將由系統的最優控制問題得到的即含有時滯項又含有超前項的非線性兩點邊值問題化為非齊線性兩點邊值問題族。
  12. Successive approximation type

    逐次逼近
  13. Low power high precision successive approximation register analog to digital converter

    低功耗高精度逐次逼近型模數轉換器的設計
  14. A new successive approximation damped newton method for nonlinear complementarity problems

    求解非線性互補問題的逐次逼近阻尼牛頓法
  15. Solving a prone projectile problem in the northern hemisphere using successive approximation method

    逐次逼近法求解北半球斜上拋體問題
  16. The ip core contains a successive approximation adc and interface control circuit

    該ip核由逐次逼近型模數轉換器以及控制介面電路所構成。
  17. Abstract : this paper presents the application of the immovable point principle in proving the existence and uniqueness of the solution to some kinds of differential equation and integral equation, and the method produced by the principle progressive approach

    文摘:本文重點講述不動點原理在證明幾類微分方程和積分方程解的存在性和唯一性方面的重要應用,以及由此產生的方法? ?逐次逼近法。
  18. The first one of the two chapters deals with the objective of logistics centers location, the principle of location should be followed, and the processing procedure of datum. and the second introduces three material mathematical models and uses one of the models solves a practical issue. by the help of the above - mentioned contents, the author researches the effect of logistics centers in the logistics industry in depth

    在這兩部分內容當中,前者對於物流中心選址前目標的確定,選址時應當遵循的基本原則和對選址時收集的資料處理等內容進行了詳述;後者則分別對重心法、逐次逼近法中的鮑姆爾?沃爾大法和混合整數規劃法三種數學選址的方法進行了介紹。
  19. By using successive approximation approach, the feedforward and feedback optimal control law is presented, and a disturbance observer is designed to make the optimal controller physically realizable

    採用逐次逼近演算法給出了系統前饋反饋最優控制律的設計方法,利用擾動觀測器解決了最優控制律的物理可實現問題。
  20. Single stiffness is presented through q - s curve, and the load of the top of pile is computed by circulating many times, so it can avoid man - made rectification. at the end of the paper, the application of the method is introduced on a project

    通過單樁的荷載沉降曲線確定群樁中單樁的剛度,並可用逐次逼近的方法求解樁頂反力和基礎沉降,避免了對剛度的非理性調整。
分享友人