連接接頭 的英文怎麼說

中文拼音 [liánjiējiētóu]
連接接頭 英文
attach fitting
  • : Ⅰ動詞1 (連接) link; join; connect 2 (連累) involve (in trouble); implicate 3 [方言] (縫) ...
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • 連接 : connect; fit together; link; marry; mate; joint; association trail; linkage; concatenate; concate...
  • 接頭 : 1 (連接起來) connect; join; joint 2 (找人聯系) contact; get in touch with; meet 3 (了解情況...
  1. Rolled parallel thread splicing of rebars

    滾軋直螺紋鋼筋連接接頭
  2. In this article, after the analysis of the type of the joint between the tube and tubesheet and relevant factors, the key stage in the fabrication and appropriate method for controlling the quality of the joint were presented

    通過分析換熱器管板與管子連接接頭型式及相關要素,提出了製造過程中的控制環節、控制方法。
  3. Test methods for compression and mechanical connectorsfor conductors of power cables - method of heat cycle testing

    電纜導體壓縮和機械連接接頭試驗方法熱循環試驗方法
  4. Be installed in reflux pipe line, utilizing pressure difference to form the flowing loop ; sampling connector be 1 / 2 ” pipe ; vent pipe connector be 1 / 4 ” pipe ; installed with support

    1安裝在迴流管路-利用壓力差形成流動迴路,采樣連接接頭為1 / 2管,排氣管道連接接頭為1 / 4 」管,支架安裝。
  5. Cone tube connector of negative thread connection

    3 .錐管陰螺紋連接接頭
  6. Synchronous connections for transmitting information signals in aircraft

    飛機上信息信號傳輸用同步連接接頭
  7. Valve needle - cylinder connector

    閥針-汽缸連接接頭
  8. Water - proofing of buildings - part 8 : water - proofing over joints for movements

    建築物的防水性.第8部分:活動連接接頭的防水性
  9. Energy reserve brake systems. couplings with thread - connections and flexible gaskets

    能量儲備制動系統.螺旋連接接頭和彈性墊圈
  10. Non - soldering compression fittings with cutting ring - complete fittings and survey

    帶環套的非焊壓力連接接頭.完全壓和概述
  11. Test methods for compression and mechanical connectorsfor conductors of power cables - general

    電纜導體壓縮和機械連接接頭試驗方法總則
  12. Timber structures - test methods - joints made with punched metal plate fasteners ; german version en 1075 : 1999

    木質構件.試驗方法.金屬板沖壓緊固件連接接頭
  13. Agricultural tractors and machinery. power take - off shafts and position of power - input connection

    農用拖拉機和農業機械.動力輸出軸和動力輸入連接接頭的位置
  14. Mechanically fastened joints of composite materials are mainly components in aircraft structures, which need to be subjected to static loadings and fatigue loadings during working. the prediction of damage failure and fatigue life is one of questions that designers always pay attention to

    復合材料連接接頭是復合材料航空結構中的主要部件,在工作過程中,要求能承受一定的靜載荷及疲勞載荷,其損傷失效及疲勞壽命是設計人員關心的問題之一。
  15. Residual stresses analysis of joints of partial transient liquid phase bonding in ceramic - metal

    金屬二次部分瞬間液相連接接頭殘余應力分析
  16. Quick joint is a pressure pipe line quick connect joint. it wide apply to power, metallurgy, chemical industries, petroleum chemical, papermaking printing and dyeing, brewing, tobacco and aerospace base

    廣泛應用於電力冶金化工石化造紙印染釀造煙草航天等基地的壓力管道快速連接接頭
  17. The fracture energy of cu / - aiodiffusion - welded joints was greatly increased by the introduction of the thin film nb interlayer whereas diffusion welding can be performed at a relatively low temperature ( 900 ). the increase in fracture energy of the joints with nb film interlayer was attributed to the strong abhesion of nb to - aio combined with larger plastic deformation in the metal side during fracture tem observations showed large amounts of dislocations existing at the interfacial regions

    本文主要內容就是概括地介紹了國內外關于擴散連接接頭行為數值模擬的發展現狀;主要包括界面孔洞消失過程、元素擴散與反應層的形成、變形與應力行為的數值模擬,以使人們能夠定性或半定量的分析擴散因素對性能的影響。
  18. Test method for compression and mechanical connectors for conductors of power cables - method of short - circuit testing

    電纜導體壓縮和機械連接接頭試驗方法短路試驗方法
  19. Conveyor belts with textile plies for coalmining - permanent joints for belts with one or two plies ; dimensions, requirements, marking

    煤礦用織物疊層輸送帶.單層或雙層帶的永久性連接接頭
  20. Test methods for compression and mechanical connectorsfor conductors of power cables - method of tensile strength testing

    電纜導體壓縮和機械連接接頭試驗方法抗拉強度試驗方法
分享友人