進入同步 的英文怎麼說

中文拼音 [jìnrùtóngbù]
進入同步 英文
beating-in
  • 進 : 進構詞成分。
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 步 : Ⅰ名詞1 （步度; 腳步） pace; step 2 （階段） stage; step 3 （地步; 境地） condition; situation; st...
  • 進入 : get into; enter; entry; entering; entrance; incoming; dipping; ingress; intro-
  1. The system comprises three modules : the first is the ccd driver module, which controlled with cpld. programming the cpld to produce ccd driving pulses and synchronized communication signals. after preprocessing, the output video signals are transmitted into high resolution adc module, in which they are converted into digital signals, and then processed in arm processing module

    整個系統分為三個模塊: ccd驅動模塊的核心是一片復雜可編程邏輯器件（ cpld ） ，對其編程產生ccd的驅動脈沖及同步控制信號;視頻輸出信號經預處理后，由高精度ad轉換模塊進行采樣，將ccd輸出的模擬信號轉換成數字量;最後，將數據送入arm處理系統中進行后續處理。
  2. This paper also studies an hvdc system based on leee fbm, a svc system based on ieee fbm and a statcom system based on ieee fbm. it proves the function of supplementare subsynchronous damping controller ( ssdc ) in the above devices to mitigate ssr. it also analyzes the influence of input signal of ssdc on ssr mitigation, tdeng hvdc as an example

    在psasp小干擾線性化平臺psaspaisst上，對基於ieeefbm的hvdc系統、基於ieeefbm的svc系統和基於ieeefbm的statcom系統分別進行了ssr小干擾穩定分析，驗證了在這些裝置中安裝次同步振蕩阻尼器（ ssdc ）對r的抑制作用，並以hvdc為例，研究了ssdc輸入信號對其抑制ssr的影響。
  3. - ' geostationary orbit re - established. ' - looks like we ' re good to go

    - 「已重新進入地球同步軌道」 -看起來一切都很順利
  4. ' geostationary orbit re - established. ' - looks like we ' re good to go

    「已重新進入地球同步軌道」 -看起來一切都很順利
  5. It is argued that malaysia has taken advantages of low labor cost and stable political and economic environment to merge into international multi production and technology network by the means of inflowing mncs and export - led strategy in the past rapid industrialization era, this strategy has successfully created the opportunity of technological learning ; however, restricted by the institutional failure in its innovation system, it ' s evaluated that malaysia ' s overall development of technological capability lags behind its industrial growth

    論文研究表明，在過去十幾年快速的工業化過程中，馬來西亞創新體系藉助跨國公司和出口導向戰略，成功地利用馬來西亞低成本競爭優勢和穩定的政治經濟環境進入多元化的國際生產和技術網路，為其技術深化贏得了機遇，但受限於創新體系內各種制度性失效問題，馬來西亞總體技術能力發展與其工業化發展速度並不同步。
  6. In the thesis, a good performance is gained with implement four 256 state machines by making good use of residuary block ram in fpga chip. in present dissertation, ts sync flag is got rapid - extract by software and hardware cooperation and whether packet length is 188 or 204 bytes also is distinguished

    在硬體實現的過程中，對傳統da演算法進行了深入研究，充分利用fpga片內剩餘ram塊，實現4個256狀態的狀態機，採用軟硬體協作的方法快速提取同步位元組，自動區分包類型是188位元組長還是204位元組長。
  7. Comparing and analyzing the synchronous control strategy, which brings up the new method to control the double un - symmetry jars proceed synchronously with the combination of proportional valve and servo valve, which forms closed loop control ; basing on the above methods, models are made to get mathematics models of position control system and to analyze system model theoretically by using pid controller, we can realize regulating parameters, minimizing synchronous errors and enhancing the dynamic performances ; the simulink tool box in matlab software is used to imitate the system according to the model, which not only makes the result visual and easy to adjust the parameters in interactive way but also lets us understand the effects of different parameters and optimizes the dynamic properties. the theory of plc control in dshp is discussed after advanced understanding of the system movements. hardware design and general regulation are given on the base of siemens company products s7 - 200 plc

    本文根據大量的國內外文獻，對研配液壓機的工作原理及設計結構進行了簡介；對位置同步的控制方法進行了比較分析，提出比例閥和伺服閥復合控制的閉環結構來對非對稱雙缸進行同步控制電液比例同步控制方案；在此基礎上著重對比例閥控非對稱缸建模，最後得到位置控制系統的總體數學模型，從理論上對同步系統動態特性進行了分析，並用pid控制器進行參數整定，減小雙缸同步誤差、提高系統的動態響應性能；其中控制性能的分析藉助于matlab軟體中的simulink工具箱，由已建立的數學模型形成模擬模型，得到可視化的模擬結果，從而利於交互方式下調整參數，了解不同的參數對系統的影響，優化同步系統的動態性能；在深入了解系統的動作特性后，對plc控制研配液壓機的原理進行了探討，針對siemens公司s7 ? 200型plc給出了硬體設計的總體規劃，編制出研配液壓機動作控製程序，在編程中著重研究位移傳感器與plc的通訊、雙缸同步運行的pid控制在plc上的實現及bcd碼撥盤輸入程序的植入問題。
  8. Namespace contains types that allow synchronous and asynchronous reading and writing on data streams and files

    命名空間包含允許在數據流和文件上進行同步和異步讀取及寫入的類型。
  9. If you always synchronize and build before checking in, you can avoid integration build breaks that occur when you and another user check in non - conflicting but mutually incompatible changes which in combination prevent your application from compiling. to synchronize your workspace to the latest server version and build

    如果始終在簽入前進行同步和生成，就可以避免集成生成中斷（當您和另一個用戶簽入非沖突但是互不兼容的更改，並且這些更改結合起來阻止應用程序編譯時，就會產生集成生成中斷） 。
  10. At last, through analysis on calculating results and comparison among operational schemes, it is concluded that if pull - in steady operation of pump unit can be successfully realized, then it provides the reasonable suggestions for design and operation of pump station

    最後，通過對計算結果的分析及運行方案對比，判斷機組能否順利牽入同步和揚水，最終進入穩定工況運行，從而為泵站的設汁及運行提出科學合理的建議。
  11. The two key parameters, back electromotive force ( emf ) and reactance of d q axial armature reaction are investigated, too. in the process of asynchronous starting, mathematics model of repmsm is established with 1, 2, 0 complex number coordinate system. combined with the model, electromagnetic torque is studied

    論文還研究稀土永磁同步電動機的異步起動過程，建立了稀土永磁同步電動機起動時的數學模型，並對電磁轉矩的性質進行了研究，論文還提出了起動時電磁轉矩的計算方法，論文對稀土永磁同步電動機的牽入同步過程進行了原理性分析，論文也對電機參數對于電機起動性能影響進行了研究。
  12. The system is able to complete the data sample of 32 signals input, and has the ability to sample simultaneously of per 4 signal inputs. the conversion is 8 bits, and the sample rate of per channel is not less than 400hz. in addition, this data conversion system also have the ability of data storage without power supply, and the data size in flash memory is amount to sample 5s " of 32 signal inputs

    整個採集系統完成對32路輸入信號的采樣，而且可對每4信號路進行同步采樣， ad轉換精度為8位，每路信號采樣率不低於400hz ，另外系統還具備斷電數據保存功能，採用flash存儲器保存5秒的采樣數據，同時也具備與計算饑的epp并行通信介面。
  13. While the role - playing genre usually does not require fast input from the players, like in first person shooters ( where the first player to shoot, will be the one who survives ) or in sport games ( where synchronization is very important for collective actions ), movements had to be consistent & smooth

    與需要對移動完全進行同步和平滑顯示的第一人稱射擊游戲和體育游戲不大一樣，角色扮演類游戲通常並不需要非常快速的輸入處理。
  14. In transmission system, the original signal is modulated to ofdm signal after be coded in dpsk. and in receiving system, the modulated ofdm signal is synchronized and demodulated

    在發射端，將以一定速率輸入的二進制信息在進行dpsk編碼后調制到基帶ofdm信號上，在接收端，對已調制的ofdm信號進行同步和解調。
  15. The equipments and methods were on the level of manual operation, hi this paper, author paid a systemic research into three kinds of measure means : direct current attenuation method, voltage integral method, and direct load method ; theoretically analyzed the measure methods of synchronous armature reaction reactance, and even developed a test system to automatically measure the synchronous armature reaction reactance

    作者對直流衰減法、電壓積分法和直接負載法這三種測試方法的測試原理進行了較為深入、系統的研究，從理論上分析了同步電樞反應電抗參數的測試方法，並在此基礎上開發出能夠自動進行同步電樞反應電抗參數測試的系統。
  16. So we should reasonably use the income effect and substitution effect of the tax - receipt, optimize economic activities of enterprises such as investment, technological advance, distribution of resources, the production and running activities and so on, finally realize the reform intention that the economic efficiency of enterprises and the financial revenue are concurrent, suitable and steadily increase

    因此，我們要合理地利用稅收的收入效應與替代效應，優化企業的經濟活動，如投資、技術進步、資源配置和生產經營活動等，並最終達成企業的經濟效益與政府的財政收入同步、協調、穩健增長的改革意圖。
  17. Replication has a new managed code programming model : replication management objects ; merge replication allows you to introduce custom business logic into the synchronization process

    復制具有新的託管代碼編程模型：復制管理對象（ rmo ） ，合併復制允許將自定義業務邏輯引入同步進程中。
  18. And then the dissertation of ac step motion control is coming

    為了獲得精確的位置控制功能，由此引入同步機的交流步進控制。
  19. Method returns, the thread that made the call must wait to reenter the synchronization domain

    方法返回時，執行調用的線程必須等待重新進入同步域。
  20. Wait method returns, the thread that made the call must wait to reenter the synchronization domain

    方法返回時，執行調用的線程必須等待重新進入同步域。
分享友人
分享到 Line

分享到臉書