進氣管 的英文怎麼說

中文拼音 [jìnguǎn]
進氣管 英文
admi ion pipe
  • : 進構詞成分。
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  • 氣管 : air tube; windpipe; trachea; weasand; tracheal sac氣管病 tracheopathy; tracheopathia; 氣管切開術 ...
  1. Pa 6 for blow moulding

    吹塑級進氣管和排
  2. The accuracy of the mfc was 3. 8 % fs, and the rotor flow meter ' s was 2 % fs. 2. the measurement of pressure was carried out by using semiconductor silicon piezometer

    ( 2 )壓強的測量採用半導體硅壓阻式壓強傳感器,通過測量mpt進氣管路的靜壓,結合理論分析計算得到mpt諧振腔的總壓。
  3. Specification for manifold pressure gauges for aircraft

    飛行器用進氣管壓力表規范
  4. Food breathed into the windpipe can cause choking

    進氣管的食物會造成窒息。
  5. Air line strainer

    進氣管道隔濾器
  6. The gas field in pemfc means the gas distribution in gas source, gas inlet tube ( scale of m ), gas - blower, gas manifold ( scale of cm ), channel ( scale of mm ), diffusion layer ( scale of um ), hydrophobic layer and catalyst layer ( scale of nm ). the aim of changing the scales is to make oxygen reach reaction area as evenly as possible

    Pemfc的場指在源、進氣管(分米級) 、風機、箱(厘米級) 、流道(毫米級) 、擴散層(微米級) 、疏水層(亞微米級) 、催化層(納米級)中的體分佈,每一級尺度的變化是為了體的一步均勻化。
  7. In order to improve the prediction accuracy, the sensitivities of pipe friction coefficients, pressure loss coefficients in bents, wall temperatures and heat transfer coefficients in pipes and cylinders on the volume efficiency are investigated

    為提高充效率的計算精度,由模擬計算和相關試驗,分析了道的摩擦系數、彎的壓力損失系數、進氣管壁和缸壁溫度及其傳熱系數對充效率的影響程度。
  8. For the sake of realizing compressive ignition of single fueled natural gas and aiming at the characteristics of high spontaneous combustion temperature of natural gas, the separated combustion chamber provided with low heat radiation structure was designed, meanwhile the heating device for the intake pipe air and the ceramic electro - thermal plug heating device inside the separation chamber were set up

    摘要為實現單一燃料天然的壓燃著火,針對天然自燃溫度高的特點,設計了具有低散熱結構的分隔式燃燒室,同時設置了進氣管加熱裝置和分隔室內陶瓷電熱塞加熱裝置。
  9. Diving accesories. snorkels. safety requirements and test methods

    潛水附件.潛水服進氣管.安全性技術要求和檢驗方法
  10. Diving accessories - snorkel - safety requirements and test methods ; german version en 1972 : 1997

    潛水附件.潛水服進氣管.安全性要求和試驗方法
  11. The results show that the heat transfer in intake manifold and cylinder has obvious effects on the volume efficiency, while the pipe friction coefficients and bent pressure loss coefficients have less effect

    結果表明,進氣管缸的傳熱對充效率的影響較顯著,而道摩擦系數和彎壓力損失系數對充效率的影響較小。
  12. When the natural frequency of the gas column in the inlet valve is consistent with the main frequency of the periodic air inlet noise, the resonance noise of the gas column will also become prominent in the air inlet noise

    進氣管柱的固有頻率與周期性噪聲的主要頻率相一致時,空柱的共振噪聲在噪聲中也會較為突出。
  13. Based on the analysis of regime of spray and heat transfer, the spray nozzles were redesigned to distribute liquid in the center area of th e tower and the gas inlet was enlarged to raise gas velocity

    根據對順流式空塔的噴淋及傳熱模式的分析,重新設計了噴嘴,使噴淋液在設備中心附近集中;縮小了進氣管直徑,以提高體的流速。
  14. The paper introduces acquired air rate of flow in admission pipes and fluidity in cylinder on single cylinder or multi cylinder engines with hot - wire anemometer, and demarcation and adjustment method of measure values are provided

    摘要本文介紹了利用熱線風速儀測量單缸與多缸內燃機進氣管內流速、缸內體流動以及標定與修正的方法。
  15. This paper investigates the structural parameters of air inlet pipe, air compensating pipe and air compensating valve which influence the air compensation of air compensating valve for motorcycle catalytic converter, the position of air compensating hole, and the relationship of air compensating pressure with engine speed

    本文就影響摩托車催化轉化器補閥補量的進氣管、補、補閥的結構參數,以及補孔的位置、補壓力隨轉速的變化關系等行了探討。
  16. The passage dimension of separation chamber, the heating temperature of intake pipe air and the relevant influence of the ceramic heat insulation coating of combustion chamber upon the compressive ignition process of natural gas were studied by experiment

    實驗研究了分隔室通道尺寸、進氣管加熱溫度、燃燒室陶瓷隔熱塗層對天然壓燃著火過程的相關影響。
  17. When the inlet valve opens, a pressure pulse is generated in the air inlet pipe, which is damped as the piston continues to move. when the inlet valve closes, another pressure pulse of certain duration is generated, thus giving rise to a periodic inlet noise

    門開啟時,在進氣管中產生一個壓力脈沖,而隨著活塞的繼續運動,它受到阻尼;當門關閉時,同樣產生一個有一定持續時間的壓力脈沖。
  18. Abstract : through the study of inlet manifold of truck direct injection diesel engines, we studied the fundamental law of the utilization of gasdynamic effect in the inlet manifold to increase the volumetric efficiency in multi - cylinder engines

    文摘:本文通過對車用直噴式柴油機進氣管的試驗研究,探討了在多缸柴油機中利用進氣管內的動力效應以提高充效率的基本規律。
  19. In the experiment the methanol was injected into the induction manifold of the diesel engine and evaporated to form methanol / air mixture with the induction air. the methanol quantity was controlled by an electronic control system

    試驗中的甲醇是通過一套電控噴嘴向進氣管噴射實現,為此作者製作了一套簡單的電子控制系統,對燃燒過程中的預混燃燒甲醇量行控制。
  20. Abstract : based on analyzing of technology and construction feature of inlet pipe casting for lost process cad / cam system of die program is setup through improvement and second development of the imported system

    文摘:以進氣管為例,通過對引系統的改和二次開發,在對鑄件工藝和結構特徵分析的基礎上,建立了消失模模具cad / cam系統。
分享友人