進水流道 的英文怎麼說
中文拼音 [jìnshuǐliúdào]
進水流道
英文
inflow runner- 進 : 進構詞成分。
- 水 : 名詞1 (由兩個氫原子和一個氧原子結合而成的液體) water 2 (河流) river 3 (指江、河、湖、海、洋...
- 流 : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
- 道 : Ⅰ名詞(道路) road; way; route; path 2 (水流通過的途徑) channel; course 3 (方向; 方法; 道理) ...
- 水流 : 1. (江河) rivers; streams; waters2. (流動的水) current; water flow; fluent; flow; [水文] stream current
-
Round we went with the tide, until we got well under the lee of the point, when suddenly the speed slackened, we ceased to make way, and finally appeared to be in dead water.
我們隨波逐流,四處飄蕩。到了海岬下面的避風處,速度突然減低,船慢慢停了下來。最後就好象走進了一道死水灣似的。Sand has accumulated in a deltaic pattern on both the marine and lagoon sides of the inlets in conjunction with this diminishing current flow.
隨著水流速度的減慢,砂質物遂以三角洲的形式堆積在進水道面向海洋和瀉湖的兩頭。The flow dynamic axis in the distorted models is smoother than that in the undistorted model, while the flow horizontal gradient in the distortion model is smaller than that in the undistorted model
在河工模型的條件下,選取不同變態模型,對環流進行了計算,研究了變率對彎道水流的相似的影響,並給出了初步分析。By modeling of " y " - shaped junction of the compound river channel with an intersection angle 90, the flow velocity and water level at the junction were obtained by use of the acoustic doppler velocimeter ( adv ) and point gauges
摘要通過製作交匯角為90的復式斷面河道" y "型交匯河口模型,利用三維聲學多普勒流速儀( adv )和測針獲取流速及水位數據,對支流河口處的水流流態包括水面形態、水流流速和水流分區進行分析。To provide necessary data for design bypass pipe, an enlargement to bi liu river reservoir, the following problems have been studied by hydraulic model and theoretical analysis : the energy losses in water head of the bypass pipe system and of the flow - control valve and their scale effects, measurement and calculation of the discharge of the bypass pipe system during the bypass pipe system operation with and without the new water power station, the hydraulic characteristics of the water tunnel and draw - off pipe, the flow rate of the aqueduct bridge and the draw - off pipe and the water elevation of the flow in the aqueduct bridge during the old water power station operation with and without the new water power station
大連市碧流河水庫供水工程取水頭部由引水渡槽、節制閘、進水閘、泄水閘等建築物組成。由於本工程場地條件限制,增設旁通管后布置非常緊湊,管道急轉角度大且轉彎距離較小,對于管內水流流態是否滿足要求,需要經過模型試驗進行論證,以確保工程的可靠性。旁通管具有上水與泄水要求,對其過流能力也要經試驗確定,為碧流河水庫增建旁通管設計提供依據。Since 1976 it has been made great achievements which has conducted water more than 100 billion m3 and has been an important project of heilongjiang province. but recently the channel has been seriously freezing - melting eroded and sand of cliff edge has been deposited along the channel, which resulted to highten the channel bottom, increase width of the channel and reduce horse road. what all above have affected to apply safely channel so it is necessary to repair comprehensive
自1976年建成以來,已累計引水100多億立方米,取得了巨大的經濟效益,成為黑龍江省西部關繫到國計民生的重點工程,但近年來渠道破壞嚴重,凍融侵蝕強烈,邊壁剝蝕下來的泥沙經渠道內水流搬運沿程發生淤積,導致渠底抬高,渠寬增加,馬道縮小,已經嚴重影響到渠道的安全運用,必須進行綜合治理。In the past, more emphasis has been put on the flow pattern and the division ratio of water and sediment discharge. in order to study the division characteristics, a theoretic model is proposed in this thesis, which combines the plan configuration of channels with the minimum energy dissipation rate theory
本文將河流動力地貌學中的平面形態和最小能耗率理論相聯系,研究分汊河道的分流特性,並推導理論分流模式;另一方面,通過建立二維水流數學模型,與理論分析結果進行比較。Based on analysing all kinds of sediment silting basins and their suitable conditions, the traditional sedimentation basin has been improved in three aspects, i. e., setting an adjusting flow board in the fore of setting basin, adding a spillway trough along the flow direction, and redesigning the flush gallery by adding auxiliary flushing facilities
摘要在對各種類型沉沙池及適用條件進行分析的基礎上,通過在沉沙池的首部加調流板、在溢流堰上沿水流方向設溢流槽、對沖沙廊道進行改進並設置輔助沖沙設施這3個方面對傳統沉沙池進行了改進。3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant
對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等;改進了水冷壁布置使換熱效果更好,減少輻射換熱損失;改進對流段結構,更充分的利用爐膛出口煙氣余熱,提高熱效率;並且進行了煙氣阻力計算、熱效率計算和能量平衡測試,對改進后的稠油燃料和改進前進行了對比,燃燒狀況和熱效率有明顯改善。The analysis model and design methodology for the gas field are discussed referring to related documents. the structure parameters of gas manifold, channel, diffusion layer and hydrophobic layer which affect the oxygen distribution are also studied
本文闡述了氣場分析模型和設計思想,研究了進氣箱、交指型流道、擴散層和疏水層結構參數對氧濃度分佈的影響。The gas field in pemfc means the gas distribution in gas source, gas inlet tube ( scale of m ), gas - blower, gas manifold ( scale of cm ), channel ( scale of mm ), diffusion layer ( scale of um ), hydrophobic layer and catalyst layer ( scale of nm ). the aim of changing the scales is to make oxygen reach reaction area as evenly as possible
Pemfc的氣場指在氣源、進氣管(分米級) 、風機、進氣箱(厘米級) 、流道(毫米級) 、擴散層(微米級) 、疏水層(亞微米級) 、催化層(納米級)中的氣體分佈,每一級尺度的變化是為了氣體的進一步均勻化。To choice good excavating scheme, this article engages in hydraulic model tests and numerical simulation on the movable bed
為了選擇較好的清挖方案,本文對太平灣電廠下遊河道進行了動床水力模型試驗及動床水流數值模擬研究。In this paper, we study the most serious damming section of the east - one main canal, which is from the entrance of the hao wan flume ( chainage12 + 123. 6 ) to the exit of shang tian yuan tunnel ( chainage24 + 091. 1 ). the main content is analyzing the flow characteristic of the canal, setting up mathematical model of the discharge condition of the east - one main canal, according to the survey section and actual roughness factors, building, bend and so on, we divided the canal into more than loocaculation segments. each segment is calculated by microsoft excel electrical table through computer as permanent transition flow of non - prismatic channel
本論文研究的渠段為陸渾灌區東一乾渠壅水最為嚴重的渠段,從郝灣渡槽進口(樁號12 + 123 . 6 )至上天院隧洞出口(樁號24 + 091 . 1 ) ,其主要內容是,分析渠道水流特徵,建立東一乾渠輸水狀況的數學模型,根據測量斷面及實際糙率、建築物、彎道等因素的不同,將渠道劃分成120多個計算段,每段按非稜柱體恆定漸變流,運用microsoftexcel電子表格進行編程計算。A number of statistical and analytical works have been done by the institutions such as thethird shipping affair engineering and relonnissanle design institue of ministry of communications, hohai university, yangize valley water hudroprower planning and institule, nanjing hydraulic research institute and so on [ 25 - 30 ]. in 1993, the correlation analyses based on the data from the short - term situ - observation at near sea - route of the yangtse river estuary and the ship - stations were carried out to deduce the wave factors used in the engineering design
交通部第三航務工程堪察設計院、河海大學、長江流域水利規劃設計院、南京水利科學研究院等單位曾作過不少統計和分析工作[ 25 - 30 ] ,在九十年代前期,人們曾根據長江口深水航道或附近短期實測資料與引水船站進行過相關分析,進而推算出設計波要素。The test results signify that the more accuracy result could be obtained to apply the method and the hydraulic losses of the conduits of bulb tubular pump is relative closely to the bulb location
試驗結果表明:採用新方法進行貫流泵進出水流道水力損失的測試,可以較為方便地得到準確的結果;貫流泵裝置進、出水流道的水力損失與燈泡布置的位置密切有關。The method was applied to measure the hydraulic losses of inlet and outlet conduit of bulb tubular pump system of the pumping station respectively
採用本文的方法對某泵站前置燈泡和後置燈泡貫流泵的進、出水流道分別進行了模型試驗,測試了流道水力損失。To serve the optimum hydraulic design for a large pumping station, a new method to separate inlet and outlet conduit from tubular pump system was put forward for measuring their hydraulic baa, by the way to design a special measuring system
摘要為了配合某大型泵站貫流泵裝置的優化水力設計研究工作,本文提出了設計專用模型試驗裝置,將貫流泵裝置進水流道和出水流道從水泵裝置模型中分離出來分別進行模型試驗及水力損失測試的方法。Application of elbow inlet passages in the technical innovation of pressured lateral intake pumping staton
肘形進水流道在有壓側向進水泵站技術改造中的應用Numerical simulation of turbulent flow inside inlet duct and experiment on characteristic performances in shaft tubular model pump set
泵站豎井進水流道數值模擬與裝置特性試驗Computation and analysis of 3 - d curved - flow of pumping station forebay and improving of the flow pattern
泵站進水彎道三維流動分析及流態改善研究分享友人